• No results found

Electrochemical Reduction and Deposition of Reduced Graphene Oxide/Manganese Oxide Composite for Supercapacitor Applications via Pulse-Chronoamperometry

N/A
N/A
Protected

Academic year: 2020

Share "Electrochemical Reduction and Deposition of Reduced Graphene Oxide/Manganese Oxide Composite for Supercapacitor Applications via Pulse-Chronoamperometry"

Copied!
8
0
0

Loading.... (view fulltext now)

Full text

Figure

Table 1 Four factors’ working ranges for Central Composite Design.
Fig. 3  The galvanostatic charge-discharge curve for rGO/MnO2 compared with pure MnO2 and rGO prepared with -1.0 V and 1.0 V for 60 s respectively using 0.2 M Mn(AC)2 at 60°C
Table 2 The specific capacitance of rGO/MnOx as a function of voltage, deposition time, temperature and concentration of Mn(Ac)2
Table 3. Analysis of ANOVA for response surface 2FI model.
+2

References

Related documents

As illustrated in our cases, majority of the rhabdomyoblastic tumors of the bladder are likely rhabdomyosarcomatous carcinoma as small foci of carcinomatous element are only

Relative cholesterol efflux in individuals het- erozygous for an ABCA1 mutation was plotted against the mean HDL-C levels observed in the carriers of that mutation, expressed as

A programmable logic controller uses a program to link together a number of input devices (e.g. Sensors, switches) and output devices (e.g. Actuators, LED's) to produce a

After analyzing the data using factor analysis resulted in the extraction of three main factors (supervision, Authority, Accountability, Recognition and Company Policies),

If the mountain streams are supported by large proportions of overland flow or interflow, the Cl − concentration in stream water entering the basin should tend to be lower than that

Following an analysis of the replies to its working document ‘Towards common asylum procedures’ of March 1999, and of relevant resolutions of the EU acquis and legislation and

and so we can follow xit) by applying methods traditionally used for the solution of ordinary differential equations. In Chapter 2 we consider general single-step methods

The effects on the corrosion parameters of steel caused by adding different concentrations of iodide ions and UC in the absence and presence of 1000 ppm PVP were studied..