glass substrate
Sensing Performance of EGFET pH Sensors with CuO Nanowires Fabricated on Glass Substrate
... Moreover, it was found that the intensities of the peaks observed from the CuO layer were much weaker than those observed from the thermally treated samples. This was attributed to the much smaller thickness of the CuO ...
8
A Compact 2.4/5.2-GHz Rat-Race Coupler on Glass Substrate
... low-loss glass substrate to reduce substrate losses, three thick metal layers to reduce conductor losses, and bumpers to integrate CMOS RFICs in a flip-chip form as shown in Figure ...
10
A pH sensor based on electric properties of nanotubes on a glass substrate
... Abstract We fabricated a pH-sensitive device on a glass substrate based on properties of carbon nanotubes. Nanotubes were immobilized specifically on chemically modified areas on a substrate followed ...
6
Morphology control and optical properties of SiGe nanostructures grown on glass substrate
... To further explore the crystal quality of SiGe/Ge NWs, we also performed the XRD measurement. Figure 4a is the typical SEM image of as-grown SiGe/Ge NWs, which we used for XRD studies. Figure 4b shows the XRD patterns of ...
5
Morphological Properties of Titanium-Niobium Alloys with Different Compositions on Glass Substrate
... In a number of recent studies, α and β-phases have been detected to coexist in Ti-Nb alloy system. 5,6 However, there are no research reports on investigations on properties of Ti-Nb alloys for full range of composition. ...
13
Synthesis of Aluminum and Boron co-doped ZnO nanostructure films on Glass Substrate
... where A is a constant, is optical bandgap, is plank constantand is the absorption coefficient. The plot of versus for AZB nanostructure films at different concentration is shown in Fig. 4(a).A plot of versus often yields ...
5
Structural properties of borondoped zinc oxide nanostructure films depositon Glass Substrate
... in Department of Physics College of science in 1989, from University of Baghdad, a researcher at the Applied Physics Center and member of thin films application [r] ...
6
Growth Of Nanopartical Zinc Sulfide Films By Chemical Spray Pyrolysis Technique
... Nanopartical zinc sulfide films were prepared by chemical spray pyrolysis (CSP) technique at substrate temperature of (400±5 о C) on glass substrate and different thickness (75, 150, 225, 300, 375, ...
17
2D-arrrays of Cu Nanodisks on Anodic Aluminum Oxide (AAO) Template for SERS Applications
... fabricated substrate, we recorded the Raman scattering spectra of Rhodamine 6G (Rh6G) coated on the glass substrate, and on the 2D- array Cu nanodisks upon the AAO substrates with the excitation ...
5
Processing and characterisation of II-VI ZnCdMgSe thin film gain structures
... InP substrate and the InGaAs buffer layer, following Moug et ...temporary glass substrate, both to protect the surface and to provide structural support during the ...InP substrate is mechani- ...
6
Effect of the Dielectric Barrier Discharge Plasma on the Optical Properties of CDS Thin Film
... Cadmium sulphide CdS films with 200 nm have been prepared by thermal evaporation technique on glass substrate at substrate room temperature under vacuum of 10 -5 mbar.In this paper, the effect of ...
6
Fabrication of Dye Sensitized Solar Cell Based on Titanium Dioxide (TiO2)
... ficiency of 7.1% and high stability [3]-[5]. There are three different kinds of electrolytes have been used in DSSCs: 1) the most common electrolyte is I − I 3 − in organic solvents, such as acetonitrile; 2) inorganic ...
7
Synthesis of Silver Sulphide Nanoparticles by Modified Chemical Route For Solar Cell Applications
... the glass and fluorine doped tin oxide (FTO) coated glass substrate from an aqueous alkaline bath at room temperature ...on glass substrate were studied for their structural, surface ...
6
Study of Structural, Morphological and Optical Properties of Spray Deposited Sn Doped Β - V 2O5 Thin Films T Akkila a* , I Mansur Basha a, b
... added from 0.01mM to 0.05mM insteps of 0.01mM in the precursor solution respectively. The solution was sprayed at an angle of 45˚ onto preheated glass substrate kept at a distance of 50cm from the spray ...
7
Influence Of Structural Properties Of Pure Sno2,fe2o3 And Nanocomposite Sno2 /fe2o3 Thin Films Deposited By Spray Pyrolysis Technique
... on glass substrate by chemical spray pyrolysis technique and to study the effect of the composite concentration on the structural properties of these ...
7
Growth and Characterization of Electrochemically Deposited N-Cdse Thin Films for Photovoltaic Solar Cells
... steel substrate at 200 o C respectively exhibiting its microstructure, the thin film of CdSe after annealing indicates smooth and uniform surface with a crack and pinhole free appearance with spherical shaped ...
9
Polycarbonate Based Blends for Optical Non linear Applications
... The UV-Vis transmission spectra of the films of poly- carbonate and polycarbonate with monomer inclusions show a steep fundamental absorption edge which is slightly shifted to a longer wavelength compared to the ...
13
Thermal Conduction Behaviors of PAAm Hydrogels
... Figure S3. Schematic of 3ωmeasurement for different water content and temperature dependent thermal conduction in PAAm hydrogels. The four Au squares with the length of 20 um and thickness of 100nm is deposited on a 1 mm ...
12
Optical characterization of the CdZnSe 2x Te2 (1-x) thin films deposited by spray pyrolysis method
... .25, .50, .75, 1 have been deposited on glass substrate by spray pyrolysis method at substrate temperature 300 o C.The average transmission values are found to vary from 75.5% to92% for ...
5
Fracture analysis of anodically bonded silicon substrates during the CMP process
... the glass substrate to form the cavities on desired locations and areas of the ...and glass substrates are cleaned to reduce surface ...silicon substrate became 60 ...
6