concrete/asphalt
Hybrid Reinforcement of Asphalt-Concrete Mixtures Using Glass and Polypropylene Fibers
... the asphalt binder, lower asphalt (effective asphalt) cannot fill the space between the mineral aggregate and produces the increase in ...fiber-reinforced asphalt-concrete may be ...
11
Characterisation of Asphalt Concrete Using Nanoindentation
... Using nanoindentation with a Berkovich indenter, it was possible to successfully capture the heterogeneity of asphalt concrete, with distinctly different properties for mastic, matrix, and aggregate phases. ...
11
Assessment of the Deterioration Model for Asphalt Concrete Pavement
... at asphalt stabilized base course at station 34+000, the binder course was badly distressed by shear failure and the thickness of the course increased between the wheel ...in asphalt concrete ...
10
Alternative Test Methods to Evaluate Moisture Sensitivity of Asphalt Concrete
... in asphalt concrete mixture may also be quantified by measuring the dynamic elastic ...cement concrete prisms, before and after exposure to freeze-thaw loading, is used as a measure of reduction in ...
130
The Use of Reclaimed Asphalt Pavement in New SUPERPAVE Asphalt Concrete Mixtures
... again for this research because of material familiarity, the close proximity of quarry to the research laboratory, and the fact that the granite aggregate manufactured at this quarry has been found to exhibit very ...
354
Performance Characteristics of the Open-Graded Asphalt Concrete Filled With a Special Cement Grout
... flexible asphalt pavement stiffness depends heavily on the temperature, the tempe- rature has no effect on rigid concrete ...pavements. Asphalt pavements consist of several relatively thin ...
9
Resilient Behavior of Modified Asphalt Concrete Mixture
... Abstract: Asphalt concrete pavement is designed to exhibit elastic behavior under loading at cold weather condition and a combination of elastic, plastic and viscous behavior at hot weather ...modified ...
6
Environmental Aspects of Use of Impregnating Compositions for Protection the Asphalt Concrete Road
... of asphalt concrete road from the negative factors of natural and technogenic ...road asphalt concrete at loss of an atmospheric precipitation, and temperature ...the asphalt ...
6
Design of high modulus asphalt overlay for concrete pavements
... 2014). Asphalt overlay is the most common type of pavement restoration; and the two widely used methods are a thin asphalt concrete mix or just thin asphalt (Cülfik, ...of asphalt only, ...
70
Investigating the Effects of Using Waste Rubber and Polyethylene Terephthalate (PET) on Mechanical Properties of Asphalt Concrete
... Modarres and Hamedi [14], [21] found that the stiffness and tensile strength of the mixture can be improved by adding of 2% (by the weight of binder) of PET into asphalt concrete. By adding PET to mixture ...
6
An Investigation of Warm Mix Asphalt Technology in Asphalt Concrete Mixtures.
... maintenance. Asphalt concrete is a material that is used in the construction of a majority of roads all over the ...world. Asphalt is a by-product obtained from fractional distillation of petroleum, ...
98
Complex Modulus Determination of Asphalt Concrete Using Indirect Tension Test
... Dynamic modulus is a fundamental material property that should remain the same regardless of how the material is being tested, assuming that asphalt concrete is isotropic. Thus, a comparison was conducted ...
132
Investigation of Warm Mix Asphalt Concrete Mixtures with Recycled Asphalt Pavement Material
... higher asphalt contents than the optimum and along with those with a softer virgin binder (PG 58-28) at optimum asphalt ...in Asphalt Pavement Analyzer ...
168
AN EXPERIMENTAL STUDY ON PERVIOUS CONCRETE AS AN ASPHALT LAYER
... pervious concrete pavement is ecofriendly to the environment. Pervious concrete will conjointly be used as permeable ...lean concrete should have a minimum compressive strength, The receptive ...
10
Linear viscous approach to predict rut depth in asphalt mixtures
... Six different aggregate gradations have been selected, to cover a range of possible variations, within the limits of 14 mm maximum aggregate size Asphalt Concrete according to BS EN 4987-1:2005. The ...
29
Water Absorption Study in Recycled Aggregates for Use as Pavement Material
... Water absorption properties of recycled materials play an important role in pavement perfor- mance. The performance of aggregates changes after absorbing water, then it affects highways layers such as base, subbase, ...
10
Water sensitive urban design for sustainable road development
... existing asphalt road, grading, installation of the curb and gutter and the sub-base installation of the sub-base for the new pavement are completed in one day, followed by the concrete pour and finishing ...
75
Wavelength dependent spatial variation in the reflectance of 'homogeneous' ground calibration targets (Paper presented at XIX ISPRS Congress, 16 22 July, 2000, Amsterdam, The Netherlands)
... GCTs: asphalt, concrete and grass. The asphalt surface was represented by a straight road of 2,000 m of length and 50 m width; the concrete surface consisted of blocks of slightly irregular ...
8
Permeable Pavement by using Waste Plastic Bottles
... The asphalt, concrete and interlocking concrete pavement industries, as well as a number of other manufacturers of permeable surfaces, provide a variety of pavement surface ...
7
Evaluation of the Physical Properties of Unbound Base Layer Containing Recycled Aggregates
... Highways are built in several layers of surface, base and sometimes sub-base. The surface layer is made of Portland cement or asphalt concrete. The base and sub-base layers are usually made of bound or ...
7