Recommendations for Further Research

Following are some suggestions for further research,

 It is recommended to extend ‘Generalised Reduction Pattern” including cost of the dampers. Hence optimisation can be modified for combined cost, benefit and technical aspects.

 It is recommended that the proposed analytical method be applied in wind- excited high-rise building structures equipped with MR dampers.

 Structures may have asymmetric due to geometry or stiffness and mass distributions. Therefore it is recommended to extend this procedure to asymmetry structures.

 Further research using experimental techniques can be carried out to demonstrate the effectiveness of the proposed methodologies.

Bibliography 164

Bibliography

Abbas, H., & Kelly, J. M. (1994). A methodology for design of viscoelastic dampers

in earthquake-resistant structures: Earthquake Engineering Research Center,

University of California.

Aguirre, N., Ikhouane, F., Rodellar, J., Wagg, D., & Neild, S. (2010). Modeling and

identification of a small scale magnetorheological damper. Paper presented

at the Proceedings of the IFAC International Workshop on adaptation and learning in control and signal processing.

Asai, T., Spencer, B., Iemura, H., & Chang, C. M. (2013). Nature of seismic control force in acceleration feedback. Structural Control and Health Monitoring,

20(5), 789-803.

ASCE/SEI_41-06. (2007). Seismic Rehabilitation of Existing Buildings (ASCE/SEI 41-06). American Society of Civil Engineers, Reston, VA.

ATC. (1993). Proceedings on seismic isolation, passive energy dissipation, and active control. ATC 17-1, Applied Technology Counsil.

ATC, A. (1996). 40, Seismic evaluation and retrofit of concrete buildings. Applied

Technology Council, report ATC-40. Redwood City.

Bahar, A., Pozo, F., Acho, L., Rodellar, J., & Barbat, A. (2010). Parameter identification of large-scale magnetorheological dampers in a benchmark building. Computers & structures, 88(3-4), 198-206.

Butz, T., & Von Stryk, O. (2002). Modelling and simulation of electro-and magnetorheological fluid dampers. ZAMM, 82(1), 3.

Chang, K., Soong, T., Oh, S., and Lai, M. . (1995). Seismic Behavior of Steel Frame with Added Viscoelastic Dampers. Journal of Structural Engineering,

121(10), 1418-1426. doi: doi:10.1061/(ASCE)0733-9445(1995)121:10(1418)

Charles, S. W. (2002). The preparation of magnetic fluids Ferrofluids (pp. 3-18): Springer.

Craig, R. R., & Yung-Tsen, Y.-T. (1982). Generalized substructure coupling procedure for damped systems. AIAA journal, 20(3), 442-444.

CSI. (2013). Computers and Structures Inc. Berkeley, CA, USA.

Das, D., Datta, T., & Madan, A. (2012). Semiactive fuzzy control of the seismic response of building frames with MR dampers. Earthquake engineering &

structural dynamics, 41(1), 99-118.

Dyke, S. J., Jr, B. F. S., Carlson, M. K. S., & J, D. (1996). Modeling and control of magnetorheological dampers for seismic response reduction. Smart Materials

and Structures, 5(5), 565-575.

FEMA-356. (2000). NEHRP Guidelines for the Seismic Rehabilitation of Buildings: Building Seismic Safety Council Washington, DC.

FEMA, F. (1997). 273: NEHRP Guidelines for the seismic rehabilitation of buildings. Federal Emergency Management Agency.

FEMA, F. (2000). 356: Prestandard and commentary for the seismic rehabilitation of buildings. FEMA Publication No, 356.

Filiatrault, A., & Cherry, S. (1990). Seismic design spectra for friction-damped structures. Journal of Structural Engineering, 116(5), 1334-1355.

Fujino, Y., Soong, T., & Spencer Jr, B. (1996). Structural control: Basic concepts and applications. STRUCT CONGR PROC, ASCE, NEW YORK, NY,(USA),

Bibliography 165

Gavin, H., Hoagg, J., & Dobossy, M. (2001). Optimal design of MR dampers.

