inductively-coupled power system
Batteryless Power Supply and Telemetry System for Biomedical Implantable Devices Using CMOS Circuits
... (RF) inductively coupled link is a commonly used technique to deliver power to implanted ...transmits power to the implanted part at field levels below government safety standards (10 mW/cm 2 ...
8
Finite Element Assisted Study of Magnetic Configurations of Flat Pickups for Inductively Coupled Power Transfer Systems
... As the main goal is to determine the pickup’s response to the misalignment problem, the proposed models were analysed in both unipolar and bipolar configurations. The pickups were moved from their central position along ...
5
Inductively Coupled Plasma Etching of III-N Semiconductors
... etching system, the samples were sequentially dipped into acetone, methanol, and 10% HCl acid for 10 minutes each to degrease and remove the carbon ...ICP power was varied from 300 to 800 ...
159
Langmuir probe measurement in a radio frequency inductively coupled argon plasma
... diagnostic system is constructed to measure the plasma properties in a radio frequency (RF) inductively coupled Argon ...RF inductively coupled Argon plasma are measured in the pressure ...
6
Nickel coatings by Inductively Coupled Impulse Sputtering (ICIS)
... [8]. Inductively Coupled Impulse Sputtering (ICIS) is a new development which aims to solve the previously mentioned issues by eliminating the need for a ...high power pulsed glow discharge was ...
31
Investigations and system design for simultaneous energy and data transmission through inductively coupled resonances
... Wireless Power Transfer (WPT) with simultane- ous data transmission through coupled magnetic resonators is investigated in this ...this system is dedicated to serve as a basis for applications in the ...
10
MODELING AND MEASURING THE CHARACTERISTICS OF AN INDUCTIVELY COUPLED PLASMA ANTENNA FOR A MICRO-PROPULSION SYSTEM
... Repeatability was verified, as shown in Figure 13, by running two tests for the same antenna and frequency and taking the difference of the power results. These two tests were separated in time by running tests of ...
92
Magnetic design considerations to improve nonlinear characteristics of inductively coupled power transfer systems
... Purpose – This study seeks to apply finite element analysis to study the proximity effect in a multi-pickup inductively coupled power transfer system, quantify the effect and propose improved ...
9
Fundamental studies of the analytical applications of an inductively coupled plasma source
... higher power was optimal for the nitrogen system (i.e. the LTE system) and hence as the Cr matrix thermalised the all argon system higher powers were then necessary for optimal ...
232
Design of Flexible Coils in an Inductively-Coupled Telemetry System for the Epiretinal Prosthesis.
... Medical prosthetics has moved from providing a simple prosthetic as replacement for external organs like limbs to sophisticated electronic devices which can help deaf people hear, blind see. Technology of implantable ...
132
Field sampling and microcolumn preconcentration techniques in inductively coupled plasma spectrometry
... it is necessary to preconcentrate them at acidic pH. Initially compromise optimal conditions were investigated for the ICP-ES. A 16 mm observation height and 1.3-1.4 kW incident power were selected for the 5 ...
226
Investigation of a Magnetically Enhanced Inductively Coupled Negative Ion Plasma Source
... and power transfer ...entire system was moved from a conductive bench top to a wooden table to assist in ...UHF power cable which is attached to the matching ...the system and connected to a ...
225
Inductively Coupled Interconnect for Chip to Chip Communication over Transmission Line
... minimize power for high speed data transmission over other conventional ...Using Inductively coupled interconnect blocks the unwanted DC power being ...The power bandwidth of this work ...
80
Review of procedures involving separation and Solid Phase Extraction for the determination of cadmium using spectrometric techniques
... For the analysis of cadmium, the toxicity of spectroscopic methods is increasing because the measurement of the low level for detection of this element is done in various samples. This review studies the methods of ...
18
Plasma analysis of Inductively Coupled Impulse Sputtering of Cu, Ti and Ni
... Inductively coupled impulse sputtering (ICIS) is a new development in the field of highly ionised pulsed PVD ...RF power, with a duty cycle of ...RF power was varied from 1000 – 4000 ...
14
Development of Wireless Transmission between Inductively Coupled Layers in Smart Clothing.
... wearable system was understood as the use of a piece of clothing to support technological devices on a body, which is much different from the concept of wearability from a typical clothing ...
135
Theoretical analysis of the efficiency of a V2G wireless charger for Electric Vehicles
... Abstract —V2G (Vehicle-to-grid) technology will report im- portant benefits for the operation and safety of the grid. In order to facilitate the expansion of the V2G technology in a future, it is recommended to offer the ...
6
Volume 4 | Issue 4 - 2014
... The Spirullina powder was digested using microwave digestor (Model: ETHOS One, Make – Millestone). A microwave assisted digestion procedure was carried out, in order to achieve a shorter digestion time. Weighed ...
5
Fundamental Studies of Femtosecond Laser Interactions with Solids and Their Applications to Laser Ablation Inductively Coupled Plasma Mass Spectrometry for Environmental Analysis
... with inductively coupled plasma mass spectrometry (ICP-MS) is a powerful analytical technique that has been applied to multi- element analysis of trace, minor and major elements of solids in many areas of ...
196
Direct Determination of Rare Earth Elements by ICP-MS after Fluoride Fusion –Application to Bauxite
... by inductively coupled plasma mass spectrometry (ICP-MS), after complete dissolution of the samples by fusion with a mixture of sodium flouride- potassium bi-fluoride salts (KHF 2 -NaF) in 3:1 ...
10