• No results found

Irradiation Time

OPTICAL CONSTANTS CORRELATED WITH ETCHING  AND IRRADIATION TIME OF  LR115 DETECTOR BOMBARDED WITH  Α-PARTICLES FOR DIFFERENT IRRADIATION TIMES

OPTICAL CONSTANTS CORRELATED WITH ETCHING AND IRRADIATION TIME OF LR115 DETECTOR BOMBARDED WITH Α-PARTICLES FOR DIFFERENT IRRADIATION TIMES

... alpha irradiation time( increasing alpha irradiation dose) due to photo degradation of LR115 films and formation of defects and clusters while the cluster size increase with increasing the absorbed ...

23

Formation and Growth of Silver Nanocubes upon Nanosecond Pulsed Laser Irradiation: Effects of Laser Intensity and Irradiation Time

Formation and Growth of Silver Nanocubes upon Nanosecond Pulsed Laser Irradiation: Effects of Laser Intensity and Irradiation Time

... laser irradiation with different ...the irradiation time, and the size distribution of synthesised AgNCs was obtained for each experi- mental ...

10

Influence of Solvents and Irradiation time on Structural and Optical Properties of Cubic PbS Nanoparticles

Influence of Solvents and Irradiation time on Structural and Optical Properties of Cubic PbS Nanoparticles

... microwave irradiation time was investigated by varying the irradiation time from 10 to 50 minutes ...and irradiation time for the formation of the PbS nanoparticles were ...

16

Thermal degradation and damping characteristic of UV irradiated biopolymer

Thermal degradation and damping characteristic of UV irradiated biopolymer

... UV irradiation time, lowest thickness, and percentages of TiO 2 loading at the frequency range of 15–25 Hz due to the potential of the sample to dissipate energy during the oscillation harmonic ...

11

MICROWAVE ASSISTED EXTRACTION OF PECTIN FROM MANGOSTEEN (GARCINIA MANGOSTANA) RIND

MICROWAVE ASSISTED EXTRACTION OF PECTIN FROM MANGOSTEEN (GARCINIA MANGOSTANA) RIND

... Pectin was extracted using a typical microwave oven. In a 500-liter Pyrex-beaker, 4 grams of powder were added to 200 mL citric acid with varying ph of 2 -3, irradiation time of 3 – 9 minutes and power ...

5

Photocatalytic Degradation Of Procion Red Synthetic Dye Using ZnO-Zeolite Composites

Photocatalytic Degradation Of Procion Red Synthetic Dye Using ZnO-Zeolite Composites

... Abstract: Textile industry consumes the most amounts of dye lots in the production process which have a non-biodegradable in nature. It is necessary to do the dye wastewater treatment before discharging to the ...

6

A time-dependent atomistic reconstruction of severe irradiation damage and associated property changes in nuclear graphite

A time-dependent atomistic reconstruction of severe irradiation damage and associated property changes in nuclear graphite

... images time series are presented in Fig. 2(a-c). At short irradiation times (2 min), long linear fringes, reminiscent of the virgin (unirradiated) graphite structure, are easily detected in the ...minute ...

40

Investigation of the Effects of Graphene Oxide Nanoparticles and Multi-Wall Carbon Nanotubes on Conductivity and Surface Morphology of Polyester-Viscose Fabric

Investigation of the Effects of Graphene Oxide Nanoparticles and Multi-Wall Carbon Nanotubes on Conductivity and Surface Morphology of Polyester-Viscose Fabric

... because of fewer required experimental trials as compared to the “one-factor-at-a-time” method [24,25]. Also, it is an efficient mathematical approach of optimizing complex processes which are able to generate an ...

12

Characterization and Corrosion Behavior of Hydroxyapatite- Coated Titanium Substrates Prepared Through Laser Induced Liquid Deposition Technique

Characterization and Corrosion Behavior of Hydroxyapatite- Coated Titanium Substrates Prepared Through Laser Induced Liquid Deposition Technique

... laser irradiation time and sintered at 500 ...laser irradiation time which contributes to the disordering of the film structure and amorphous-like structure ...

7

Detailed kinetic and chemometric study of the cellulose thermal breakdown in artificially aged and non aged commercial paper. Different methods for computing activation energy as an assessment model in archaeometric applications

Detailed kinetic and chemometric study of the cellulose thermal breakdown in artificially aged and non aged commercial paper. Different methods for computing activation energy as an assessment model in archaeometric applications

... the irradiation time in the weatherometer, seems to be the one obtained using the Satava and Arrhenius methods to identify the model function that best fits the experimental trend of the DTG peak values, ...