Proceedings of US-Japan Workshop on Smart Structures for Improved Seismic Performance in Urban Regions, 225-236.

Goncalves, F. D., Ahmadian, M., & Carlson, J. (2006). Investigating the magnetorheological effect at high flow velocities. Smart Materials and

Structures, 15(1), 75.

Ha, Q. P., Kwok, N. M., Nguyen, M. T., Li, J., & Samali, B. (2008). Mitigation of seismic responses on building structures using MR dampers with Lyapunov‐ based control. Structural Control and Health Monitoring, 15(4), 604-621. Hahn, G. D., & Sathiavageeswaran, K. R. (1992). Effects of added-damper

distribution on the seismic response of buildings. Computers & structures,

43(5), 941-950.

Jolly, M. R., Bender, J. W., & Carlson, J. D. (1998). Properties and applications of

commercial magnetorheological fluids. Paper presented at the 5th Annual

International Symposium on Smart Structures and Materials.

Kim, H.-S., & Kang, J.-W. (2012). Semi-active fuzzy control of a wind-excited tall building using multi-objective genetic algorithm. Engineering Structures, 41, 242-257.

Kodikara, T., Chan, T. H., Nguyen, T., & Thambiratnam, D. P. (2015). Model updating of real structures with ambient vibration data.

Lee, K.-S., Ricles, J., & Sause, R. (2009). Performance-based seismic design of steel MRFs with elastomeric dampers. Journal of Structural Engineering, 135(5), 489-498.

LORD, C. from http://www.lord.com/

Lu, L.-Y., Chung, L.-L., Wu, L.-Y., & Lin, G.-L. (2006). Dynamic analysis of structures with friction devices using discrete-time state-space formulation.

Computers & structures, 84(15), 1049-1071.

Marko, J., Thambiratnam, D., & Perera, N. (2004). Influence of damping systems on building structures subject to seismic effects. Engineering Structures, 26(13), 1939-1956. doi: 10.1016/j.engstruct.2004.07.008

Metwally, H., El-Souhily, B., & Aly, A. (2006). Reducing vibration effects on buildings due to earthquake using magneto-rheological dampers. Alexandria

Engineering Journal, 45(2), 131-140.

Nguyen, T. (2014). SHM through flexible vibration sensing technologies and robust

safety evaluation paradigm. Queensland University of Technology.

Ogata, Y. (2010). Space—time heterogeneity in aftershock activity. Geophysical

Journal International, 181(3), 1575-1592.

Oh, H.-U., Onoda, J., & Minesugi, K. (2004). Semiactive isolator with liquid-crystal type ER fluid for momentum-wheel vibration isolation. Journal of vibration

and acoustics, 126(2), 272-277.

Pall, A. S., & Marsh, C. (1982). Response of friction damped braced frames. Journal

of Structural Engineering, 108(9), 1313-1323.

Papadrakakis, M., Fragiadakis, M., Lagaros, N. D., & Plevris, V. (2011).

Computational methods in earthquake engineering: Springer.

Papadrakakis, M., Fragiadakis, M., & Plevris, V. (2014). Using the new sap2000 open application programming interface to develop an interactive front-end for the modal pushover analysis of bridges.

Pong, W., Tsai, C., & Lee, G. (1994). Seismic study of viscoelastic dampers and

TPEA devices for high-rise buildings. Paper presented at the Proc., First

Bibliography 166

Pourzeynali, S., & Mousanejad, T. (2010). Optimization of semi-active control of seismically excited buildings using genetic algorithms. Scientia Iranica,

Transaction A, Civil Engineering, 17(1).

Rabinow, J. (1948). The Magnetic Fluid Clutch. American Institute of Electrical

Engineers, Transactions of the, 67(2), 1308-1315. doi: 10.1109/T-

AIEE.1948.5059821

Rich, J. P., Doyle, P. S., & McKinley, G. H. (2012). Magnetorheology in an aging, yield stress matrix fluid. Rheologica acta, 51(7), 579-593.

