implant surface
Effectiveness of implant surface debridement using particle beams at differing air pressures
... the surface at com- pressed air pressures of 25, 35, 45, or 55 pounds per square inch ...the implant surface, as recommended by the manufac- turer, the same manner as it would be used clinically, ...
6
Implant Surface Modification and Osseo Integr...
... Dental implant success has evolved from modest results of the middle of the past ...titanium surface. Bone formation at the endosseous implant surface was considered a positive outcome that ...
6
Adhesion of osteoblasts to a nanorough titanium implant surface
... While numerous experimental studies have shown that the nanorough regions of a titanium surface implant facilitate the binding of osteoblast cells, the underlying mechanisms are not fully understood. Here ...
16
Sex dependent regulation of osteoblast response to implant surface properties by systemic hormones
... The present study is limited because it was conducted in vitro and used rat cells. Thus, the data cannot be cor- related directly to human cells or to in vivo responses in humans. Here, all of the rats were of the same ...
11
Bioactive–hybrid–zirconia implant surface for enhancing osseointegration: an in vivo study
... inert surface which requires additional surface treatments in order to enhance ...nano-porous surface infiltrated with a bioactive material may enhance osseointegration of zirconia ...nano-porous ...
7
Simulation of the mechanical interlocking capacity of a rough bone implant surface during healing
... In this simulation the ultimate strain was used as a failure criterion based on available ultimate strain data. Principal strain failure can be used to represent brittle or ductile failure in materials [29]. Other ...
13
Osteoconductivity Control Based on the Chemical Properties of the Implant Surface
... Ti implant surface by UV light irradiation [30], and have already commercialized a device that can be used in the operating ...Ti implant surface, and did not examine the effect of the ...
15
Bone Morphogenetic Protein Coating on Titanium Implant Surface: a Systematic Review
... The result revealed that adsorption amount of rhBMP-2 on AO treated implants was lowest while adsorption amount with AA treated implants was highest. PT group had the median adsorption amounts. They found also that ...
12
Dental implant bioactive surface modifications and their effects on osseointegration: a review
... different implant surface modifications and their effect on implant osseointegration at 2, 4, and 8 weeks after ...different implant surfaces: (1) sandblasted and acid-etched titanium (Ti), ...
14
8-14-2013 12:00 AM The Effect of Stem Surface Treatment and Substrate Material on Joint Replacement Stability: An In-Vitro Investigation into the Stem-Cement Interface Mechanics under Various Loading Modes
... the implant surface is introduced into the plasma gas stream using a carrier gas, and the mixture is accelerated at high speeds onto the stem substrate material (Figure ...stem surface and bone ...
266
Recent advances in dental implants
... on implant surfaces, immediate loading versus conventional loading, short implants, sinus lifting, and custom implants using three-dimensional ...the implant surface modifications showed good ...
10
Bone integration capability of nanopolymorphic crystalline hydroxyapatite coated on titanium implants
... and implant–tissue interfacial analyses were in ...sandblasted surface was not associated with bone after the push-in test, implying that either there was no bone formation in this area or that newly formed ...
15
The influence of surface texture and wettability on initial bacterial adhesion on titanium and zirconium oxide dental implants
... Besides surface roughness and morphology, the hydro- phobicity and surface free energy (SFE) of an implant surface are known to influence bacterial adhesion [42, ...the surface free en- ...
11
Open Journal Systems
... of implant placement is prepared, a lesion is made and the phase of bone-implant healing is performed by a method similar to healing in the case of a broken bone, since both operations start with ...
5
Reduced bacterial growth and increased osteoblast proliferation on titanium with a nanophase TiO<sub>2</sub> surface treatment
... to implant surfaces. Technology that can create nanoscale surface roughness, similar to that presented here, can reduce bacterial colonization and, thus, may have a synergistic effect in treating ...the ...
7
Bioactive Coating on Titanium Dental Implants for
... dental implant surface was modified by bioactive vitamin D3 coating prepared by self-assembly.. 61.[r] ...
15
The synergistic effect of TiO<sub>2</sub> nanoporous modification and platelet-rich plasma treatment on titanium-implant stability in ovariectomized rats
... After surface morphology, topographical structure, and chemical changes of implant surface had been detected by scan- ning electron microscopy (SEM), atomic force microscopy, contact-angle ...
15
CHARACTERIZATION AND ANTIBACTERIAL ACTIVITY OF THE ESSENTIAL OIL FROM THYMUS VULGARIS CULTIVATED IN MOROCCO (TAOUNATE) AGAINST TEN BACTERIA
... Development of resistance for many bacteria to antibiotics and detergents used in various procedures, including, sterilization, disinfection equipment in food, medical and food preservation, [1] and nosocomial infections ...
12
Development of Niobium Oxide Coatings on Sand Blasted Titanium Alloy Dental Implants
... Early implant failure will likely result from either of the first two outcomes, in which either an in- flammatory response is triggered or a fibrous capsule of connective tissue forms around the ...the ...
5
Effect of implant design and surface modification on Osseointegration
... an implant system that will promote rapid healing and successful osseointegration of the endosseous implants into the jaw ...the implant surface is ...the implant surface, strontium ...
10