• No results found

IMPORTANT SAFETY SYMBOLS IMPORTANT SAFETY INSTRUCTIONS. Read these instructions. Keep these instructions. Heed all warning. Follow all instructions.

N/A
N/A
Protected

Academic year: 2021

Share "IMPORTANT SAFETY SYMBOLS IMPORTANT SAFETY INSTRUCTIONS. Read these instructions. Keep these instructions. Heed all warning. Follow all instructions."

Copied!
5
0
0

Loading.... (view fulltext now)

Full text

(1)
(2)

1 ON: Denotes the apparatus is turned on

OFF: Denotes the apparatus is turned off.

CAUTION: Describes precautions that should be observed to prevent danger of the apparatus.

CAUTION

RISK OF ELECTRIC SHOCK DO NOT OPEN

Protective grounding terminal

WARNING: Describes precautions that should be observed to prevent the danger of injury or death to the operator.

¡ã

¡ã

The symbol is used to indicate that some hazardous live terminals are involved within this apparatus, even under the normal operating conditions, which may be sufficient to constitute the risk of electric shock or death.

The symbol is used in the service documentation to in- dicate that specific component shall be replaced only by the component specified in that documentation for safety reasons.

Alternating current/voltage Hazardous live terminal

Read these instructions.

Keep these instructions.

Heed all warning.

Follow all instructions.

Water & Moisture

The apparatus should be protected from moisture and rain, can not used near water, for example: near bathtub, kitchen sink or a swimming pool, etc.

Heat

The apparatus should be located away from the heat source such as radiators, stoves or other appliances that produce heat.

IMPORTANT SAFETY SYMBOLS

IMPORTANT SAFETY INSTRUCTIONS

Use only with the cart, stand, tripod, bracket, or table specified by the manufacturer, or sold with the apparatus. When a cart is used, use caution when moving the cart/apparatus combination to avoid injury from tip-over.

RISK OF ELECTRIC SHOCK DO NOT OPEN CAUTION:

TO PREVENT ELECTRIC SHOCK DO NOT REMOVE TOP OR BOTTOM COVERS. NO USER SERVICEABLE PARTS INSIDE WARNING:

TO REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK. DO NOT EXPOSE THIS EQUIPMENT TO RAIN OR MOISTURE ON

RIGHT 4

LEFT 4 OUTPUT

LEFT SPEAKER RIGHT SPEAKER

MAINS INPUT 115/230V 60/50Hz Pwr: 250VA T 5A H 110-120V FUSE T 2.5A H 220-240V

(3)

Cleaning

Clean only with a dry cloth. Do not use any solvents such as benzol or alcohol.

Servicing

Do not implement any servicing other than those means described in the manual.

Refer all servicing to qualified service personnel only.

Only use accessories/attachments or parts recommended by the manufacturer.

Electrical Connection

Improper electrical wiring may invalidate the product warranty.

Power Cord and Plug

Protect the power cord from being walked on or pinched particularly at plugs, convenience receptacles, and the point where they exit from the apparatus. Do not defeat the safety purpose of the polarized or grounding-type plug. A polarized plug has two blades with one wider than the other. A ground- ing type plug has two blades and a third grounding prong.

The wide blade or the third prong is provided for your safety.

If the provided plug does not fit into your outlet, refer to elec- trician for replacement.

Power Supply

The apparatus should be connected to the power supply only of the type as marked on the apparatus or described in the manual. Failure to do could result in damage to the product and possibly the user. Unplug this apparatus during lightning storms or when unused for long periods of time.

Fuse

To prevent the risk of fire and damaging the unit, please use only of the recommended fuse type as described in the manual.

Before replacing the fuse, make sure the unit turned off and disconnected from the AC outlet.

Ventilation

Do not block areas of ventilation opening. Failure to do could result in fire. Always install accordance with the manufacturer's instructions.

Object and Liquid Entry

Objects do not fall into and liquids are not spilled into the inside of the apparatus for safety.

Application

-15 +15 -15 +15 -15 +15

-15 +15 -15 +15 -15 +15

0 10 0 10 0 10

0 10 0 10 0 10

0 10 0 10 0 10

HIGH

LOW

MON

EFF

LEVEL HIGH

LOW

MON

EFF

LEVEL HIGH

LOW

MON

EFF

LEVEL

CH 1 CH 2 CH 3

MIC IN MIC IN MIC IN

LINE IN LINE IN LINE IN

-15 +15

-15 +15

0 10

0 10

0 10 HIGH

LOW

MON

EFF

LEVEL

CH 4/5

MIC IN

LINE L LINE R

-15 +15

-15 +15

0 10

0 10

0 10 HIGH

LOW

MON

EFF

LEVEL

CH 6/7

MONO STEREO TAPE IN

REC OUT R L

L R

L R

0 10

0 10 0 10

0 10 MON UP POWER

DOWN

MASTER PROGRAM

OUTPUT

L R

EFF

MON INSERT RETURNEFF

LEVEL

0 0

-6 -6

-12 -12

+6 +6

+12 +12

100 200 500 1K 2K 5K 10K

G R A P H I C E Q U A L I Z E R

INSTRUMENTS EFF / MUTE FOOT SWITCH

DIGITAL EFFECT PROCESSOR 0-Hall1 1-Hall2 2-Room1 3-Room2 4-Room3 5-Plate1 6-Plate2 7-Spring

