Adsorptive removal
Adsorptive Removal of Aniline from Aqueous Solutions Using Prunus dulcis (Almond): Equilibrium, Kinetics and Thermodynamics
... This study was aimed at investigating Adsorptive removal of Aniline from aqueous solutions using Prunus dulcis. The effect of different parameters such as pH, contact time, pollutant concentration and ...
6
Adsorptive Removal of Antimony (III) Using Modified Montmorillonite: A Study on Sorption Kinetics
... The adsorptive removal of antimony (III) has been successfully obtained on montmorillonite (MMT) and modified MMT from synthetic solution. The adsorption behavior of the modified and unmodified MMT has been ...
9
Adsorptive Removal of Cr(VI) and Cu(II) Ions from Water Solution using Graphene Oxide-Manganese Ferrite (GMF) Nanomaterials
... for adsorptive removal of Cr(VI) and Cu(II) ...ions removal was investigated via batch adsorption study by varying parameters such as pH, ion concentration and contact ...
6
Adsorptive Removal of Cadmium and Lead from Oryza Sativa Rice by Banana Peel as Bio-Sorbent
... the removal efficiency, our finding proved that treating banana peel as a waste material by citric acid 1% could have high potential in removing lead and cadmium from rice as a stable food for most people in Iran ...
11
Assessment and Enhancement of Powdered and Activated Carbon Derived from Persea Nuts for Adsorptive Removal Dyes from Wastewaters
... The stability and regeneration ability of the used prepared adsorbents P-PAN and C-PAN during the adsorption process are essential to its practical application. Interestingly, to achieve the potential and applicability ...
8
Adsorptive Removal of Acid blue 45, from Aqueous Solutions by Preformed Flocs
... The length of the time required to reach equilibrium of sorption reaction is important to determine the capacity of the sorbent with respect to solute removal. Thus, the results of the kinetic studies are the ...
8
Adsorptive Removal of Zinc from Electroplating Effluent by Using Banana Peels as Bio Sorbent
... the removal of heavy metals from industrial waste water streams the bi-sorption process is used with use of natural, alternative and cheaper ...for removal of zinc ion from electroplating industrial waste ...
5
Adsorptive Removal of Congo red dye from wastewater using Fenugreek Powder
... for removal of Congo red ...maximum removal of Congo red dye observed was ...for removal was 4 hours. The maximum removal of dye was found at acidic ...
8
Adsorptive Removal of Copper from Aqueous Solution by Using Syzygium Cumini L
... (II) removal could be noticed as the initial Cu(II) concentration in the solution increased, due to the saturation of the active sites in the solution (El-Ashtoukhy et ...
5
Adsorptive removal of Cd (II) using NTA modified Dendrocalamus strictus charcoal powder
... The effect of initial concentration on the adsorption of cadmium metal ions (UDC and MDC) was investigated by varying the cadmium concentration (50, 100, 200, 300, 400 and 500 mg/l) as shown in Fig. 1 d. It was observed ...
8
Simultaneous Adsorptive Removal of Cyanide and Phenol from Industrial Wastewater: Optimization of Process Parameters
... phenol removal against contact time of GAC at an adsorbent concentration of 30 g/L at various initial cyanide and phenol concentrations at optimum pH and temperature ...
10
Adsorptive removal of cadmium from aqueous solution by Luffa Cylindrica: Equilibrium, dynamic and thermodynamic
... The removal of toxic metal, cadmium, by using adsorption into Algerian Luffa Cylindrica, LC, was investigated. The biosorption process was studied with respect to contact time, particle size, pH and temperature. ...
10
Adsorptive Removal Of Nickel Ions By Natural Sand Collected From A Tank In Ramanathapuram, India
... Larger surface area imply a greater adsorption capacity, for example, carbon and activated carbon. Smaller particle sizes reduce internal diffusion and mass transfer limitation to penetrate of the adsorbate inside the ...
7
Adsorptive removal of lead (II) from aqueous solution by low cost adsorbents: A review
... Activated carbon prepared from the cones of the European Black pine was used as adsorbent for the removal of lead (II) ions from aqueous solutions 32 . The effect of pH, initial concentration of lead (II) ions, ...
20
Adsorptive removal of methylene blue by agar: effects of NaCl and ethanol
... their removal from industrial effluents before dischar- ging into the environment is extremely ...the removal of dyes in effluents include physical, chemical, and biological ...
13
Adsorptive Removal Of MB Dye By Graphitic-C3N4 From Industrial Effluents
... Abstract— Dyes in surface water are widely found due to extensive use of colorants in various industries such as textiles, printing and food plants. The contaminated effluents are the crucial reasons for water pollution. ...
6
Adsorptive Removal of Mercury by Using New Nano Adsorption
... Abstracts In the present work nano-hydroxyapatite/ Carboxymethyl Cellulose (n-HApCMC) composite was synthesized by precipitation method and was characterized by Fourier transform infrared (FT-IR) spectroscopy, X-ray ...
6
Synergistic Study of Hydroxyiron (III) and Kaolinite Composite for the Adsorptive Removal of Phenol and Cadmium
... In the case of Cadmium in Figures 14, it was observed that as the temperature increases from 298 K - 318 K an increase in percentage removal was observed from 45.972% - 55.992% for RK, 49.996% - 59.950% for TAK, ...
13
Adsorptive Removal of Methylene Blue by Biomass of Aspergillus versicolor: A Mechanistic Study.
... adsorbents of biological origin have advantage of possible biodegradtion. Methylene blue (MB), a cationic dye used extensively in dyeing and printing industries, on inhalation, may cause diseases of digestive and ...
8
Equillibrium Modelling of Adsorptive Removal of Methylene Blue Using BGA
... The removal of Methylene Blue dye from aqueous solution using a biowaste, dried Blue Green Algae was investigated in terms of variation of initial concentration of the dye solution, adsorbent dosage and ...the ...
6