• No results found

low power cw-laser

Nonlinear Responses and Optical Limiting Behavior 
of Ag Nanoparticle Suspension

Nonlinear Responses and Optical Limiting Behavior of Ag Nanoparticle Suspension

... pulsed laser ablation of a silver plate in ...nanosecond laser pulses at 532 ...a low power CW laser (at 532 nm) and nanosecond pulsed laser measurements of the optical ...

6

Inactivation of viruses by coherent excitations with a low power visible femtosecond laser

Inactivation of viruses by coherent excitations with a low power visible femtosecond laser

... pumped cw mode-locked Ti-sapphire laser. The laser pro- duces a continuous train of 80 fs pulses at a repetition rate of 80 MHz ...phire laser is used to irradiate the sample. The excitation ...

5

Tunable Yb:KGW laser, CW or Q-switched, enabled by dual-axis tilt of a MOEMS mirror : KGW laser, CW or Q-switched, enabled by dual-axis tilt of a MOEMS mirror

Tunable Yb:KGW laser, CW or Q-switched, enabled by dual-axis tilt of a MOEMS mirror : KGW laser, CW or Q-switched, enabled by dual-axis tilt of a MOEMS mirror

... The laser output power in this work was intentionally lim- ited to 5 mW average power to avoid thermal failure of the MOEMS device in both CW and Q-switched ...the power-scaling of ...

9

Tunable, CW laser emission at 225 nm via intracavity frequency tripling in a semiconductor disk laser

Tunable, CW laser emission at 225 nm via intracavity frequency tripling in a semiconductor disk laser

... high power in continuous wave operation with good beam quality, narrow linewidth and tunable ...and low optimum output coupling, typically on the order of a few percent, mean that the emit- ting wavelength ...

8

Effects of CW CO2 Laser Annealing on Indium Tin Oxide Thin Films Characteristics

Effects of CW CO2 Laser Annealing on Indium Tin Oxide Thin Films Characteristics

... different laser power. The main incentive was to develop a low temperature process for ITO thin films, which typically required a 350˚C anneal to crystallize and achieve optimum optical and ...

8

Feasibility Study of Laser Ablation using Long Pulsed 300W, CW Single Mode Fiber Laser

Feasibility Study of Laser Ablation using Long Pulsed 300W, CW Single Mode Fiber Laser

... peak power density or peak power per unit area, measured in W/cm 2 ...peak power density will allow for ablation to occur. Typically the peak power density is in the GW/cm 2 ...peak ...

115

1.6 W continuous-wave Raman laser using low-loss synthetic diamond

1.6 W continuous-wave Raman laser using low-loss synthetic diamond

... Raman laser output power was observed for diode- laser pump powers above 15W for CW operation; such behavior was not observed in the quasi-CW experiment indicating that this effect ...

7

Photoacoustic for Oral Soft Tissue Imaging based on Intensity Modulated Continuous-Wave Diode Laser

Photoacoustic for Oral Soft Tissue Imaging based on Intensity Modulated Continuous-Wave Diode Laser

... diode laser with a wavelength of 532nm and output peak power of 200mW as an excitation source, combined with a condenser microphone as photoacoustic signals ...of laser radiation by using certain ...

6

Low Power Consumption Substrate Emitting DFB Quantum Cascade Lasers

Low Power Consumption Substrate Emitting DFB Quantum Cascade Lasers

... ultra-low power consumption substrate-emitting distributed feedback (DFB) quantum cascade laser (QCL) was ...threshold power dissipation is reduced to ...threshold power dissipation of ...

5

Laser surface alloying of pure aluminium with iron and nickel via low power CO2 laser

Laser surface alloying of pure aluminium with iron and nickel via low power CO2 laser

... Teknik laser ke atas permukaan aloi telah digunakan untuk memperbaiki sifat-sifat permukaan aluminium seperti kekerasan dengan pengubahan komposisi komponenya dan struktur mikro ...cahaya laser CO 2 telah ...

25

A Study on Bead-on-Plate Welding of AA7075 using Low Power Fiber Laser

A Study on Bead-on-Plate Welding of AA7075 using Low Power Fiber Laser

... BOP laser welding process, the cross section of the welded samples selected from the optimum depth for both welding modes was compared as shown in Figure ...to CW, which could only produce wider weld zone ...

11

Laser surface alloying of pure aluminum with iron and nickel via low power CO2 laser

Laser surface alloying of pure aluminum with iron and nickel via low power CO2 laser

... Teknik laser ke atas permukaan aloi telah digunakan untuk memperbaiki sifat-sifat permukaan aluminium seperti kekerasan dengan pengubahan komposisi komponenya dan struktur mikro ...cahaya laser CO 2 telah ...

29

Efficacy of Low Power Laser Therapy and Exercise on Pain and Functions in Chronic Low Back Pain

Efficacy of Low Power Laser Therapy and Exercise on Pain and Functions in Chronic Low Back Pain

... the laser was external over a series of standardized fields designed to include the L4 to L5 and L5 to S1 apophyseal capsules, dorsolumbar fascia, and interspinous ligaments, as well as the gluteal fascia, ...

6

Molecular mechanisms of cell proliferation induced by low power laser irradiation

Molecular mechanisms of cell proliferation induced by low power laser irradiation

... Recent study demonstrated that He-Ne laser (632.8 nm) irradiation induces an immediate increase in mitochon- drial membrane potential (m), ATP, and cAMP of melanoma cell line A2058 cell via enhanced cytochrome c ...

16

APPLICATION NOTE. AT05558: Wireless Manufacturing Test Kit. Atmel ATmega256RFR2. Description. Features

APPLICATION NOTE. AT05558: Wireless Manufacturing Test Kit. Atmel ATmega256RFR2. Description. Features

... Continuous Carrier Wave (CW) and Pseudo-Random Binary Sequence Modulated Carrier (PRBS) signals for inspection with low-cost equipment. For trouble shooting and repairs the MTK can be used manually with a ...

10

Development of focusing plasma mirrors for ultraintense laser-driven particle and radiation sources

Development of focusing plasma mirrors for ultraintense laser-driven particle and radiation sources

... high power laser facilities as a tool for suppressing laser pulse amplified spontaneous emission (ASE) and possible pre-pulses inherently present in intense pulses produced through the chirped pulse ...

14

Low Cost Transmission Of Voice And DTMF Signals Using LASER Torch

Low Cost Transmission Of Voice And DTMF Signals Using LASER Torch

... the LASER rays in wireless ...high power LASER signals are used for signal transmission the range of transmis- sion can be considerably improved and can be used for long distance ...the LASER ...

5

Modeling and Simulation of Laser Assisted Turning of Hard Steels

Modeling and Simulation of Laser Assisted Turning of Hard Steels

... single precision solver was used for analysis. The next step of the model development is the definition of the material properties as well as the definition of a moving Gaussian heat source. The thermo physical ...

8

Injection locking of a low cost high power laser diode at 461 nm

Injection locking of a low cost high power laser diode at 461 nm

... slave laser spectrum, which are not resonant with the Sr line and, hence, not ...slave laser recorded at various injection laser ...at low injection laser power the slave ...

5

Stimulation of the hydrocarbon compounds degrading Saccharomyces rosinii by low power laser radiation

Stimulation of the hydrocarbon compounds degrading Saccharomyces rosinii by low power laser radiation

... by laser radiation "Biostimultion" is of most ...of laser radiation are the helium-neon laser ...gallium-aluminum laser (Ga-Al ,λ=630- 685nm), the helium-neon-arsenate laser ...

11

Show all 10000 documents...

Related subjects