8-DLY 5ms 9-DLY 10ms A-DLY 20ms B-DLY 30ms C-DLY 200ms D-DLY 300ms E-DLY 400ms F-DLY 500ms

..

Condenser Mic bal

Bass/ Guitar

Power Amplifier Monitor Speaker

Effector Recorder

UP BYPASS STORE

DOWNENTERRECALL

ANALOG LEVEL SEARCHDELAYFEED BACK

1 3

2 4

5

06

1 3

2 4

5

06

POWER INPUT OUTPUT CONTROL PANEL

HALL GATE ROOM

DELAY CHORUS FLANGER PITCH SHIFTER DISTORTION

DUAL ENGINE PROCESSOR

. . .

CLIP

L dB R - 5- 10 - 20 - 30

ON EDITSTORE RECALL + +

F M 3 1 0 6 75

RDSSEEK

1 2RPT3I S4D S5RND6

D - D +

PTYAF CD TUNER BAND

LOCMON

T AP S CLK

CD

(4)

23

Introduction

Congratulations on your purchase Powered Mixing console.

manual carefully it in a safe place for f- uture reference.

Main Features

1. CH MIC, Lo-Z input (XLR-Bal), Hi-Z input(1/ 4"Bal phone jack)

2. CH Stereo, 2-Track input channel.

It may be used for Guitar, key-board, CD and Tape recorder signal input.

3. Each channel: 2 Band EQ, Monitor, Effect and signal control.

4. Feed back display Equalizer.

5. Stereo, AUX input channel.

6. 62GD built-in set Digital sound effect processing system (DSP). 62GE built-in Electronic Reverb.

7. 50W/4 + 50W/4 power amplifier.

8. High reliable protection circuit.

Mixer Specifications 1. Rated output power: 10

Pl-

ease read this and keep

0W/4 + 100W/4 2. T. H. D: 0.08% (1KHz 20W)

3. Frequency Response: 20Hz-20KHz, 0.5dB 4. Input level ref: 0dB=0.775V 1mW 600 MIC CH (Lo - Z bal) -58dB

MIC CH (Hi -Z bal) -26dB AUX IN TAPE IN -22dB

5. Surplus Noise: -45dB 6. Equalizer

MIC CH: HIGH-10KHz 15dB, LOW-100Hz 15dB LINE CH: HIGH-10KHz 15dB, LOW-100Hz 15dB Graphic Equalizer:

(100Hz, 200Hz, 500Hz, 1KHz, 2KHz, 5KHz, 10KHz) 12dB MAX, with feed back display 7-band graphic equalizer.

7. Effect:

3201

8. Power Supply: AC 110-120V/60Hz 220-240/50Hz Power Consumption: 150W

9. Volume: 420mm x 275mm x 300mm 10. Weight: 6Kg

REAR PANEL

26. POWER SWITCH

27. POWER SOCKET (with fuse) 28. OUTPUTS 1 / 4" phone jack.

6

0-Hall1 1-Hall2 2-Room1 3-Room2

4-Room3 5-Plate1 6-Plate2 7-plate3 8-Chorus

9-flange A-delay1 B-delay2

C-Chorus/Room1 D-chorus/Room2 E-vocal cancel F-rotary speaker

RISK OF ELECTRIC SHOCK DO NOT OPEN CAUTION:

TO PREVENT ELECTRIC SHOCK DO NOT REMOVE TOP OR BOTTOM COVERS. NO USER SERVICEABLE PARTS INSIDE WARNING:

TO REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK. DO NOT EXPOSE THIS EQUIPMENT TO RAIN OR MOISTURE

ON

RIGHT 4

LEFT 4 OUTPUT

11

26

1127 1128

MAINS INPUT 115/230V 60/50Hz Pwr: 250VA T 5A H 110-120V FUSE T 2.5A H 220-240V

(5)

SYSTEM BLOCK DIAGRAM

23

1 SPEAKER EFF SEND LOWPASS FILTERDSP MODULE FOOT SWITCH

EFF RETURN

L REC R

LEFT RIGHT

7 BAND FEED BACKDISPLAY

HEAD PHONE Y/R L CHPOWER AMP(PROTECTOR) MONITOR MONITOR OUTPUT

EQUALIZER R CHPOWER AMP(PROTECTOR)

