• No results found

MX8 CORDLESS 22.2V STICK VACUUM CLEANER

N/A
N/A
Protected

Academic year: 2021

Share "MX8 CORDLESS 22.2V STICK VACUUM CLEANER"

Copied!
16
0
0

Loading.... (view fulltext now)

Full text

(1)

MX8 CORDLESS 22.2V STICK

VACUUM CLEANER

(2)
(3)

• Ensure to read the instructions in this user guide thoroughly. Store the user guide for future use.

• Use the appliance on a stable, flat, heat-resistant surface.

• Never immerse any part of the plug or the main unit in water or other liquids. • Never leave the appliance unattended while in use.

• Ensure the power supply voltage is as per the rated voltage. • Remove the battery pack when not in use or for maintenance.

• This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance in a safe way by the person responsible for their safety, and understand the hazards involved.

• This appliance is suitable for children 8 years and older. Pay close attention to children’s safety when they are near the appliance. Do not let children play with the appliance to avoid accidents.

• Do no let the pets go near the appliance.

• This appliance is for domestic use only. It should not be used for any purpose other than its intended use.

• Do not use this appliance to suck liquid, sharp objects such as nails, pushpins, etc. • Do not disassemble or repair this appliance. Contact Kogan.com or the

Kogan.com recommended professionals to repair the appliance.

• If the power cord is damaged, cease use immediately and contact Kogan.com • Use this appliance with the Kogan.com recommended accessories.

• In the event of a malfunction, cease use immediately and contact Kogan.com

(4)

Main Unit Aluminium Tube Wall Bracket

Charger

Accessories

Electric Brush 2-in 1 Brush Crevice Tool

(5)

1 Primary Screen 8 Brush Lock 2 Compact Screen 9 Electric Brush 3 Dust Cup Lock 10 Charging Indicator 4 Dust Cup 11 Battery Pack Lock 5 Dust Release Button 12 Battery Pack 6 Tube Lock 13 On/Off Switch 7 Aluminium Tube 1 2 3 4 5 6 7 8 9 10 11 12 13

OVERVIEW

(6)

Compact Screen

Battery Level Indicator

Eco Speed High Speed Automatic Mode

(7)

1. Choose an accessory according to your cleaning requirement.

2. Insert the aluminium tube into the main unit until it clicks into the place. 3. Insert the accessory you have chosen into the aluminium tube. 4. Make sure the installation is firm before you use it.

5. To remove the aluminium tube, press and hold the tube lock. To remove the accessory, press and hold the brush lock.

1. Press the on/off switch, the appliance will start to work in the eco speed mode. 2. Press the speed control button, the appliance will work in the high speed mode. 3. Press the speed control button again to return to the eco speed mode. 4. Press AUTO to switch the automatic dust suction mode.

ASSEMBLY

OPERATION

Note:

• When using, do not exceed the maximum line indicator in the dust cup. • This appliance is for dry suction only.

• Ensure there is no clogging in any of the openings to avoid motor overheating and damage.

(8)

Battery Pack

1. Insert the battery pack into the place along the guide slot and ensure the battery pack is fixed firmly.

2. To remove the battery pack, press the battery pack lock.

Charging

1. Connect the charger to the battery pack and turn on the power supply to start charging.

2. When charging, the charging indicator flashes blue light gradually and becomes solid when it is fully charged.

WARNING:Charge the battery with the charger supplied with the appliance to avoid damage.

(9)

• Never immerse the main unit in water or any liquid.

• Only use a soft, slightly damp cloth to clean the main unit. Do not allow any liquid substances to enter the main unit.

• Except the main unit, other parts can be washed with warm soapy water. After cleaning, it must be thoroughly dried.

• Do not use any corrosive chemicals or abrasives. • Do not use when the filter is damaged or worn.

Cleaning Dust Cup

1. Empty the dust cup and clean the filter every time it is used. 2. Press and hold the dust cup lock to separate the dust cup.

3. Press and hold the dust release button to empty the dust in the dust cup.

(10)

Cleaning Filter

1. Separate dust cup from the main unit.

2. Remove the air inlet filter and wash it in warm water.

3. Dry the filter for 24 hours before placing it back into the dust cup.

Note:

• Do not dry the filter with drying equipment. Dry naturally.

• Do not clean it with other cleaning equipment. Follow the instructions in this section.

• Replace the filter every three months (depending on the usage) to ensure the best performance.

(11)

Problem Cause Possible Solution

Weak Suction Power

Dust cup and filters are full of dust.

Clean the dust cup and filters regularly.

The brush head is blocked by

hair. Clean the brush.

Abnormal Sounds The aluminium tube is blocked Clean the blockage inside of the aluminium tube. If there are any abnormalities, contact Kogan.com

Charging Indicator Light Flashes

The brush or dust cup is blockage has caused the current increase

Clean the blockage. See the Cleaning & Care section if this user guide.

Ambient temperature is too high or too low, causing the battery humidity to be too high or too low

Ensure the appliance is operated at a right temperature (0 - 55 ° C).

A different charger is used to charge the battery.

Charge the battery using the charger supplied with the appliance.

Brush is Not

Working The brush head is blocked by hair. Clean the brush.

Appliance is Not Working

The battery power is low. Charge the battery. See the Operation section of this user guide.

The aluminium tube nozzle is

blocked. Clean the aluminium tube nozzle.

Automatic Mode

Failure The aluminium tube nozzle is blocked. Clean the nozzle regularly.

Disposal

This marking indicates that this appliance should not be disposed with other house-hold wastes. To prevent possible harm to the environment or human health from uncontrolled waste disposal, recycle it responsibly to promote the sustainable reuse of material resources.

(12)

Battery Configuration Lithium-ion 2000mAh 22.2V

Rated Power 120W

Input Power AC 100-240V, 50/60Hz 0.5A

Output Power DC 26.5V, 0.5A

Charging Time 4-5 Hours

Operating Time Maximum of 40 minutes (when the battery is fully charged)

Protection Class II

(13)
(14)
(15)
(16)

Need more information?

We hope that this user guide has given you the assistance needed for a simple set-up. For the most up-to-date guide for your product, as well as any additional assistance you may require,

References

Related documents

The contrasting evidence available for some of them is analysed first One can say that the very factor that sustained some equality before the crisis, i.e., a rather high rate

Fairest Lord Jesus, ruler of all nature, O thou of God and man the Son, Thee will I cherish, Thee will I honor, Thou, my soul's glory, joy, and crown!. Fair are the

To program the speed at which Rapid Fire operates, press and hold the ‘Feature Button 2’ and move the right analogue stick up to increase the speed and down to decrease the

Instead of dialing the extension number, you may press a MEMORY button programmed with an extension number (for internal calls only) - or press a SPEED DIAL button (or press

• repeatedly press the fan button to choose the desired ventilation speed; in case of selecting the AUTO mode, the speed is decided by the electronic control depending on the gap

To cancel the Jet Cool mode, press the Jet Cool button or the fan button or the room temperature setting button again and the unit will operate in high fan speed in cooling mode..

To cancel the Jet Cool mode, press the Jet Cool button, the fan speed button or the room temperature setting button again and the unit will operate at high fan speed on cooling mode..

To cancel the Jet Cool mode, press the Jet Cool button again or the fan speed button or the room temperature setting button and the unit will operate in high fan speed on cooling