• No results found

Ti-Au-C:B

Effect of Annealing Temperature on Microstructure and Superelastic Properties of Ti Au Cr Zr Alloy

Effect of Annealing Temperature on Microstructure and Superelastic Properties of Ti Au Cr Zr Alloy

... of Au, respectively. Au-rich precipitates with an averaged diameter of ...3; Au concentration is 18 mol% and ...this Au-rich precipitate was Ti 3 Au, and this was consistent ...

6

Magneto-Optic Surface Plasmon Resonance Ti/Au/Co/Au/Pc Configuration and Sensitivity

Magneto-Optic Surface Plasmon Resonance Ti/Au/Co/Au/Pc Configuration and Sensitivity

... in-plane magnetic field to the sensor surface for both the as-deposited and annealed multilayers 21.. showed isotropic easy axis magnetization parallel to the multilayer interface at a [r] ...

11

Thermodynamic Analysis of the Nb–Ti–B Ternary Phase Diagram

Thermodynamic Analysis of the Nb–Ti–B Ternary Phase Diagram

... of B on austenite grain boundaries, which suppresses the nucleation of ferrite on grain boundaries; however, this mechanism has not been clarified and is still ...and Ti to steels improves their strength and ...

10

Abstract: The stepwise hydrogenation of the C=C bond and C=O group of acrolein on Au 3

Abstract: The stepwise hydrogenation of the C=C bond and C=O group of acrolein on Au 3

... Recently gold exhibits unexpected activity for the selective hydrogenation of α,β-unsaturated aldehydes to unsaturated alcohols.[14-17] Experimental studies substantiated the crucial role of Au as an active ...

11

A decomposable silica-based antibacterial coating for percutaneous titanium implant

A decomposable silica-based antibacterial coating for percutaneous titanium implant

... the titanium specimens in a culture of S. aureus for 24 hours was sufficient to initiate biofilm formation. The method used to assess the anti-biofilm activity on the obtained structures involved quantification of the ...

9

Metal electrode integration on macroporous silicon: pore distribution and morphology

Metal electrode integration on macroporous silicon: pore distribution and morphology

... long Au ribbons (100-nm thick). Au was chosen because it is HF ...thick Ti layer was used to promote the Au surface adherence. Ti was chosen instead of Cr because the combination of Cr ...

5

Electrochemical characteristics of microelectrode designed for electrical stimulation

Electrochemical characteristics of microelectrode designed for electrical stimulation

... materials, an electrical prosthesis must also provide long-term stability of the metal electrodes, while minimizing any tissue damage that occurs as a result of the electrical stimulation. Induced tissue damage will ...

14

Bipolar resistance switching characteristics with opposite polarity of Au/SrTiO3/Ti memory cells

Bipolar resistance switching characteristics with opposite polarity of Au/SrTiO3/Ti memory cells

... [14]. The oxygen vacancies, which are positively charged, are accumulated (extracted) into (from) the top interface region upon negative (positive) bias. In the process of the current transition, the Schottky-like bar- ...

8

Effect of Titanium Carbides on the Ductility and Toughness of High Carbon 30 mass% Chromium Steels

Effect of Titanium Carbides on the Ductility and Toughness of High Carbon 30 mass% Chromium Steels

... and Ti carbide precipitates. The morphology of Ti carbide precipitates and ductile-brittle transition temperatures deter- mined by tensile tests (tensile DBTTs) for the specimens containing between ...

6

Mesomorphic Lamella Rolling of Au in Vacuum

Mesomorphic Lamella Rolling of Au in Vacuum

... as compiled in Table 1. The supercooled liquid with Au clusters in planar, cage, or pyramid forms [7, 34] would facilitate bulk nucleation of the lamellae (Fig. 8a). In fact, the change of 3-D clusters into planar ...

11

T cell–independent B cell activation induces immunosuppressive sialylated IgG antibodies

T cell–independent B cell activation induces immunosuppressive sialylated IgG antibodies

... (TI) B cell activation via B cell receptor (BCR) crosslinking through polysaccharides or via BCR and TLR costimulation also induces IgG Abs, but the Fc glycosylation state of these Abs is ...that ...

