Appliance Quick Start Guide v6.21

If you are using NAT mode you don't need to make any changes to the real servers except to make sure the load balancers internal floating ip address needs to be set as the

The load balancer must be in a NAT configuration (internal and external sub nets) with the real servers using the load balancers internal Floating IP address as their default

When using a clustered pair of load balancers in two-arm NAT mode all load balanced services must be configured on a floating IP and the real servers must also have their

If you are using a two-arm NAT load balancing method the real server configuration is a simple case of configuring the load balancer as the default gateway.. The real server must

If you are using a two-arm NAT load balancing method, the Real Server configuration is a simple case of configuring the load balancer as the default gateway. Normally, a floating

• Virtual Services & Real Servers (i.e. the IIS servers) must be on different subnets • The default gateway on the IIS servers should be an IP address on the load balancer •

The issues with using Proxy are that the default Filter on the real servers (i.e. the Web Filters) must be changed to point as the load balancer and also it requires a

• Load Balancer Clustered Pair 1 – Used to load balance the Internal Edge, the Director Servers and the Enterprise Front End Servers. • Load Balancer Clustered Pair 2 – Used to