ion exchanger
STUDY OF EFFECT OF TEMPERATURE ON THE PROPERTIES AND STRUCTURE OF ZIRCONIUM PHOSPHOBORATE ION-EXCHANGER
... Its ion exchange capacity for Na + and K + was found to be ...the ion exchange capacity and crystallinity of the ion exchanger decreases with increase in ...
7
Hydrothermal Synthesis and Characterization of a Novel Zirconium Oxide and Its Application as an Ion Exchanger
... of ion exchanger with 10 ml of metal ion ...metal ion concentrations were determined using the supernatant liquid by atomic absorption ...
6
Zirconium (IV) phosphate/poly(gelatin-cl-alginate) Nanocomposite as Ion Exchanger and Al3+ potentiometric Sensor
... nanocomposite ion exchanger. Sample S-3 showed highest ion exchange capacity (IEC) of ...The ion exchange capacity of nanocomposites was increased due to incorporation of organic material with ...
19
Evaluation Of The Degradation Power Of Polyaniline Encapsulated Titanium Cerium Molybdate Nanocomposite Ion Exchanger For The Removal Of Methyl Red Dye From Aqueous Solution
... of ion exchanger due to their unusual properties by the combination of both organic and inorganic characteristics within a single molecular ...inorganic ion-exchangers as they overcome two major ...
16
Removal of Cesium on Polyaniline Titanotungstate as Composite Ion Exchanger
... improved ion exchange properties and selective ion exchangers for the treatment of nuclear ...inorganic ion-exchanger, which pro- vided high selective andseparation for 134 Cs from metal ...
14
Kinetic Studies of the Exchange Adsorption of Ions from Acid Solutions on an Inorganic Ion Exchanger EUR 2748
... column height, cm ratio of the sorbed quantity of ions per gram of ion exchanger to the concentration of the same ions per ml of solution,ml/g number of effective plates in column operat[r] ...
34
STUDY ON THE COMPLEX FORMATION BETWEEN N-PROPYLSALICYLIDENE BASED ON SILICA AS ION EXCHANGER AND SOME TRANSITION METAL IONS
... the ion exchanger IE shows that the ion exchanger is thermally degraded in three ...the ion exchanger and its com- plexes with Cr(III) and Hg(II) are shown in Figure ...
7
Synthesis, Properties and Analytical Applications of Titanium (IV) Phosphosulphosalicylate – A New Hybrid Inorganic-Organic Ion-Exchanger
... organic ion exchangers, a stable material with good chromatographic properties, a new inorganic-organic ion exchanger Titanium (IV) phosphosulphosalicylate(TiPSS) was ...detailed ion exchange ...
8
Quantitative analysis of resting membrane electrogenesis in insect (diptera) skeletal muscle I Intracellular K+, Na+ and Cl activities, measured using liquid ion exchanger and neutral ion carrier microelectrodes
... Frequency histograms illustrating: A the distributions of intracellular K+ activity aKj values measured using NIC-type K+-sensitive microelectrodes; and B a comparison of aKj values obta[r] ...
16
A New Potentiometric Sensor for Determination of Pethidine hydrochloride in Ampoules and Urine
... active ion exchanger complex might be a useful analyti- cal tool and interesting alternative for the determination of PD ions in pharmaceutical preparations and urine ...
10
Synthesis and in Silico Analysis of Novel 1,2,4-Triazolylamides as Potential Antifungals
... prepared material was done by different parameters like FTIR, TGA curve, X-ray diffraction, and other studies include pH titration, Kd values, thermal & chemical stabilities. The synthesized ion- ...
8
Methods and costs of preventing cadmium emissions. EIR 6636 EN Vol. III. Environment and quality of life
... The most common methods of removing cadmium from waste water are neutralisation precipitation, carbonate precipitation, sulphide precipitation, and ion exchanger + neutralisation precipi[r] ...
29
Contact Angle Profiles for Droplets on Omniphilic Surfaces in the Presence of Tangential Forces
... metal ion adsorption experiments, the estimation of the appropriate pH value for the adsorption of uranyl ions on the fabricated NaZrP-CEX ion-exchanger was carried out as follows: a 20 mg of ...
18
An investigation of cellulose ion exchangers : a thesis presented in partial fulfilment of the requirements for the degree of Master of Science in Chemistry at Massey University, New Zealand
... If the matrix carries positive groups the counter ions will be negative, Such an ion exchanger will exchange negative ions and is therefore termed an anion exchanger... In the same way, [r] ...
19
Short Communication: A simple method for Construction of Flexible, Subminiature Ion selective Electrodes
... Ion-selective microelectrodes ISMEs can be constructed by introducing a short column of a neutral carrier or ion-exchanger cocktail into the tip of a glass micropipette.. The inner surfa[r] ...
8
Characterization of a New Zn2+-Selective Electrode Based on Schiff-base as Ionophore
... The compositions of membranes have great effect on the characteristics of ISEs [15]. Therefore, membranes with different compositions have been prepared and their potentiometric response characteristics were evaluated, ...
8
Gelatin-zirconium Dioxide Nanocomposite as a Ni (II) Selective Potentiometric Sensor: Heavy Metal Separation and Photocatalysis
... (GT/ZONC) ion exchanger by sol-gel ...the ion-exchange capabilities of the material different physicochemical properties such as effect of eluent concentration, elution behaviour, thermal stability, ...
18
Synthesis, Characterization and Ion Exchange Properties of a three Component Cation Exchanger [Stannic(IV) iodosilicate]: Separation of Cd(II) from Mg(II), Ni(II) and Zn(II)
... an ion exchanger is brought in to contact with an electrolyte solution by shaking a given quantity of exchanger with the solution, exchange of ions take place until equilibrium is ...the ...
10
Investigation of Effective Parameters on a Thermal Load in a Thermo-Acoustic Refrigerator
... heat exchanger, and on the other hand, the gas element temperature should be lower than the temperature of the heat ...heat exchanger is ...heat exchanger until heat transfer between the heat ...
6
Heat Transfer Enhancement of Shell and Tube Heat Exchanger
... By fouling we mean any accumulation of unwanted material on surfaces of a process equipment hinders the desired operation. This issue is particularly common in food industry, chemical industry and energy industry ...
12