18 results with keyword: 'mechanical properties alsi mg produced selective laser melting'
Effect of heat treatment on AlSi10Mg alloy fabricated by selective laser melting: microstructure evolution, mechanical properties and fracture mechanism.. Selective laser melting
N/A
variable. The effect of externally applied pressure on electrical impedance values was investigated using the silicon prototype to measure beef rib fat and muscle
N/A
Heat treatment of Ti6Al4V produced by selective laser melting: Microstructure and mechanical properties. and
N/A
At a high stress level (i.e. 395MPa for both testing directions), they will become the critical defects which initiate inhomogeneous deformation. Because of their location close to
N/A
Selective laser melting of high strength Al-Cu-Mg alloys: Processing, microstructure and mechanical properties. Analysis of processing parameters and characteristics of selective
N/A
The Effect of Selective Laser Melting Process Parameters on the Microstructure and Mechanical Properties of Al6061 and AlSi10Mg Alloys. Selective Laser Melting of aluminium alloy
N/A
Stucker, “Influence of defects on mechanical properties of Ti-6Al-4V components produced by selective laser melting and electron beam melting,” Materials & Design, vol. Moore,
N/A
Comparative study of microstructures and mechanical properties of in situ Ti–TiB composites produced by selective laser melting, powder metallurgy, and casting
N/A
Abstract: The microstructure and mechanical properties of Al-20Si produced by selective laser melting (SLM) are investigated for different heat treatment conditions.. As a result of
N/A
Large interior inclusions and ductile riding are seen in Figure 63, while a small un-melted powder particle and metallurgical porosity near the edge of the sample indicate a
N/A
Effect of heat treatment on AlSi10Mg alloy fabricated by selective laser melting: Microstructure evolution, mechanical properties and fracture mechanism. Microstructure and
N/A
Effect of heat treatment on AlSi10Mg alloy fabricated by selective laser melting: Microstructure evolution, mechanical properties and fracture mechanism. Microstructure and
N/A
The Effect of Build Orientation on the Surface Quality, Microstructure and Mechanical Properties of Selective Laser Melting 316L Stainless Steel.. Hamza Alsalla* † Liang Hao
N/A
Selective laser sintering and selective laser melting are powder based additive manufacturing (AM) process that can rapidly manufacture parts with comparable
N/A
Frascati, Application study of AlSi10Mg alloy by selective laser melting: physical and mechanical properties, microstructure, heat treatments and manufacturing of aluminium
N/A
Yang, Densi fi cation behavior, micro- structural evolution, and mechanical properties of TiC/316L stainless steel nano- composites fabricated by selective laser melting,
N/A
In spite of the higher tensile strength, the fatigue strength of the SLM materials was much lower than that of the wrought material since molding defects may induce
N/A
Single track and single layer AlSi10Mg has been produced by selective laser melting (SLM) of alloy powder on a AlSi12 cast substrate.. The SLM technique produced a
N/A