D.3 Capabilities of PP (EUT) under test
D.3.3 Message parameters
The slot type shall be set correctly in all message parameters.
The equipment supplier shall provide message parameter details for configuring the LT.
Table D.7: Parameters for A-field static system information message
Parameters for A-field static system information message
Item Name of Parameter Reference PT LT Values
No. Status Status PT
Allowed LT Allowed 1 Normal-reverse 7.2.3.2.2 [5] M M 0,1 0 2 Slot number 7.2.3.2.3 [5] M M 0 - 11 0 - 11 3 Start position 7.2.3.2.4 [5] M M 0,2 0,2 4 QT escape bit 7.2.3.2.5 [5] M M 0,1 0,1 5 Number of transceivers 7.2.3.2.6 [5] O M 0 - 3 0
6 Extended RF carrier information available 7.2.3.2.7 [5] O M 0,1 0 7 RF carriers available 7.2.3.2.8 [5] O M 1 - 1 023 1 - 1 023 8 Carrier number 7.2.3.2.10 [5] O M 0 - 9 0 - 9 9 Primary receiver scan carrier number 7.2.3.2.12 [5] O M 0 - 9 0 - 9
Table D.8: Parameters for MAC FP capability message
Parameters for A-field MAC FP capability message
Item Name of parameter Reference PT LT Values
No. Status Status PT
Allowed LT Allowed 1 Extended FP information 7.2.3.4.2 [5] O M 0,1 0 2 Double slot 7.2.3.4.2 [5] O M 0,1 0,1 3 Half slot 7.2.3.4.2 [5] O M 0,1 0,1 4 Full slot 7.2.3.4.2 [5] O M 0,1 0 5 Frequency control 7.2.3.4.2 [5] O M 0,1 0 6 Page repetition 7.2.3.4.2 [5] O M 0,1 0 7 C/O setup on dummy bearer allowed 7.2.3.4.2 [5] O M 0,1 0 8 C/L uplink 7.2.3.4.2 [5] O M 0,1 0 9 C/L downlink 7.2.3.4.2 [5] O M 0,1 0 10 Basic A-field setup 7.2.3.4.2 [5] O M 0,1 0,1 11 Advanced A-field setup 7.2.3.4.2 [5] O M 0,1 0,1 12 B-field setup 7.2.3.4.2 [5] O M 0,1 0,1 13 CF messages 7.2.3.4.2 [5] O M 0,1 0,1 14 IN minimum delay 7.2.3.4.2 [5] O M 0,1 0 15 IN normal delay 7.2.3.4.2 [5] O M 0,1 0,1 16 IPM error detection 7.2.3.4.2 [5] O M 0,1 0,1 16a IPQ error detection 7.2.3.4.2 [5],
7.2.3.5.2 [5]
O M 0,1 0,1
17 IPM error correction 7.2.3.4.2 [5] O M 0,1 0,1 17a IPQ error correction 7.2.3.4.2 [5],
7.2.3.5.2 [5]
O M 0,1 0,1
18 Multibearer connections 7.2.3.4.2 [5] O M 0,1 0,1 19 Synchronization field – prolonged preamble 7.2.3.5.2.2 [5] O M 0,1 0,1 20 MAC suspend and resume 7.2.3.5.2 [5] O M 0,1 0,1 21 Long slot support (j = 640) 7.2.3.11.2 [5] O M 0,1 0,1 22 Long slot support (j = 672) 7.2.3.11.2 [5] O M 0,1 0,1 23 E+U-type mux and channel IPF basic
procedures supported
Parameters for A-field MAC FP capability message
Item Name of parameter Reference PT LT Values
No. Status Status PT
Allowed LT Allowed
24 channel IPF advanced procedures supported 7.2.3.11.2 [5] O M 0,1 0,1 25 channel SIPF supported 7.2.3.11.2 [5] O M 0,1 0,1 26 channel GF supported 7.2.3.11.2 [5] O M 0,1 0,1 27 "no-emission" mode: preferred carrier number
mode (CN)
7.2.3.11.2 [5] O M 0,1 0,1
Table D.9: Parameters for higher layer information FP capability message (EN 300 175-5 [7], clause F.1)
Parameters for A-field higher layer information FP capability message
Item Name of parameter bit reference PT LT Values
No. Status Status PT
Allowed
LT Allowed
1 ADPCM/G.726 (note) Voice service a32 F.1 [7] O M 0,1 0,1 2 Generic Access Profile (GAP)
supported
a33 F.1 [7] O M 0,1 0,1
3 Non-voice circuit switched service a34 F.1 [7] O M 0,1 0,1 4 Non-voice packet switched service a35 F.1 [7] O M 0,1 0,1 5 Standard authentication required a36 F.1 [7] O M 0,1 0,1 6 Standard ciphering supported a37 F.1 [7] I M 0,1 0 7 Location registration supported a38 F.1 [7] O M 0,1 0,1 8 SIM services available a39 F.1 [7] O M 0,1 0,1 9 Non-static Fixed Part (FP) a40 F.1 [7] O M 0,1 0,1 10 CISS services available a41 F.1 [7] O M 0,1 0,1 11 CLMS services available a42 F.1 [7] O M 0,1 0,1 12 COMS services available a43 F.1 [7] O M 0,1 0,1 13 Access rights requests supported a44 F.1 [7] O M 0,1 0,1 14 External handover supported a45 F.1 [7] O M 0,1 0,1 15 Connection handover supported a46 F.1 [7] O M 0,1 0,1
16 Reserved a47 F.1 [7] O M 0,1 0,1
NOTE: ITU-T Recommendation G.726 [i.7].
