• No results found

11 Conclusion

In document Rajesh (Page 108-110)

In this paper, a high increase dc-dc device supported the CW voltage multiplier factor while not a line- or high-frequency step up electrical device has been given to get a high voltage gain. Since the voltage stress on the active switches, diodes, and capacitors isn’t laid low with the number of cascaded stages, power components with a similar voltage rating will be selected. The techniques gate operation are thought-about during this paper. The planned management strategy employs 2 freelance fre- quencies, one in all that operates at high frequency to attenuate the scale of the electrical device whereas the opposite one operates at a comparatively low frequency in step with the specified output voltage ripple. Finally, the simulation and experimental results tested the valid- ity of the theoretical analysis and also the practicable- ness of the planned device. In future work, the influence of loading on the output voltage of the planned device is Derived for finishing the steady-state analysis.

References

[1] X. Hu, C. Gong, ”A High Gain Input-Parallel Output-Series DC/DC Converter with Dual Coupled Inductors,” IEEE Trans. Power Electron., vo1.30, no.3, pp.1306, 1317, March 2015.

[2] M. Siva Ramkumar, M. Sivaram Krishnan “Power Management of a Hybrid Solar- Wind Energy Sys- tem” International Journal of Engineering Research & Technology vol. 3(2) pp.1988–1992, 2014.

[3] M. Siva Ramkumar, M. Sivaram Krishnan, A. Amudha. “Resonant Power Converter Using GA For PV Applications” International Journal Of Electron- ics, Electrical And Computational System,6 (9) pp 239–245, 2017.

[4] M. Sivaram Krishnan, M. Siva Ramkumar, A. Amudha. “Frequency Deviation Control In Hybrid Renewable Energy System Using Fc-Uc “ in Interna- tional Journal of Control Theory and Applications, 10 (2) pp 333–344, 2017.

[5] M Siva RamKumar, Dr. A Amudha, R. Rajeev “Op- timization For A Novel Single Switch Resonant Power Converter Using Ga To Improve Mppt Efficiency Of Pv Applications” in International Journal of Applied Engineering Research, 11(9) pp 6485–6488, 2016. [6] M. Sivaram Krishnan. M. Siva Ramkumar, M. Sown-

thara “Power Management Of Hybrid Renewable En- ergy System By Frequency Deviation Control” in ‘In- ternational Journal of Innovative Research in Sci- ence, Engineering and Technology’ on 3 (3) pp 763– 769,2014.

[7] M. Siva Ramkumar “Unmanned Automated Railway Level Crossing System Using Zigbee” in International Journal of Electronics Engineering Research, 9 (9) pp 1361–1371, 2017

[8] M. Siva Ramkumar, M. Sivaram Krishnan “Hybrid Solar-Wind Energy System” in ‘International Journal of Advance Research in Computer Science and Man- agement Studies’ 2(2),2014

[9] Emayavaramban. G, Amudha. A, ‘sEMG Based Clas- sification of Hand Gestures using Artificial Neural Networks’, Indian Journal of Science and Technology, Vol.9 (35), pp.1–10, September 2016.

[10] D. Kavitha, Dr. C. Vivekanandan, “An Adjustable Speed PFC Buck- boost Converter Fed Sensorless BLDC Motor” in International Journal of Applied Engineering Research, ISSN 0973–4562 Vol. 10 No.20 (2015), pg. 17749–17754.

[11] D. Manoharan, Dr. A. Amudha. “Condition Moni- toring And Life Extension Of EHV Transformer” In- ternational Journal of Applied Engineering Research, ISSN 0973–4562 Vol. 10 No.55 (2015)

[12] D. Manoharan, Dr. A. Amudha. A Novel Optimiza- tion of stresses acting and failure rates with power transformer International Journal of Applied Engi- neering Research ISSN 0973–4562 Volume 10, Number 3 (2015) pp. 6233–6240.

[13] Dr. A. Amudha. “Enhancement of Available Trans- fer Capability using FACTS controller” in Interna- tional journal of Applied Mechanics and Materials, Vol. 573, pp 340–345

[14] K. Balachander, Dr. P. Vijayakumar, “Modeling, Simulation and Optimization of Hybrid Renewable Energy Systems in Technical, Environmental and Eco- nomical aspects (Case Study: Pichanur Village, Coim- batore, India)” International Journal of Applied En- vironmental Sciences”, Volume - 08, No.16 (2013), pp.2035–2042.

[15] K. Balachander, Dr. P. Vijayakumar, “Modeling, Simulation and Optimization of Hybrid Renewable Power System for Daily Load demand of Metropoli- tan Cities in India ”, American Journal of Engineering Research, Volume - 02, Issue-11(2013), pp-174- 184. [16] K. Balachander, Dr. P. Vijayakumar, “Optimiza-

tion of Cost of Energy of Real Time Renewable En- ergy System Feeding Commercial Load, Case Study: A Textile Showroom in Coimbatore, India”, Life Sci- ence Journal, (2013), Volume. 10, Issue. 7s, pp. 839– 847.

[17] K. Balachander, Dr. P. Vijayakumar, “Renewable Energy System Optimization of Two Different Loca- tions” CiiT International Journal of Automation and Autonomous System [Print: ISSN 0974 – 9659 & Online: ISSN 0974 – 9551(IF: 0.134)] Issue: April 2013, DOI: AA042013001.

[18] K. Balachander, Dr. Vijayakumar Ponnusamy, ‘Eco- nomic Analysis, Modeling and Simulation of Photo- voltaic Fuel Cell Hybrid Renewable Electric System for Smart Grid Distributed Generation System’ Inter- national Journal of Mechanical Engineering and Tech- nology, Volume 3, Issue 1, January- April (2012), pp. 179–186.

[19] K. Balachander, Dr. Vijayakumar Ponnusamy, ‘Op- timization, Simulation and Modeling of Renewable Electric Energy System with HOMER’ International Journal of Applied Engineering Research’, Volume 7, Number 3 (2012), pp. 247–256.

[20] K. Balachander, S. Kuppusamy, Dr. Vijayaku- mar Ponnusamy, ‘Modeling and Simulation of VSD- FIG and PMSG Wind Turbine System’, International Journal of Electrical Engineering, Volume 5, Number 2 (2012), pp. 111–118.

[21] M. Sivaram Krishnan, A. Amudha, M. Siva Ramkumar, ‘Execution Examination Of Three Phase Ac To Three Phase Ac Matrix Converter Using Distinctive Transporter Based Exchanging Algorithms’, International journal of Pure and Applied Mathimatics,118 (11), pp 609–617,2018 DOI:10.12732/ijpam.v118i11.79

[22] S. Motapon, L. Dessaint, K. AI-Haddad, ”A Comparative Study of Energy Management Schemes for a Fuel-Cell Hybrid Emergency Power System of More-Electric Aircraft, ” IEEE Trans. Ind. Electron., vo1.61, no.3, pp.1320,1334, March 2014.

DESIGN AND IMPLEMENTATION OF SERIES Z-SOURCE

In document Rajesh (Page 108-110)