[PDF] Top 20 EAA MODEL: IZH43 (BOUNTY HUNTER II) SIDE BY SIDE- SHOTGUN WARNING AND INSTRUCTION MANUAL PLEASE READ THESE INSTRUCTIONS

... 7. WARNING: The actual firearm does not contain any lead; however, it does fire ammunition containing lead or lead compounds known to the State of California to cause cancer, birth defects, reproductive toxicity, ... See full document

... owner’s manual contains important warnings and safety procedures which must be understood BEFORE using this Air ...Rifle. Read the entire manual and if you do not understand any part of it or the ... See full document

... owner’s manual contains important warnings and safety procedures which must be under- stood BEFORE using this Air ...Pistol. Read the entire manual and if you do not understand any part of it or the ... See full document

... With the barrel pointed in a safe direction and the cocking handle in the forward locked position, load the magazine with five pellets (One in each holding position and make sure the pellet skirt is flush with the ... See full document

... IF YOU HAVE LOADED YOUR AIR PISTOL and you wish to unload the pistol. First engage the slide safety, make sure the pistol is pointed in a safe direction and then remove the magazine. Slide the BB Pusher down and turn the ... See full document

... 10. The Rifle Barrel Extension slides over the barrel of the pistol and locks on the trigger guard with a button detent. 11. The Trigger Safety is located in the trigger and is a push / pull type. If the round ring is ... See full document

... • 5) After inspection load the correct type of cartridge into the barrel. Make sure that the cartridges are flush with the extractor, then close the action by swinging the barrel up until it locks into the receiver and ... See full document

... 3) Fig 3: Engage the lower locking lug located on the lower portion of the barrel with the receiver. The half round cut out on the lower locking lug fits around the round bar in the forward lower portion of the slot in ... See full document

... If there is any reason to suspect that a bullet or projectile is obstructing the barrel, immediately unload the firearm (See Unloading Instructions) and check the chamber and the bore. A bullet may be lodged some ... See full document

... STOP SHOOTING IMMEDIATELY AND UNLOAD YOUR FIREARM if your fire- arm develops: a mechanical malfunction; binding or stoppage; spitting pow- der/gas; a cartridge primer is punctured; a cartridge case is bulged or ruptured; ... See full document

... This shotgun has a unique feature called a cocking lever / locking ...the shotgun and are not ready to fire we suggest you decock the gun by following the above ...the shotgun and wish to recock the ... See full document

... • 5) After inspection load the correct type of shot shell into the bottom chamber and the correct type of cartridge into the top barrel. Make sure that the shell and cartridge are flush with the extractor, then close the ... See full document

... there is a file with the same name as the directory that the camera is attempting to create, or the highest possible file number has already been reached. In the Rec. Menu, set the [File No. Reset] option to [On]. Save ... See full document

... Wheelock’s Series E50 Speakers are UL Listed under UL Standard 1480 for Speaker Appliances. They are designed for multiple power requirements with high dBA output at each power tap. All models offer a choice of field ... See full document

... The hammer safety stop is a notch on the hammer which prevents it from falling fully forward in the event of primary sear notch failure. It also prevents fingers slip from the slide or hammer while cocking the pistol, ... See full document

... Before disassembling, ensure your shotgun is unloaded and pointed in a safe direction. Move the barrel latch downward to its rear most position. Move the top lever to the extreme right to open the shotgun. ... See full document

... OPERATION OF THE DOUBLE RIFLE "SAFETY" MECHANISM The double rifle safety mechanism is located on the tang of the receiver assembly just in front of the buttstock on the top side (See figure 5). Some Merkel ... See full document

... NOTE: The barrel release button should be roughly parallel with the edges of the handguard nearest it (Fig.37). If it looks like Fig. 36, the barrel is not locked into place. Rotate the barrel slightly back and forth and ... See full document

... pistol, please read and follow the procedures outlined in this ...This manual only applies to the SIGARMS Granite Series ...this manual is available for reference and kept with this pistol if ... See full document

... Before using your firearm, it should be cleaned. (See Cleaning Instructions at page 24.) Your firearm has been treated with either a preservative or oil to protect it against corrosion. Before using it, all excess ... See full document