10

Hardness and Wear Properties of Ti Mo C N Film

Hardness and Wear Properties of Ti Mo C N Film

... (AES). Ti, Mo, C and N contents were determined quantitatively by a relative sensitivity coefficient method using TiC, TiMo and TiN as reference ...obtained Ti-Mo-C-N films were examined by ...

6

Fabrication of self assembled Au droplets by the systematic variation of the deposition amount on various type B GaAs surfaces

Fabrication of self assembled Au droplets by the systematic variation of the deposition amount on various type B GaAs surfaces

... thin Au film during surface diffusion ...dense Au droplets of round dome shapes were synthe- sized with an AH of ...of Au droplets was increased by × ...self-assembled Au droplets was ...

11

Water Driven Assembly of Laser Ablation Induced Au Condensates as Mesomorphic Nano  and Micro Tubes

Water Driven Assembly of Laser Ablation Induced Au Condensates as Mesomorphic Nano and Micro Tubes

... Reddish Au condensates, predominant atom clusters and minor amount of multiply twinned particles and fcc nanoparticles with internal compressive stress, were produced by pulsed laser ablation on gold target in ...

9

Photoelectrochemical studies of DNA tagged biomolecules on Au and Au/Ni/Au multilayer nanowires

Photoelectrochemical studies of DNA tagged biomolecules on Au and Au/Ni/Au multilayer nanowires

... different Au nanostructures with or without dye-attached ...the Au NWs without tagging (Figure 4b). In Figure 4c,d, Au NWs exhibit a bright reflection because of an uniform cover- age of biomolecules ...

8

Vacuum Brazing of Alumina to Titanium for Implantable Feedthroughs Using Pure Gold as the Braze Metal

Vacuum Brazing of Alumina to Titanium for Implantable Feedthroughs Using Pure Gold as the Braze Metal

... with Ti ferrule having leak rate of the order of ...of Ti with Au and EDX analysis at the Au- Ti interface revealed that all the four Ti-Au intermetallic compounds forms ...

7

Cooperative Effects of Confinement and Surface Functionalization Enable the Formation of Au/Cu2O Metal-Semiconductor Heterostructures

Cooperative Effects of Confinement and Surface Functionalization Enable the Formation of Au/Cu2O Metal-Semiconductor Heterostructures

... with organic matter. Slides were removed from the piranha solution after one hour, rinsed several times with water, and dried for 30 minutes in an oven heated to 80°C. Deoxygenated ethanol was prepared by adding 5 ...

25

Microstructure and Mechanical Properties of a Rolled Ti Si B Alloy

Microstructure and Mechanical Properties of a Rolled Ti Si B Alloy

... chemical compositions of elemental materials used in this study were summarized in Table 1. The ingot was sliced into billet with a size of 40 10 7 mm 3 . The billets were subjected two kinds of thermo-mechanical ...

5

Processing of Mg-3.2 Al-2.4 Zn Alloy Matrix In-situ Composites by Reactive Infiltration Technique

Processing of Mg-3.2 Al-2.4 Zn Alloy Matrix In-situ Composites by Reactive Infiltration Technique

... mild steel tube. The pieces of Mg-Al-Zn alloy ingot were placed on the top of the compacted preform in the tube. The steel tube containing powder preform and Mg alloy ingots was then placed in a stainless steel chamber ...

7

Spectroelectrochemical Dynamics of Dendritic Poly (Propylene imine)-Polythiophene Star Copolymer Aptameric 17B-Estradiol Biosensor

Spectroelectrochemical Dynamics of Dendritic Poly (Propylene imine)-Polythiophene Star Copolymer Aptameric 17B-Estradiol Biosensor

... a AuG1PPT-co-PEDOT star copolymer electrode system and its application in the development of aptameric biosensor by incorporating an E2-specific 76-mer biotinylated ssDNA ...

23

Show all 10000 documents...

Related subjects