GENERAL WARNINGS
- CAUTION:
The operator must use the machine and all its controls only when properly seated in the driver’s seat.
- CAUTION:
The telehandler described in this manual cannot be used in clo-sed environments or where there might be explosive gases. To work in this type of environment, contact the manufacturer so that the necessary modifications can be made to the machine.
- CAUTION:
Working on gradients can be dangerous. Ground conditions can vary according to weather conditions (e.g. rain, snow, ice). Therefore pay the utmost attention to the ground condi-tions you are working on and proceed slowly.
- CAUTION:
While transporting a load on a gradient, proceed with the load uphill of the machine to increase stability. Before ascending ramps or trailers, remove any mud, ice or oil, which could cause accidents.
- CAUTION:
Proceed with the utmost caution on uneven, wet or muddy surfaces.
- CAUTION:
Lack of efficient communication can cause serious accidents.
If you are working with others, ensure any hand signals you intend to use are understood by everybody. Since work sites are often very noisy, do not rely on verbal communication.
- CAUTION:
It is forbidden to use moveable hydraulic machine parts to lift people, except for the uses described in this manual.
- CAUTION:
Before activating moveable hydraulic machine parts, ensure the surrounding area is free.
- CAUTION:
The machine may only be used by skilled and trained per-sonnel who have read this manual. If the machine is driven on roads, the operator must have a valid driver’s licence pursuant to the regulations in effect in the country where the machine is being used (type “B” licence in Italy).
- CAUTION:
Do not use the machine if you are under the effect of alco-hol or drugs, or even if you have taken medication that may make you drowsy or alter your reflexes.
- CAUTION:
Before starting the machine or before carrying out any par-ticularly complex or dangerous manoeuvres, it is essential that you practice in an empty, unobstructed part of the site.
- CAUTION:
Clear, basic symbols are situated near each of the controls to make them more practical and comprehensible to the operator.
- CAUTION:
When traverse steering is selected, always proceed slowly.
- CAUTION:
If any part malfunctions and causes a risk, stop the machine immediately. Do not use the machine again until the malfun-ction has been repaired.
- CAUTION:
Excessively inflated or overheated tyres can explode: follow the instructions in this manual to ensure the tyres are infla-ted correctly. Do not weld or cut the rims. Any repair work must be carried out by a tyre specialist.
- CAUTION:
Do not leave the machine boom raised and extended for long periods, this could misalign the boom extensions. Re-tract the extensions at least once a day.
- CAUTION -
IT IS COMPULSORY TO READ AND LEARN CHAPTER
“B” (SAFETY STANDARDS) BEFORE READING CHAPTER “C” AND BEFORE USING THE MACHINE.
Machine right side
1. Rear right stabiliser 2. Rear right light
3. Epicyclic reduction gear:
4. Wheel
5. Oscillation lock cylinder 6. Turret rotation locking pin 7. Boom safety support rod 8. Engine bonnet
9. Diesel engine 10. Levelling cylinder 11. Right rear-view mirror 12. Front right light 13. Front right stabiliser
14. Boom head electrical connector 15. Boom head work spotlight 16. Front work spotlight on the cab
1
3. Attachment holder plate 4. Front left stabiliser 5. Rear left stabiliser 6. Epicyclic reduction gear:7. Machine levelling cylinder 8. Wheel
9. Front left light 10. Battery
11. Toolbox
12. Hydrostatic system oil filter 13. Hydraulic oil tank
14. Diesel fuel tank 15. Oscillation lock cylinder
16. Control unit and timing system bonnet 17. Control unit
18. Timing system 19. Rear left light
20. Front work spotlight on the cab Machine left side
10
Machine right side 3. Attachment holder plate 4. Front left stabiliser 5. Rear left stabiliser 6. Epicyclic reduction gear:
7. Machine levelling cylinder 8. Wheel
9. Front left light 10. Battery
11. Toolbox
12. Hydrostatic system oil filter 13. Hydraulic oil tank
14. Diesel fuel tank 15. Oscillation lock cylinder
16. Control unit and timing system bonnet 17. Control unit
18. Timing system 19. Rear left light
20. Front work spotlight on the cab
1. Rear right stabiliser 2. Rear right light
3. Epicyclic reduction gear:
4. Wheel
5. Oscillation lock cylinder 6. Turret rotation locking pin 7. Boom safety support rod 8. Engine bonnet
9. Diesel engine 10. Levelling cylinder 11. Right rear-view mirror 12. Front right light 13. Front right stabiliser
14. Boom head electrical connector 15. Boom head work spotlight 16. Front work spotlight on the cab
1
IDENTIFYING MACHINE PARTS – Eight movement stabilisers
(Pegasus 45.19, 45.21, 50.21, 40.25)10
15 20
5
1. Front right stabiliser 2. Front left stabiliser 3. Front right wheel 4. Front left wheel 5. Attachment holder plate 6. Boom safety support rod 7. Front right light
8. Front left light 9. Cab
10. Telescopic boom 11. Left rear-view mirror 12. Right rear-view mirror
1. Rear right stabiliser 2. Rear left stabiliser 3. Rear right wheel 4. Rear left wheel
5. Timing system and control unit 6. Rear window - Emergency exit 7. Rear right light
8. Rear left light 9. Left rear-view mirror 10. Right rear-view mirror 11. Revolving light power outlet
1. Front right stabiliser 2. Front left stabiliser 3. Front right wheel 4. Front left wheel 5. Attachment holder plate 6. Boom safety support rod 7. Front right light
8. Front left light 9. Cab
10. Telescopic boom 11. Right rear-view mirror 12. Left rear-view mirror
1. Rear right stabiliser 2. Rear left stabiliser 3. Rear right wheel 4. Rear left wheel
5. Timing system and control unit 6. Rear window - Emergency exit 7. Rear right light
8. Rear left light 9. Right rear-view mirror 10. Left rear-view mirror 11. Revolving light power outlet
1
Machine with four movement stabilisers
(Pegasus 70.11, 60.16, 30.16, 40.17, 38.16)Machine with eight movement stabilisers
(Pegasus 45.19, 45.21, 50.21, 40.25)Front view
External components
Rear window / Emergency exit 7.
Rear windshield wiper 8.
Revolving light air inlet 9.
Grip for climbing in/out of the cab.
8.
(Pegasus four and eight movement stabilisers)