[PDF] Top 20 Plasma-induced physicochemical effects on a poly(amide) thin-film composite membrane

... 50. Kim, S.H., S.-Y. Kwak, and T. Suzuki, Positron Annihilation Spectroscopic Evidence to Demonstrate the Flux-Enhancement Mechanism in Morphology-Controlled Thin- Film-Composite (TFC) ... See full document

... Asymmetric PSf substrate was prepared via phase inversion tech- nique using a polymer dope with a PSf concentration of 15 wt.%. In order to increase the porosity, 1 wt.% PVP was added into the dope solu- tion. PVP was fi ... See full document

... driven membrane processes, such as forward osmosis (FO) or osmotic distillation ...membranes, thin film composite (TFC) for FO membranes require careful design to reduce salt concentration ... See full document

... the effects of top selective layer thickness formed by controlling the coating angle (15-60°) and polymer solution concentration (5-10 ...the effects of different operating pressure (2-10 bar) and ... See full document

... PbSe-ZnSe composite thin film was prepared by the HWD ...a film surface, resulting in achieving a state near thermal equi- librium ...PbSe-ZnSe composite thin film was ... See full document

... The mechanical properties of membrane were carried out on a LLOYD instrument tensile tester. The samples were cut into dumbbell shape with dimension according to ASTM D412 (die C). Aging of the dumbbell specimens ... See full document

... Plasma membrane localization of MARV VP40 is dependent upon the anionic charge of the cytoplasmic ...the plasma membrane inner leaflet in live COS-7 cells for mVP40 ...the plasma ... See full document

... active amide linkages. The membrane prepared from the interfacial polymerization between m- phenylenediamine-4-methyl (MMPD) and trimesoyl chloride (TMC) also showed better chlorine resistance compared to ... See full document

... Figure 4a shows the influence of DA concentration in the aqueous phase on FO performance of the DA/TMC TFC membranes. The concentration of DA was fixed at 0.1, 0.3 and 0.5 wt% in the aqueous phase, respectively. The FO ... See full document

... The plasma jet used in this study was a cylindrical dielectric barrier discharge (DBD) as is shown in figure ...to plasma deposition of the ionised monomer, can affect the quality of the plasma, thus ... See full document

... Thin film composite (TFC) membranes are the most applicable NF membranes, which have the superior performance compared to membranes with asymmetric structure ...TFC membrane is prepared by ... See full document

... favorable attachment to tissue and bioactivity in bone repair.[14] Solvent casting was first described by Mikos et al.[15] to prepare highly porous biodegradable polymer membranes used as scaffolds with tunable porosity ... See full document

... To visualize the process of drug release from the mag- netic micropump, water-soluble red dye in PBS solution was injected into the micropump through the aperture in the bottom of the micropump (Fig. 2II b) using a ... See full document

... Thin-film composite hollow fiber membranes were prepared by interfacial polymerization of Piperazine in aqueous phase with TMC in organic phase ...support membrane was submerged into the ... See full document

... performances of optical sensor were investigated which provide the excellent result. The response time of 2–3 s and the detection limit of thiocyanate solution, 1 ppm were found at room temperature. Thus, in future this ... See full document

... Polymerization chloride bis p-phenylene Using NH cm"1 12 terephthaloyl 23% Tg 3430-3000 at indicates the bis p-phenylene a analysis the as by differential scanning calorimetry sulfonamid[r] ... See full document

... the film emission, and broad, redshifted PL spectra were obtained as a result to excimer formation in comparison with the solution spectra ...the Poly(PC5), a yellow emission was detected (576nm) which is ... See full document

... the effects of radiation on the properties and performance of ferroelectric based ...fundamental effects of radiation are involved with introducing displacement events which are composed of Frenkel pairs, ... See full document

... membrane and were attached by using the binder clips. At the same time, both 2% (w/v) MPD solution and 2% (w/v) MPD/AgNPs solution were prepared. The 2% (w/v) MPD/AgNPs solution was prepared by mixing different ... See full document

... blend film shows a peak at 445nm which is due to polaron - π* transition and confirms the polymer PDMA in conducting form ...CdS thin film may be due to small size CdS ... See full document