LO-Z

MIC INPUT CH 1-6 HI-Z

PA N

LEFT&MONOIN STEREO INPUT RIGHT IN STEREO AUX INPUT

L PLAYR POWER SUPPLY

TO POWER AMP TO MIXING

AC230V 50Hz

EQUALIZER AMP SENDLINE OUT

5 DOT DISPLAYLED 5 DOT DISPLA\YLED

HEAD PHONE OUTPUT

RETURN MAIN IN RETURN MAIN IN L OUTPUT SPEAKER R OUTPUT

SENDLINE OUT PAD

LOWHIGH LEVEL

PAN EFF

MONITOR

L R EF F

MO NIT

OR +V

-V

GN D

EQUALIZER LOWHIGH LOWHIGH TYPE & AUX

AMP EQUALIZER AMP

LE VE

L L VE LE

EF FE CT

MIC CHANNEL INPUT 1. HIGH (EQ)

2.LOW (EQ)

3. MONITOR VOLUME CONTROL 4. EFF LEVEL

5. LEVEL Channel level 6. Lo-Z XLR connector(Bal)

STEREO CHANNEL INPUT 7. HIGH

8. LOW (EQ) (EQ)

9. MONITOR VOLUME CON- TROL

10. EFF LEVEL

11. LEVEL Channel Level 12. LEFT& MONO 1 / 4" ph- one jack.

13. RIGHT 1 / 4" phone jack.

14. Lo-Z XLR Connector(Bal) 15. TAPE IN/REC OUT L/R RCA connector

16. Mono and Stereo selector

FRONT PANEL

-15 +15

-15 +15

0 10

0 10

0 10 HIGH

LOW

MON

EFF

LEVEL

CH 3

MIC IN LINE IN

-15 +15

-15 +15

0 10

0 10

0 10 HIGH

LOW

MON

EFF

LEVEL

CH 4/5

MIC IN

LINE L LINE R

1

2

3

4

5

6

118

9

10

11

13

14 117

12

15 16

MONO STEREO TAPE IN

REC OUT L R

L R

19. Program selector lab l

20. MASTER LEVEL: Left, Right, Monitor.

21. AUX IN (Stereo) 1 / 4 phone jack.

22. EFF OUT Return 1 /4 phone . 23. MONITOR OUT 1 / 4 phone . 24. LINE OUT Send 1 / 4 phone . 25. FOOT SWITCH

(16 band) e

"

" jack

" jack

" jack 1 / 4" phone jack.

18. Eff Return Level control 17. 7 Band EQ

L R

0 10

0 10 0 10

0 10 MON UP POWER

DOWN

MASTER PROGRAM

OUTPUT

L R

EFF

MON INSERT

RETURNEFF

LEVEL

0 0

-6 -6

-12 -12

+6 +6

+12 +12

100 200 500 1K 2K 5K 10K

G R A P H I C E Q U A L I Z E R

INSTRUMENTS EFF / MUTE

FOOT SWITCH

DIGITAL EFFECT PROCESSOR

..

11171118

11 20

1121 1

122 1

123 1

124

1811 19

1125

0-Hall1 1-Hall2 2-Room1 3-Room2

4-Room3 5-Plate1 6-Plate2 7-Plate3 8-Chorus

9-Flange A-Delay1 B-Delay2

C-Chorus/Room1 D-Chorus/Room2 E-Vocal Cancel F-Rotary Speaker

0-Hall1 1-Hall2 2-Room1 3-Room2 4-Room3 5-Plate1 6-Plate2 7-Plate3

8-Chorus 9-Flange A-Delay1 B-Delay2 C-Chorus/Room1 D-Chorus/Room2 E-Vocal Cancel F-Rotary Speaker

References

Related documents

5. Before use, put the inner bowl into the bread maker, turn it clock- wise to lock. Make sure to install the mixing paddle in the center of the inner bowl. It is critical for

If you want to change the special function press the “OFF“ button and then the “PUSH&GO“ button to select the desired function.. To deactivate the special functions, press

Failure to follow these instructions so could result in substantial property damage, severe personal injury, or death.... Follow all instructions in the boiler installation

During installation, make sure the appliance does not damage the power cable - risk of fire or electrical shock.. Only activate the appliance when the installation has

 Papillary ca of thyroid  Medullary C Follicular D Anaplastic. 191 normal thyroid

Power Sources - The appliance should be connected to a power supply only of the type described in the operating instructions or as marked on the

Read and follow all Safety, Assembly, and Use and Care Instructions in this Guide before assembling and using the appliance.. Failure to follow all instructions in this Use and

*METEOR LIGHTING reserves the right to make changes to this product at any time without prior notice and such modification shall be effective immediately.... ADVANCED