• No results found

Cyclic load

Characteristics and Behavior of Geogrid-Reinforced Aggregate under Cyclic Load

Characteristics and Behavior of Geogrid-Reinforced Aggregate under Cyclic Load

... Within the realm of geosynthetic materials, geotextiles provide good separation, drainage and filtering characteristics, in addition to reinforcement capability. By providing higher tensile strength at low strains, woven ...

164

Ratchet analysis of structures under a generalised cyclic load history

Ratchet analysis of structures under a generalised cyclic load history

... direct cyclic methods in the sense that the full load cycle does not need to be fully analysed in a typical calculation, only the relevant peaks in the stress domain which give rise to the largest stress ...

9

Enhancing Performance of Infill Masonry With Skin reinforcement Subjected To Cyclic Load

Enhancing Performance of Infill Masonry With Skin reinforcement Subjected To Cyclic Load

... Static cyclic load is applied at the top of the beam using hydraulic actuators in steps of 1kN. Three cycles were given for each increment of loading. From the experimental investigations, yield ...

6

Flexural capacity and ductility of castella beam due to cyclic 
		load

Flexural capacity and ductility of castella beam due to cyclic load

... increase is affect the increased flexure capacity castela beam of 82.5% compared to the beam NB Besides that, increases in the beam high will increase the slenderness cross section (H/B) and lower radius of inertia (ry) ...

7

Stress Relaxation of a Paper Sheet under Cyclic Load: An Experimental and Theoretical Model

Stress Relaxation of a Paper Sheet under Cyclic Load: An Experimental and Theoretical Model

... at cyclic deformation (dynamic behavior), might give a better understanding of the difference in the performance of this type of material during a given time ...under cyclic loading on the paper sheet used ...

6

Response of Pile Foundations to Random Cyclic Loads

Response of Pile Foundations to Random Cyclic Loads

... the cyclic loads (e.g. one- way vs. two-way cyclic load or constant ...two cyclic tests performed in 1982 in Tampa Bay (Long & Vanneste, ...of load cycles has been another criticism ...

227

Fracture   Behavior of Straight Pipe and Elbow with Local Wall Thining

Fracture Behavior of Straight Pipe and Elbow with Local Wall Thining

... This study was performed to evaluate the fracture behavior of carbon steel straight pipes and elbows with local wall thinning under monotonic and cyclic load.. The res[r] ...

8

Behaviour of backfilled masonry arch bridges subjected to cyclic loading

Behaviour of backfilled masonry arch bridges subjected to cyclic loading

... Experimental research has demonstrated that the interaction between soil fill surrounding the arch barrel of a masonry arch bridge structure has a significant influence on ultimate limit state behaviour. However, little ...

11

Numerical Study on Retrofitting Of Beam Column Joint Strengthened With CFRP

Numerical Study on Retrofitting Of Beam Column Joint Strengthened With CFRP

... The structural geomentry of exterior beam column joint has been modelled for the mentioned dimension and analysed using ANSYS. The exterior beam column joint has been analysed without CFRP wrapping. The bottom of the ...

7

Behavior of ACB Masonry In Filled RC Frame Under Cyclic In Plane Lateral Load

Behavior of ACB Masonry In Filled RC Frame Under Cyclic In Plane Lateral Load

... These RC flanges were secured firmly to the base of the loading frame using adequate mild steel channels and clamps which were welded to the steel base of loading frame. The test set-up is made using jacks, dial gauge ...

8

BEHAVIOR OF SANDWICH COMPOSITES UNDER FLEXURAL AND FATIGUE LOADING: EFFECT OF VARIATION OF CORE DENSITY

BEHAVIOR OF SANDWICH COMPOSITES UNDER FLEXURAL AND FATIGUE LOADING: EFFECT OF VARIATION OF CORE DENSITY

... the cyclic load and test frequency play a critical role in determining fatigue strength and change in core density attributes to the failure through foam-face sheet delamination, and at higher frequencies ...

10

Cyclic Tearing of Through Wall Cracked Pipes made of Carbon Steel

Cyclic Tearing of Through Wall Cracked Pipes made of Carbon Steel

... applied load of magnitude equal to peak load at the postulated flaw location during the earthquake ...instability load of pipe with flaw is taken as equal to lower of the monotonic tearing ...

10

Utilisation of Waste Materials in the Construction Of Roads A Srinivas 1, DSV Prasad2 , M AnjanKumar 3, GVR Prasada Raju4

Utilisation of Waste Materials in the Construction Of Roads A Srinivas 1, DSV Prasad2 , M AnjanKumar 3, GVR Prasada Raju4

... compression tests were conducted. The tests have clearly shown a significant improvement in the shear strength and bearing capacity parameters and low strength and high compressible soft clay soils were found to improve ...

8

Simplified Method for the Assessment of Elastic-Plastic Shakedown in Piping

Simplified Method for the Assessment of Elastic-Plastic Shakedown in Piping

... under cyclic loads must be ...a cyclic load is applied, one can show that the stresses and strain rates will undergo steady cycling after a transient period ...

8

Термостійкість графітизованої сталі

Термостійкість графітизованої сталі

... thermal cyclic load C) the indices of graphitized steels' and cast irons' me- chanical properties in the temperature range of 20…800°С have been investigated ...thermal cyclic loads C within the ...

6

Quasi-cyclic fracture studies on narrow gap welded stainless steel straight pipes

Quasi-cyclic fracture studies on narrow gap welded stainless steel straight pipes

... the cyclic load amplitude (as a percentage of maximum load carrying capacity of a specimen under monotonic fracture) and number of cycles to failure of four specimens tested under ...the load ...

8

Ratchet limits for a crack in a welded pipe subjected to a cyclic temperature load an a constant mechanical load

Ratchet limits for a crack in a welded pipe subjected to a cyclic temperature load an a constant mechanical load

... In order to overcome the difficulties of the step-by-step elasto-plastic FEA, a number of direct methods based upon the Koiter's [5] kinematic and/or the Melan's [6] static theorems have been developed including: i) the ...

9

Effect of variations in load profile on power transformer cyclic ratings

Effect of variations in load profile on power transformer cyclic ratings

... the load profile by reducing peaks and increasing troughs, not by reducing demand in ...the load cycle was to decrease because this would mean a reduction in the total energy being supplied, hence ...

237

Biomechanical evaluation of an arthroscopic transosseous repair as a revision option for failed rotator cuff surgery

Biomechanical evaluation of an arthroscopic transosseous repair as a revision option for failed rotator cuff surgery

... more homogenously assigned in transosseous sutures in opposite to the anchor repair, where high values may be a risk factor for ischemic tissue damage [36]. To evaluate the Gap-formation and displacement two optical ...

7

Static Stress and Fatigue Analysis on Vertical Stabilizer of a Typical Trainer Aircraft

Static Stress and Fatigue Analysis on Vertical Stabilizer of a Typical Trainer Aircraft

... Fatigue is the progressive and localized structural damage that occurs when a material is subjected to cyclic loading. [2]Fatigue occurs when a material is subjected to repeat load[r] ...

7

Show all 10000 documents...

Related subjects