Table D.9a: Parameters for extended higher layer information FP capabilities message (EN 300 175-5 [7], clause F.2)
Parameters for A-field higher layer information FP capability message
Item Name of parameter bit reference PT LT Values
No. Status Status PT
Allowed
LT Allowed
1 ISDN Data Services a47 F.2 [7] O M 0,1 0,1 2 DPRS FREL a46 F.2 [7] O M 0,1 0,1 3 DPRS Stream a45 F.2 [7] O M 0,1 0,1 4 Data Service Profile D a44 F.2 [7] O M 0,1 0,1
5 LRMS a43 F.2 [7] O M 0,1 0,1
6 Asymmetric bearers supported a41 F.2 [7] O M 0,1 0,1 7 Emergency call supported a40 F.2 [7] O M 0,1 0,1 8 Location registration with TPUI
allowed
a39 F.2 [7] O M 0,1 0,1
9 Synchronization to GPS achieved a38 F.2 [7] O M 0,1 0,1 10 ISDN intermediate system a37 F.2 [7] O M 0,1 0,1 11 RAP Part 1 Profile a36 F.2 [7] O M 0,1 0,1
12 V.24 a33 F.2 [7] O M 0,1 0,1
13 PPP a32 F.2 [7] O M 0,1 0,1
14 IP a31 F.2 [7] O M 0,1 0,1
15 Token Ring a30 F.2 [7] O M 0,1 0,1
16 Ethernet a29 F.2 [7] O M 0,1 0,1
Parameters for A-field higher layer information FP capability message
Item Name of parameter bit reference PT LT Values
No. Status Status PT
Allowed
LT Allowed
18 Generic Media Encapsulation transport (DPRS) supported
a27 F.2 [7] O M 0,1 0,1
19 Basic ODAP supported a26 F.2 [7] O M 0,1 0,1 20 F-MMS Interworking profile
supported
a25 F.2 [7] O M 0,1 0,1
Table D.9b: Parameters for extended higher layer information, part 2, FP capabilities message (EN 300 175-5 [7], clause F.3)
Parameters for A-field higher layer information FP capability message
Item Name of parameter bit reference PT LT Values
No. Status Status PT
Allowed
LT Allowed
1 NG-DECT Wideband voice (see TS 102 527-1 [i.4])
a24 F.3 [7] O M 0,1 0,1
2 DPRS/NG-DECT Packet Data Category (see EN 301 649 [i.3] and TS 102 527-2 [i.5])
a25 to a28
F.3 [7] O M 0,1,2,3 0,1,2,3
3 NG-DECT Extended wideband voice supported (TS 102 527-3 [i.6])
a29 F.3 [7] O M 0,1 0,1
4 NG-DECT FP extended wideband voice (TS 102 527-3 [i.6]) specific sets of services: Call transfer (external or internal)
a30 F.3 [7] O M 0,1 0,1
5 NG-DECT FP extended wideband voice (TS 102 527-3 [i.6]) specific sets of services: Common parallel call procedures (external or internal)
a31 F.3 [7] O M 0,1 0,1
6 NG-DECT FP extended wideband voice (TS 102 527-3 [i.6]) specific sets of services: Third party conference call (external or internal)
a32 F.3 [7] O M 0,1 0,1
7 NG-DECT FP extended wideband voice (TS 102 527-3 [i.6]) specific sets of services: Intrusion call
a33 F.3 [7] O M 0,1 0,1
8 NG-DECT FP extended wideband voice (TS 102 527-3 [i.6]) specific sets of services: Call defection
a34 F.3 [7] O M 0,1 0,1
9 "no emission" mode support (see EN 300 175-3 [5], TS 102 527-3 [i.6])
a35 F.3 [7] O M 0,1 0,1
10 List access feature support (see TS 102 527-3 [i.6])
a36 F.3 [7] O M 0,1 0
11 Easy pairing feature support. If supported, for security reasons, set to "1" and unset at the same time as a44 (see TS 102 527-3 [i.6])
a37 F.3 [7] O M 0,1 0,1
12 NG-DECT FP extended wideband voice (TS 102 527-3 [i.6]) specific sets of services: Multiple lines
a38 F.3 [7] O M 0,1 0,1
13 NG-DECT FP extended wideband voice (TS 102 527-3 [i.6]) specific sets of services: Multiple calls
a39 F.3 [7] O M 0,1 0,1
14 NG-DECT FP extended wideband voice (TS 102 527-3 [i.6]) specific sets of services: permanent CLIR