9

Development of hybrid coconut shell peek adsorbent for methane 
		adsorption: optimization using response surface methodology

Development of hybrid coconut shell peek adsorbent for methane adsorption: optimization using response surface methodology

... and irradiation time are variables studied in this ...of irradiation time and 25wt% amount of PEEK. Power and time are played significant role than PEEK towards the CH 4 adsorption with ...

8

Photocatalytic degradation of malachite green dye under UV light irradiation using calcium-doped ceria nanoparticles

Photocatalytic degradation of malachite green dye under UV light irradiation using calcium-doped ceria nanoparticles

... was found to 3.96 eV. In addition, under the optimum operational conditions (initial dye concentration of 6 mg/L, irradiation time of 90 min, photocatalyst dosage of 0.1 g and solution temperature of 35 ...

14

Using Ultraviolet Irradiation for Removal of Malathion Pesticide in Water

Using Ultraviolet Irradiation for Removal of Malathion Pesticide in Water

... traviolet irradiation depends on three param- eters; the initial concentration, the irradiation time and the ...the irradiation time increases, lots of free radicals has formed in the ...

9

Influence of Irradiation and Damage Coefficient on the Minority Carrier Density in Transient Respons
                 

Influence of Irradiation and Damage Coefficient on the Minority Carrier Density in Transient Respons  

... Abstract - This paper present the theoretical and simulation investigation of a bifacial silicon solar cell under multispectral illumination and particles (electrons, protons…) irradiation. The bifacial solar cell ...

7

Time- and Dose-Dependent Effects of Ionizing Irradiation on the Membrane Expression of Hsp70 on Glioma Cells

Time- and Dose-Dependent Effects of Ionizing Irradiation on the Membrane Expression of Hsp70 on Glioma Cells

... Its intratumoral heterogeneity, concerning genetic alterations and morphology as well as the infiltrative growth and diffuse dissemination into the brain parenchyma often hinder a successful treatment of GBM. Therefore, ...

24

Effects of g irradiation, temperature and storage time on the status of the glucose, fructose and sucrose in onion bulbs Allium cepa L.

Effects of g irradiation, temperature and storage time on the status of the glucose, fructose and sucrose in onion bulbs Allium cepa L.

... Several investigations have been carried out throughout the world on the use of ionising radiation for controlling the sprouting of onions [9,11]. The irradiation doses ranging from 0.05 to 0.15 kGy inhibit bulb ...

5

Preparation and near infrared photothermal conversion property of cesium tungsten oxide nanoparticles

Preparation and near infrared photothermal conversion property of cesium tungsten oxide nanoparticles

... powder before grinding had a large particle size. After grinding, the resulting particles had an irregular shape because they were debris from the collisions with grind- ing beads during the milling process. Furthermore, ...

8

Research to Determine the Long Term Mechanical Properties of Metals Subjected to Mechanical Stress at Elevated Temperatures and Neutron Irradiation  Annual Report 1965  EUR 2834

Research to Determine the Long Term Mechanical Properties of Metals Subjected to Mechanical Stress at Elevated Temperatures and Neutron Irradiation Annual Report 1965 EUR 2834

... On the basis of these results, the following conclusions can be drawn: By comparison of time-to-rupture tests with and without neutron irradiation at different temperatures, the effect o[r] ...

24

A Photofission Delayed γ-ray Spectra Calculation Tool for the Conception of a Nuclear Material Characterization Facility

A Photofission Delayed γ-ray Spectra Calculation Tool for the Conception of a Nuclear Material Characterization Facility

... We decide to use the DARWIN code package [8] to solve such equations, because of its robustness but also because it contains already preprocessed nuclear data libraries. This code package is able to solve non homogeneous ...

5

Effect of Titanium Dioxide on Material Properties for Renewable Rapeseed and Sunflower Polyurethane

Effect of Titanium Dioxide on Material Properties for Renewable Rapeseed and Sunflower Polyurethane

... UV irradiation for 3000 hours show a decrease in the height of the peak maximum as the result of restricted chain ...various time intervals show a decrease in the height of the peak maximum for the ...

8

Show all 10000 documents...

Related subjects