• No results found

high temperature gas turbine

Inventory of on-going high temperature materials research activities in Europe. Section 2: mechanical properties. EUR 8637 EN

Inventory of on-going high temperature materials research activities in Europe. Section 2: mechanical properties. EUR 8637 EN

... Long term creep behaviour of high temperature strength gas turbine materials.. Crack growth in high temperature materials at elasticity exceeding conditions at high temperatures.[r] ...

144

Performance Evaluation Of Gas Turbine By Reducing The Inlet Air Temperature

Performance Evaluation Of Gas Turbine By Reducing The Inlet Air Temperature

... inlet temperature of gas turbine is 35°C for that mass flow rate enters into the compressor is 671T/H with the atmospheric ...methane gas. The methane gas will be compressed from 10 bar ...

5

Performance of a Typical Simple Gas Turbine Unit under Saudi Weather Conditions

Performance of a Typical Simple Gas Turbine Unit under Saudi Weather Conditions

... of gas turbines has been discussed in various ...specific gas turbines (SGT ...ambient temperature above ISO conditions the units lose ...170 gas turbine units in Iran with a combined ...

13

Implementation and Thermal Analysis of Transition Duct in Industrial Gas Turbine

Implementation and Thermal Analysis of Transition Duct in Industrial Gas Turbine

... The efficiency of fuel generators becomes increasingly more vital simultaneously asthe pollutants demands get more difficult. Therefore it is crucial to hold the flametemperature within the area of effective combustion ...

5

Evaluation of the Influence of Ambient Temperature on the Performance of the Trans Amadi Gas Turbine Plant

Evaluation of the Influence of Ambient Temperature on the Performance of the Trans Amadi Gas Turbine Plant

... work, turbine net- work, specific fuel consumption and the thermal efficiency of the ...inlet temperature was lowered, the compressor work reduces, the turbine network increases, specific fuel ...

13

Modeling Study Of A Gas Turbine Burner Cooling Ring Efficiency In A Model Combuster Exit Duct

Modeling Study Of A Gas Turbine Burner Cooling Ring Efficiency In A Model Combuster Exit Duct

... improve gas turbine efficiency. The turbine inlet temperatures have increased steadily from 540 ˚C in the 1940s to 1425 ˚C and even higher ...the turbine blades with ceramic layer and cooling ...

24

Selection of technology for the low calorific synthetic gas combustion in the gas turbine combustion chamber

Selection of technology for the low calorific synthetic gas combustion in the gas turbine combustion chamber

... hot gas (300-500°С) combustion in the high-heat (900-1000°С) cycle ...fuel gas (up to 500°С) the low calorific gases combustion temperatures become entirely sufficient for the modern gas ...

5

EFFECT OF AMBIENT TEMPERATURE, GAS TURBINE INLET TEMPERATURE AND COMPRESSOR PRESSURE RATIO ON PERFORMANCE OF COMBINED CYCLE POWER PLANT

EFFECT OF AMBIENT TEMPERATURE, GAS TURBINE INLET TEMPERATURE AND COMPRESSOR PRESSURE RATIO ON PERFORMANCE OF COMBINED CYCLE POWER PLANT

... a gas turbine to produce useful work. The heat rejected by gas turbine is highly appreciable as the exhaust temperature is very ...steam turbine working on rankine cycle to ...

13

C H A P T E R F I V E GAS TURBINES AND JET ENGINES

C H A P T E R F I V E GAS TURBINES AND JET ENGINES

... the turbine and deliver just enough power to drive the compressor (the work condition ...the turbine exit at station 4, still hot and at a stagnation pres- sure well above the ...a ...

55

Inventory of on-going high temperature materials research activities in Europe. Section 1: corrosion. EUR 6919, revised edition 1981

Inventory of on-going high temperature materials research activities in Europe. Section 1: corrosion. EUR 6919, revised edition 1981

... 2 High temperature corrosion and creep/thermal shock of selected Ni-superalloys and coatings for gas turbine application_ 3 Development of corrosion resistant exhaust valve alloys_ 4 Dev[r] ...

61

Thermodynamic Modeling and Optimization of a Dual Pressure Reheat Combined Power Cycle

Thermodynamic Modeling and Optimization of a Dual Pressure Reheat Combined Power Cycle

... flue gas condition with an aim of getting minimum possible temperature ...For high performance, better conditions for compressor, HRSG sections, steam reheater and deaerator are ...a gas ...

9

Evaluation of the Gas Turbine Inlet Temperature with Relation to the Excess Air

Evaluation of the Gas Turbine Inlet Temperature with Relation to the Excess Air

... ambient temperature, the humidity content in- creases ...for high ambient temperature ...for gas turbine combustion when there ambient temperature values up to 30˚C and relative ...

8

Study & Analysis Of Effects Of Thermal Barrier Coating (TBC) On Gas Turbine Engine

Study & Analysis Of Effects Of Thermal Barrier Coating (TBC) On Gas Turbine Engine

... the turbine flow passage use the cooling air travelling between the combustor and outer engine case where as the turbine rotor blades, disks, and inner wall of the turbine flow passage use cooling ...

5

Analysis Of Inlet Air Temperature Effect On Gas Turbine Compressor Perfornance

Analysis Of Inlet Air Temperature Effect On Gas Turbine Compressor Perfornance

... the gas turbine has a second turbine acting as an air compressor mounted on the same ...air turbine (compressor) draws in air, compresses it and feeds it at high pressure into the ...

9

Design   Study on Gas Turbine High Temperature Reactor (GTHTR300)

Design Study on Gas Turbine High Temperature Reactor (GTHTR300)

... In parallel to the development and successful operation of the HTTR, JAERI has undertaken the study of an original design concept of gas turbine high temperature reactor, the G[r] ...

6

Enhancing power output and profitability through energy-efficiency techniques and advanced materials in today’s industrial gas turbines

Enhancing power output and profitability through energy-efficiency techniques and advanced materials in today’s industrial gas turbines

... the high-temperature creep resistance is the primary requirement in superalloys for hotter GT ...of gas turbines (Huda 2007, ...industrial gas-turbine ...the temperature capacity ...

12

Gas Turbine and Gas Cycle Plants

Gas Turbine and Gas Cycle Plants

... a gas cycle containing a mixture of liquid natrium and kalium NaK78 (Figure ...very high efficiency and excel­ lent adaptability to momentary need for ...a gas turbine with electrical power of ...

5

Emissions from a Gas Turbine Power Plant by using a Molten Carbonate Fuel Cell

Emissions from a Gas Turbine Power Plant by using a Molten Carbonate Fuel Cell

... are high temperature fuel cells ...of high temperature fuel cell with gas turbine gives a hybrid system with potentialy ultra-high efficiency ...

6

Thermodynamic Analysis of Gas Turbine Trigeneration System

Thermodynamic Analysis of Gas Turbine Trigeneration System

... with gas turbines as prime mover can improve energy utilization efficiency significantly because of their potential of high economic and energy saving ...conventional gas turbine cycle for the ...

5

INVESTIGATION ON STRUCTURAL STABILITY OF CMSX-4 AND RENE 77 MADE SHOWERHEAD COOLING DESIGNED GAS TURBINE GUIDE VANES.

INVESTIGATION ON STRUCTURAL STABILITY OF CMSX-4 AND RENE 77 MADE SHOWERHEAD COOLING DESIGNED GAS TURBINE GUIDE VANES.

... elevated temperature. Its significant properties at high temperatures includes impact strength, rupture strength, and fracture ...of gas turbine and reduced weight ...

6

Show all 10000 documents...

Related subjects