• No results found

Material and measurement

Means and method for ultrasonic measurement of material properties

Means and method for ultrasonic measurement of material properties

... ultrasonic measurement of material properties Abstract The system for field measurement of texture, stress and related material properties such as formability parameters using ultrasonic ...

15

Thermoelectric Material Property Measurement for Flexible Films

Thermoelectric Material Property Measurement for Flexible Films

... a material with a lower thermal conductivity and comparable electrical conductivity may further reduce heat conduction ...between measurement set-ups are not ideal and may alter the final ...

84

IN-SITU MEASUREMENT OF MATERIAL PROPERTIES OF GYPSUM BOARD WALLS

IN-SITU MEASUREMENT OF MATERIAL PROPERTIES OF GYPSUM BOARD WALLS

... measured material properties as well as a to determine the material properties of their structural members, like studs and gypsum ...the measurement of the stiffness properties are pre- sented. Two ...

8

SEMIAUTOMATIC SURFACE REFLECTANCE MEASUREMENT FOR MONITORING OF MATERIAL WEATHERING

SEMIAUTOMATIC SURFACE REFLECTANCE MEASUREMENT FOR MONITORING OF MATERIAL WEATHERING

... REFLECTANCE MEASUREMENT FOR MONITORING OF MATERIAL WEATHERING ...for measurement of surface reflectance in dependence on incidence angle and reflectance ...This measurement enables us to ...

5

CAVITY PERTURBATION MEASUREMENT OF COMPLEX  PERMITTIVITY OF DIELCTRIC MATERIAL AT MICROWAVE

CAVITY PERTURBATION MEASUREMENT OF COMPLEX PERMITTIVITY OF DIELCTRIC MATERIAL AT MICROWAVE

... sample material placed at its center performs dielectric properties ...The material under test is fabricated in the form of a cylinder and inserted into the center of the ...The measurement setup ...

5

Planar Microwave Sensors for Accurate Measurement of Material Characterization: A Review

Planar Microwave Sensors for Accurate Measurement of Material Characterization: A Review

... overlay material independent effective permittivity of biological ...for material characteristics compared to existing ...solid measurement is shown in Table ...

11

Development of an indentation method for material surface mechanical properties measurement

Development of an indentation method for material surface mechanical properties measurement

... the measurement of Young’s modulus and pointed out that when pileup is large, the areas deduced from analysis of the load displacement curves underestimates the true contact areas by as much as ...the ...

157

Tailored graphitized soot as reference material for EC/OC measurement validation

Tailored graphitized soot as reference material for EC/OC measurement validation

... of measurement methods and comparison of data sets taken at multiple locations over different periods of ...organic material with dif- ferent molecular structures, similar to those found in the nat- ural ...

10

Pulsed magneto acoustic emission sensor array for stress measurement and material ’characterisation

Pulsed magneto acoustic emission sensor array for stress measurement and material ’characterisation

... various material properties, such as grain size and rolling ...differing measurement depths and are sensitive to differing stress ranges, so by combining of the two inspection methods using data fusion ...

7

Material-Loaded High Q-Factor Slot Resonator and Measurement of Relative Permittivity

Material-Loaded High Q-Factor Slot Resonator and Measurement of Relative Permittivity

... whereas the measured one is 3.34. The uncertainty of measurement of the dielectric constant is only 0.04 which gives an error of only 1.18%. It is in same range as provided by other complex measurement ...

10

Thermal conductivity measurement in clay dominant consolidated material by Transient Hot-Wire method.

Thermal conductivity measurement in clay dominant consolidated material by Transient Hot-Wire method.

... conductivity measurement by the Hot Wire Method, already validated in fluids appears to be well adapted to thermal conductivity measurement in solid and clay dominant ...the material and (2) ...

8

Comparison of two possibilities for mowing machine material feed rate measurement under laboratory conditions

Comparison of two possibilities for mowing machine material feed rate measurement under laboratory conditions

... the measurement with each different material. Material was transported into the mowing machine for approximately five seconds for each measurement using a conveyer ...single ...

6

FISCHERSCOPE MMS PC2 The Universal Multi-Measuring System for Coating Thickness Measurement and Material Testing

FISCHERSCOPE MMS PC2 The Universal Multi-Measuring System for Coating Thickness Measurement and Material Testing

... Beta transmission method Standard: DIN EN ISO 3543, ASTM B567a Functional principle Analogous to the beta-backscatter method, an isotope source emits beta radiation (electrons) that are detected by the Geiger-Müller ...

16

Estimation of Material Flow in Stir Zone during Friction Stir Welding by Distribution Measurement of Si Particles

Estimation of Material Flow in Stir Zone during Friction Stir Welding by Distribution Measurement of Si Particles

... the material flow phenomena has not been achieved, because different explanations are still being made by different ...the material flow in the stir zone by analyzing the distribution measurement of the ...

9

The effect of surface texture and carbonaceous material composition on 
		the dielectric properties measurement of coconut shell polymer (CSP) 
		composites

The effect of surface texture and carbonaceous material composition on the dielectric properties measurement of coconut shell polymer (CSP) composites

... absorbing material represent the ability of the material to absorb microwave signals and dissipated those signals as ...absorbing material due to their excellent dielectric ...carbonaceous ...

10

[DRAFT] EDUCATIONAL MATERIAL ON FAIR VALUE MEASUREMENT

[DRAFT] EDUCATIONAL MATERIAL ON FAIR VALUE MEASUREMENT

... The trading yield of six per cent is considered to be an appropriate estimate of the cost of debt to Entity R at the measurement date. Cost of debt estimated by reference to an actual or synthetic credit rating ...

68

Characterization and Measurement of Corn Stover Material Properties

Characterization and Measurement of Corn Stover Material Properties

... its material properties, and sampling techniques to measure those properties, are not well ...stover’s material properties, and to establish appropriate sampling techniques for these ...allow ...

124

(Methods, Material, Manpower, Measurement, Machines, Mother Nature,Management)

(Methods, Material, Manpower, Measurement, Machines, Mother Nature,Management)

... starting time for invoiced services, response time starting time for invoiced services, response time.. requirement is handed over till the problem is solved requirement is handed over[r] ...
Research for Fast Neutron Absorbed by Material for Fast Neutron Fluence Measurement

Research for Fast Neutron Absorbed by Material for Fast Neutron Fluence Measurement

... all elements in covers and subtracted by iron, the new results is smaller 1.5% and 2.6% than olds, respectively. The old measurements are creditability and safety..[r] ...

20

Open Celled Material Structural Properties Measurement: From Morphology To Transport Properties

Open Celled Material Structural Properties Measurement: From Morphology To Transport Properties

... (Received February 28, 2006; Accepted May 29, 2006; Published September 15, 2006) Keywords: Metallic foam, measurement, structural characterizations, heat transfer properties 1. Introduction Metal foams are a ...

8

Show all 10000 documents...

Related subjects