• No results found

Lubrication and Friction

The Influence of Tool Texture on Friction and Lubrication in Strip Reduction Testing

The Influence of Tool Texture on Friction and Lubrication in Strip Reduction Testing

... structure with flat plateaus and neighbouring flat bottomed valleys can be obtained by combined grinding, milling and polishing of tools [12-13]. A small pocket angle towards the workpiece surface facilitates escape of ...

11

Atomic Scale Friction and Lubrication of Carbon Based Materials in Aqueous Environments.

Atomic Scale Friction and Lubrication of Carbon Based Materials in Aqueous Environments.

... “boundary lubrication” regime, the benefits of such nanolubricants have recently been demonstrated in elastohydrodynamic lubrication, where a reduced surface roughness in the rolling contact was achieved ...

181

Oil Film Thickness Measurements Combined with High Temperature Friction Investigations in a Simplified Piston-Ring Lubrication Test Rig

Oil Film Thickness Measurements Combined with High Temperature Friction Investigations in a Simplified Piston-Ring Lubrication Test Rig

... engine lubrication and rheological phenomena are avoided and engine experiments can be interpreted much easier ...the lubrication between the ...interpret friction and oil film pressure results ...

13

Reduction of friction and wear by grooves applied on the nanoscale polished surface in boundary lubrication conditions

Reduction of friction and wear by grooves applied on the nanoscale polished surface in boundary lubrication conditions

... real friction units was ...on friction surfaces occurred; (2) the final test stage, during which tribological and rheological character- istics of a friction samples and lubricant were ...of ...

5

The Influence of the Lubrication Type and the Structure of Friction Torque on Total Friction in Ball Bearings

The Influence of the Lubrication Type and the Structure of Friction Torque on Total Friction in Ball Bearings

... the lubrication conditions in ball bearings are as good as EHD lubrication, or very close to them and the portion o f the torque due to the spinning of the balls is small, the influence o f rolling and ...

8

Measurement of Friction in Cold Upsetting with Mist Lubrication

Measurement of Friction in Cold Upsetting with Mist Lubrication

... film lubrication is measured with the ring compression test. A method for depositing a thin lubricant film on the tools is shown as Fig. 8. To form a thin lubricant film on the tool surface, a known amount of ...

6

The Hydrodynamic Squeeze Film Lubrication of the Ankle Joint

The Hydrodynamic Squeeze Film Lubrication of the Ankle Joint

... of friction and reduction of synovial film thickness with time of ...joint lubrication, variable behavior of synovial fluid during different time of joint activities and the influences of articular ...

9

The Effect of Micro and Nano-Lubrication on Tribological Properties

The Effect of Micro and Nano-Lubrication on Tribological Properties

... systems. Friction is the main culprit of losses in mechanical systems developed at contact ...of friction, wear, and lubrication between interacting surfaces by relative ...

7

Oral Lubrication Matters: Effects on Satiety

Oral Lubrication Matters: Effects on Satiety

... and lubrication properties ...of friction is a measure of the reverse of lubrication), as well as characterisation of the oral processing behaviour using video ...

21

A Comparative Study of Face Milling of D2 Steel Using Al2O3 Based Nanofluid Minimum Quantity Lubrication and Minimum Quantity Lubrication

A Comparative Study of Face Milling of D2 Steel Using Al2O3 Based Nanofluid Minimum Quantity Lubrication and Minimum Quantity Lubrication

... M. Sayuti et al. experimented on duralumin AL-2017-T4 using carbon onion nano particles during milling and stated that 46% reduction oc- curs in surface roughness was reduced, as com- pared to an ordinary lubricant; ...

7

Bio-friction

Bio-friction

... the friction between the two bearing surfaces is ...in friction studies of natural synovial joints and artificial replacements as reviewed in Section ...4.1.1. Friction is usually quantified as a ...

14

Study of Additive for Aluminum Cold Rolling Lubrication

Study of Additive for Aluminum Cold Rolling Lubrication

... of friction of 1.4755; lubrication failed as soon as steel ball and rotating disc came in contact at room temperature ...of friction was detected at around 106℃ repeatedly for three tests, which is ...

133

Visualization of Lubrication Film in Model of Synovial Joint

Visualization of Lubrication Film in Model of Synovial Joint

... specific lubrication processes in synovial joint with very low coefficient of friction and ...of lubrication in natural joints in terms of experimental ...to friction measurement, but studies ...

7

Transfer lubrication techniques in a stick slip situation

Transfer lubrication techniques in a stick slip situation

... damping coefficient up to about 0.5, there was close agreement between theory and experimental results. Experimental results showing dynamic gradient as a function of impressed velocity were negative for all natural ...

320

Development of a new mechano-chemical model in boundary lubrication

Development of a new mechano-chemical model in boundary lubrication

... boundary lubrication has been considered for a long time as a necessity for modern designs of machines with reliable ...boundary lubrication regime has been the subject of many studies for more than 70 ...

34

Fiber Lubrication: A Molecular Dynamics Simulation Study

Fiber Lubrication: A Molecular Dynamics Simulation Study

... of friction and lubrication is called ...Amontons’ friction law to micro ...of friction and lubrication are still a mystery because it is technically difficult to observe what happens ...

182

Index Terms — Hydrodynamic lubrication, parabolic slider,

Index Terms — Hydrodynamic lubrication, parabolic slider,

... parameters for reduced friction coefficient. Bayrakpeken et al [3] carried out a comparative study of inclined and parabolic slider bearings using a non-Newtonian fluid in the clearance zone of the slider ...

8

Study on lubrication effect on motorbike chain transmissions

Study on lubrication effect on motorbike chain transmissions

... correct lubrication can significantly reduce the amount of heat generated during the motion: it is not clear yet whether the lubricant reduces the intensity of the impacts between the brushing component of the ...

26

Economical lubrication for every component.

Economical lubrication for every component.

... The correct advanced speciality lubricants support your compo- nents in meeting these requirements. Speciality lubricants made by Klüber Lubrication protect against wear also when subject to micro-movements, and ...

15

The Effects of Lubrication on Pharmaceutical Granules

The Effects of Lubrication on Pharmaceutical Granules

... the friction and cohesion forces that influence particle-particle ...Furthermore, friction is also affected by the surface properties of the ...particles. Friction acts at contact points between ...

155

Show all 1449 documents...

Related subjects