• No results found

Q-switched laser beam

Beam spot of Q-switched ND: YAG laser based on raster graphic

Beam spot of Q-switched ND: YAG laser based on raster graphic

... of beam produced by a Q-switched Nd:YAG laser was ...the beam spots were made via a scanner and analyze using raster graphic or bitmap from a Matrox Inspector version ...the beam ...

5

A new laser method for cleaning micropalaeontological specimens

A new laser method for cleaning micropalaeontological specimens

... the beam is highly coherent and it can be focused to di ff erent spot ...The laser most commonly used to clean museum objects at present is the Q-switched Nd: YAG (neo- dymium yttrium aluminium ...

5

Ytterbium doped and co-doped Q-switched fiber lasers utilizing passive saturable absorbers

Ytterbium doped and co-doped Q-switched fiber lasers utilizing passive saturable absorbers

... solid-state laser systems is the fiber laser with some advantages like compact size, high electrical efficiency, superior beam quality and reliability, great output power, lower maintenance, low ...

34

Tunable Yb:KGW laser, CW or Q-switched, enabled by dual-axis tilt of a MOEMS mirror : KGW laser, CW or Q-switched, enabled by dual-axis tilt of a MOEMS mirror

Tunable Yb:KGW laser, CW or Q-switched, enabled by dual-axis tilt of a MOEMS mirror : KGW laser, CW or Q-switched, enabled by dual-axis tilt of a MOEMS mirror

... the laser conversion ...the laser beam spot shifting across the MOEMS mirror ...that laser wavelengths between 978 nm and 1085 nm occurred fully within the confines of the MOEMS mirror ...

9

Rotating-Mirror Q-Switched Er:YAG Laser for Optodynamic Studies

Rotating-Mirror Q-Switched Er:YAG Laser for Optodynamic Studies

... The laser-beam spatial profile was measured at a position 341 mm from the laser- output coupler. Due to a lack of equipment for better measurements, a technique of measuring the transmission through ...

8

The surface roughness of copper when focused with a Q-switched Nd:YAG laser analyzed using AFM

The surface roughness of copper when focused with a Q-switched Nd:YAG laser analyzed using AFM

... A Q-switched Nd: Yag Laser was focused to optimize the copper surface area beam size at different energy ...the laser is focused with different level energy, a different frequencies and ...

15

Revealing the nature of morphological changes in carbon nanotube polymer saturable absorber under high power laser irradiation

Revealing the nature of morphological changes in carbon nanotube polymer saturable absorber under high power laser irradiation

... of laser radiation, the thermal field, and stress field configuration near high concentration and big bundles of CNT in the PVA ...available laser powers and ...low laser power and on a the short ...

10

Thermal distribution and response in Q-switched ruby laser treatment for oculodermal melanosis (Nevus of Ota)

Thermal distribution and response in Q-switched ruby laser treatment for oculodermal melanosis (Nevus of Ota)

... was delivered to the skin through an optical fiber and lens that focused the beam onto a 3 mm spot on the lesion. The untreated area was assigned as a control. Sites were assigned to one-treatment regimens by ...

8

Alloying of aluminium surface with Q-switched Nd:YAG laser

Alloying of aluminium surface with Q-switched Nd:YAG laser

... Usually, laser material processing involve a thermal process where the absorption of large number of photons heats the metallic material to achieve the surface ...that laser surface treatment and coating ...

30

Q-Switched Ruby Laser Treatment of Tattoos and Benign Pigmented Skin Lesions: A Critical Review

Q-Switched Ruby Laser Treatment of Tattoos and Benign Pigmented Skin Lesions: A Critical Review

... patient's wishes with the Q-switched ruby laser (Fig 2). As with professional tattoos, more than five treatment sessions are usually needed. To protect the eves from the laser beam a ...

14

Q-switched laser as a source for Thomson scattering from a hollow cathode arc.

Q-switched laser as a source for Thomson scattering from a hollow cathode arc.

... The diffraction loss for large L has been ex­ amined^ under conditions that assume a far field effect characterized by initial lasing occuring only within a filament f of the rod1s cross section. The condition for a far ...

44

Raman amplification and pulsed lasing in cladding pumped germanosilicate fiber

Raman amplification and pulsed lasing in cladding pumped germanosilicate fiber

... The signal pulse is reflected back through the cavity all the way to the pump launch end of the DCRF. There, 4% is reflected again from the perpendicularly cleaved fiber end. At the same time, a new pump pulse is ...

6

The Q Switched Nd: YAG Laser in Tattoo Removal and the Effect of Lymphatic Elimination: An Experimental Study in Rabbits

The Q Switched Nd: YAG Laser in Tattoo Removal and the Effect of Lymphatic Elimination: An Experimental Study in Rabbits

... and laser assited methods. Invention of the Q-switch mode, advanced the laser method, to be one of the most effective methods of tattoo ...of Q-switched Nd-YAG laser (532nm, ...

7

Simulation of Diode Pumped Q Switched Nd:YAG Laser Generating Eye Safe Signal in IOPO Environment

Simulation of Diode Pumped Q Switched Nd:YAG Laser Generating Eye Safe Signal in IOPO Environment

... pulsed laser. Another impor- tant simulated parameter is secondary pump beam quality as it determines the signal’s beam ...pump beam waist and simulate the signal beam spot size and ...

6

Q-switched Nd:YAG laser induced photodisruption in an eye model

Q-switched Nd:YAG laser induced photodisruption in an eye model

... of laser radiation make it such a useful tool to be applied for medical ...The laser beam can be controlled, focused and manipulated to give precise, specific and localized effects in tissues ...

22

Diode laser pumped, high repetition rate, Nd:YLF laser and its frequency conversion

Diode laser pumped, high repetition rate, Nd:YLF laser and its frequency conversion

... So far only backward scattering could be observ ed as there was no freq uency doubled c omp onent at the entrance s urface of the KTP crystal. In order to check the nature of the scattering effect at the beginning of ...

278

Generation of Q-switched thulium-doped fiber laser (TDFL) using differentsaturable absorbers

Generation of Q-switched thulium-doped fiber laser (TDFL) using differentsaturable absorbers

... and Q-switched TDFL by using NG:PEO, NG:PVA, SWCNT, and HiPCOCNT as the saturable absorbers ...CW laser emission is at 1973 nm ...the Q-switching operation has also made the wavelength shifted ...

7

Status Of Laser Technology In India

Status Of Laser Technology In India

... include laser technology, non-linear optics, laser-matter Interaction, fiber optics, optical fiber sensors, optical neural network, photonic materials development, and optoelectronic ...and laser ...

5

C Band Q Switched Fiber Laser Using Titanium Dioxide (TiO 2) As Saturable Absorber

C Band Q Switched Fiber Laser Using Titanium Dioxide (TiO 2) As Saturable Absorber

... ferrules. Q-switched pulsing starts with the assistance of physical disturbance of the laser cavity (by lightly tapping the cavity to induce instability) at 140 mW and lasts until 240 ...The ...

8

Distributed optical fibre sensing at 1 65µm using a Q switched fibre laser

Distributed optical fibre sensing at 1 65µm using a Q switched fibre laser

... It is becoming increasingly vital to monitor telecommunication links during operation and installation process. By using a high peak power source and the optical time domain reflectometry (OTDR) technique operating at ...

8

Show all 10000 documents...

Related subjects