4. SSL-VPN Connection

(1)

4. SSL-VPN Connection

Guide of Configuring INAZUMA Certified Systems

(2)

Agenda

Contents

Explanation Scope on this document

Overview

0.

Getting Started

Please be sure to read this for using INAZUMA Certified Systems.

Preparation

1.

Receiving the user registration notice

An e-mail notices you that your registration application is accepted.

2.

Installation of the Client Certificate

Client Certificate is for proving your PC identity.

3.

Obtaining the Global ID

Each user should get unified ID for using INAZUMA Certified Systems.

Connecting to INAZUMA Certified Systems

4.

SSL-VPN Connection

SSL-VPN is encrypted communication network.

5.

Log in Common Authentication Service

This authentication is common authentication system for users of INAZUMA Certified Systems.

4-1. Connecting to SSL-VPN Server

About how to connect to SSL-VPN Server.

4-2. Select Client Certificate

About how to select Client Certificate.

4-3. Add-On Installation for SSL-VPN Connection

Installation of Add-On(ActiveX) is needed one time.

4-4. Activating Add-On Module and Establishment of SSL-VPN Add-On Modules starts automatically, SSL-VPN is established. 4-5. Quitting SSL-VPN connection

(3)

4-1. Connecting to SSL-VPN Server

Access to following URL. https://vpn.portal.sony.biz/jsaz 4-1. Connecting to SSL-VPN Server

About how to quit the SSL-VPN connection.

SSL_VPN, a form of telecommunication, is necessary to connect to

INAZUMA Certified Systems, but not all systems require it. Please check if the system which you connect to requires SSL_VPN or not .

SSL-VPN is automatically established by connecting to the specified URL by Sony through an internet browser “Internet Explorer”.

This page describes how to connect to SSL-VPN Server.

Overview

1. Run “Internet Explorer”.

2. Access the URL below.

https://vpn.portal.sony.biz/jsaz

Steps

Note

(4)

4-2. Select Client Certificate

If more than one Client Certificate have been installed on you computer, [Choose a digital certificate] dialog will pop up.

Select Client Certificate downloaded from Sony when using INAZUMA Certified Systems.

Overview

1. [Choose a digital certificate] Dialog pops up. 2. [Choose a digital certificate] Dialog shows a list of Client Certificates installed on your PC. 3. Choose Client Certificate downloaded from

Sony when using INAZUMA Certified Systems.

4. Click [OK].

Steps

Tip

This window will NOT show up if only one Client Certificate has been installed.

Choose a certificate.

(5)

4-3. Add-On Installation for SSL-VPN Connection [1/2]

Click the information bar.

Click [Install ActiveX Control]. 4-1. Connecting to SSL-VPN Server

Installation of Add-On(ActiveX) is necessary for SSL-VPN Connection. An install wizard will run automatically on a first access to a SSL-VPN Server.

Overview

1. Click on the information bar regarding [JuniperSetupClient.cab] displayed on Internet Browser.

2. Click [Install ActiveX Control] on the Drop Down Menu.

Steps

Tip

Installing Add-On(ActiveX) for SSL-VPN Connection is required when you first connect to a SSL-VPN Server or the version of SSL-VPN is updated.

(6)

Click [Install]

4-3. Add-On Installation for SSL-VPN Connection [2/2]

3. Click [Install] on a [Internet explorer Add-on Installer - Security warning] Dialog.

4. It will be downloaded and installed automtatically.

5. It approximately takes one minute to be installed depending on network speed. 6. Once the installation is finished, SSL-VPN

Connection runs automatically. (Refer to 4-4.)

Steps

Note

The installation needs Power User Authority or Administrator Authority.

(7)

①

②

4-3. Add-On Installation for SSL-VPN Connection [TIP]

1) Click [OK]

2) Close the browser 3) Access the URL again 4) Install Add-On again

< If the screen (2) appears while establishing a connection …>

1) Click[Continue the session]

2) Quite the existed connection and try to connect SSL-VPN again

(8)

4-4. Activating Add-On Module and Establishment of SSL-VPN

[ Precondition ] An Add-On(ActiveX) for SSL-VPN Connection has been installed.

Authentication Success. Please open new browser and type URL.

An SSL-VPN icon appears on the [System Tray]. 4-1. Connecting to SSL-VPN Server

If you try 4-1. and 4-2. once again after finishing [4-3. Add-On Installation for SSL-VPN Connection], the Add-On runs automatically and SSL-VPN connection will be established.

Overview

1. Follow instructions in 3-1, and 3-2 again. (URLs connected to ; check Appendix1)

1. The Add-On runs automatically and SSL-VPN Connection will be established. 2. If SSL-VPN Connection is set, a message

will be displayed on Internet Browser. 3. Also an SSL-VPN icon will appear on the

[System Tray].

Steps

(9)

4-5. Quitting SSL-VPN connection

Guide of SSL-VPN Connection ends here.

This page describes how to quit the SSL-VPN connection after logging out from each INAZUMA Certified Systems.

Click the [Sign Out] from [Basic View] icon, and then quite the SSL-VPN connection.

For log in each INAZUMA Certified System with SSL-VPN connection, please read “5.Log in Common Authentication Service”.

Overview

1. Right click on the icon in task tray.

2. A pop-up window appears so that choose [Basic View].

3. Click [Sign Out] on [Basic View] window. 4. The connection will be cut.

Steps

[ Precondition ] SSL-VPN connection has been established.

(10)

Appendix

(11)

Appendix1. SSL-VPN URL

Connecting SSL-VPN, please access to following URL.

https://vpn.portal.sony.biz/jsaz

(12)

Revision History

(13)

Revision History

Date

Ver.

Contents for change

Editor

Apr. 08, 2011 1.0 First edition INAZUMA Head Office Sep. 20, 2011 2.0 The URL of SSL-VPN is revised on Page 3

Caution is deleted on Page 7 Appendix1 is added

INAZUMA Head Office

Feb. 13, 2012 3.0 3-3. Add-On Installation for SSL-VPN Connection(1/2) was updated. 3-3. Add-On Installation for SSL-VPN Connection(Note)was added. 3-5. Quitting SSL-VPN connection was added.

The manual No. was changed from 3 to4.

IINAZUMA Head Office

Mar. 01, 2013 3.1 Added “SPIRITS” to the sub title on the cover. Added “and SPIRITS” to [Agenda].

Deleted one of SSL-VPN URLs from [4-1. Connecting to SSL-VPN Server] and Appendix.

Changed the client module name on [4-3. Add-On Installation for SSL-VPN Connection [1/2]].

INAZUMA Head Office

Jun. 27, 2013 3.2 Deleted the word of “SPIRITS” in this manual. INAZUMA Head Office Jun. 17, 2014 3.3 Changing layouts and some expressions. INAZUMA Head Office Apr. 13, 2015 3.4 Specifying “Internet Explorer” for internet browser on [4-1. Connecting to

SSL-VPN Server].

(14)

4. SSL-VPN Connection