SEAOC. (1995). Performance-based seismic engineering. Structural Engineers

Association of California, Sacramento, CA.

Shames, I., & Cozzarelli, F. (1992). Elastic and inelastic stress analysisPrentice-Hall.

Englewood Cliffs, NJ.

Snyder, R. A., Kamath, G. M., & Wereley, N. M. (2000). Characterization and

analysis of magneto-rheological damper behavior due to sinusoidal loading.

Paper presented at the SPIE's 7th Annual International Symposium on Smart Structures and Materials.

Snyder, R. A., & Wereley, N. M. (1999). Characterization of a magnetorheological

fluid damper using a quasi-steady model. Paper presented at the 1999

Symposium on Smart Structures and Materials.

Soong, T. T., & Spencer Jr, B. F. (2002). Supplemental energy dissipation: state-of- the-art and state-of-the-practice. Engineering Structures, 24(3), 243-259. doi: 10.1016/s0141-0296(01)00092-x

Soong, Y., Gruber, D., Peterson, L., & Rothschild, R. (1990). Spectral behavior of Hercules X-1-Its long-term variability and pulse phase spectroscopy. The

Astrophysical Journal, 348, 641-646.

Spencer, B., Dyke, S., Sain, M., & Carlson, J. (1997). Phenomenological model for magnetorheological dampers. Journal of engineering mechanics, 123(3), 230- 238.

Spencer Jr, B., & Nagarajaiah, S. (2003). State of the art of structural control.

Journal of Structural Engineering, 129, 845.

Spencer Jr, B., & Sain, M. K. (1997). Controlling buildings: a new frontier in feedback. Control Systems Magazine, IEEE, 17(6), 19-35.

Symans, M. D., Charney, F. A., Whittaker, A. S., Constantinou, M. C., Kircher, C. A., Johnson, M. W., & McNamara, R. J. (2008). Energy Dissipation Systems for Seismic Applications: Current Practice and Recent Developments.

Journal of Structural Engineering, 134(1), 3-21.

Symans, M. D., & Constantinou, M. C. (1999). Semi-active control systems for seismic protection of structures: a state-of-the-art review. Engineering

Structures, 21(6), 469-487. doi: 10.1016/s0141-0296(97)00225-3

TheMathWorksInc. (2014). MATLAB.

Tseng, H., & Hedrick, J. (1994). Semi-active control laws-optimal and sub-optimal.

Vehicle System Dynamics, 23(1), 545-569.

Tu, F., Yang, Q., He, C., & Wang, L. (2012). Experimental study and design on automobile suspension made of magneto-rheological damper. Energy

Procedia, 16, 417-425.

Wen, Y.-K. (1976). Method for random vibration of hysteretic systems. Journal of

the engineering mechanics division, 102(2), 249-263.

Wilson, E. L. (1997). SAP2000: integrated finite element analysis and desing of

Bibliography 167

Wu, B., Zhang, J., Williams, M., & Ou, J. (2005). Hysteretic behavior of improved Pall-typed frictional dampers. Engineering Structures, 27(8), 1258-1267. Yang, G., Spencer Jr, B. F., Carlson, J. D., & Sain, M. K. (2002). Large-scale MR

fluid dampers: modeling and dynamic performance considerations.

Engineering Structures, 24(3), 309-323. doi: 10.1016/s0141-0296(01)00097-

9

Yoshida, O., & Dyke, S. J. (2004). Seismic control of a nonlinear benchmark building using smart dampers. Journal of engineering mechanics, 130(4), 386-392.

Zapateiro, M., Luo, N., Karimi, H. R., & Vehí, J. (2009). Vibration control of a class of semiactive suspension system using neural network and backstepping techniques. Mechanical Systems and Signal Processing, 23(6), 1946-1953. doi: 10.1016/j.ymssp.2008.10.003

Zhu, W. Q., Luo, M., & Dong, L. (2004). Semi-active control of wind excited building structures using MR/ER dampers. Probabilistic Engineering