• No results found

The Fabrication of Nano Particles in Aqueous Solution From Oxyfluoride Glass Ceramics by Thermal Induction and Corrosion Treatment

N/A
N/A
Protected

Academic year: 2020

Share "The Fabrication of Nano Particles in Aqueous Solution From Oxyfluoride Glass Ceramics by Thermal Induction and Corrosion Treatment"

Copied!
5
0
0

Loading.... (view fulltext now)

Full text

Figure

Fig. 1 a XRD patterns of GCsTEM micrographs of nano-particles existing in glassmatrix.after thermal induction
Fig. 3 Measured UC red and green emission in GCs and nano-particles in aqueous solution under diode laser excitation of 980 nm

References

Related documents

Cabrera Luna, Marcela, "The Role of the State, Multinational Oil Companies, International Law & the International Community: Intersection of Human Rights &

A base-line measurement was performed before an educational intervention and a follow-up measurement was made afterwards in both groups, using a study specific questionnaire in

Results: Cases had statistically higher urinary levels of 2,5-HD (0.48 mg/L) than the general population (0.41 mg/L) and men higher excretion than women (0.48 mg/L and 0.38

Inertial-range asymptotic behavior of a vector (e.g., mag- netic) field, passively advected by a strongly anisotropic turbulent flow, is investigated by means of the field

This paper describes four such studies in which EC control has proved crucial – increased resolution Thomson Scattering measurements in the plasma edge, time-resolved plasma

Suman Sharma, “Finite Element Analysis of Spur Gear Used in Lathe Headstock”, International Journal of Engineering Sciences & Research Technology. “Design of machine

Source: (Airspace Management Cell, 2018).. “Synchronised operations” understands the ATC interaction with a drone operator based on the assessment of the characteristics of

Mexico’s cohabitation boom of the 2000s was driven by cohorts born after 1975, whose cohabiting unions are less likely to transition to marriage than those formed by earlier