mass flow rates
Performance Assessment of Parabolic Trough Collector (PTC) by Using Three Passes Receiver for Preheating the Fuel Oil Under Iraq Climate for Different Mass Flow Rates
... A PTC was installed in the city of Najaf at the Alternative Energy Research Centre in the Technical Institute of Najaf, Al-Furat Al-Awsat Technical University, Iraq. The performance of a PTC was analyzed in detail under ...
10
THERMAL EFFICIENCY ANALYSIS OF A SINGLE-FLOW SOLAR AIR HEATER WITH DIFFERENT MASS FLOW RATES IN A SMOOTH PLATE
... several mass flow ...of mass flow rate of air in flow channel ...of mass flow rate equal to 0.0202 kg/s in flow channel duct for all operating conditions and the ...
6
Study of the Mass Flow Rates on the Efficiency of Hybrid Thermal / Photvoltaique Sensor
... air flow direction ...the mass flow is increasing, and the difference in the total efficiency is important with the increasing of the mass ...the mass flow increases, the cells ...
7
IMPACT OF DRYING TEMPERATURES AND AIR MASS FLOW RATES ON THE DRYING PERFORMANCE OF A PARABOLIC TROUGH SOLAR COLLECTOR (PTSC) USED FOR DEHYDRATION OF APRICOTS
... air mass flow rate. This is because at a high mass flow rate, more air was pumped into the collector that resulted in more heat delivery to the drying ...air mass flow ...air ...
8
Thermal Stratification In Vertical Solar Water Heater Tank
... different mass flow rates, also to study the variation of the thermocline region and the deviation of ...a mass flow rate of 20 kg/h the variation of the temperature in the tank at a ...
6
Fuzzy Sliding Mode Control for the Vehicle Height and Leveling Adjustment System of an Electronic Air Suspension
... (1) Height and leveling adjustment during the lift- ing procedure: In the lifting process, the charg- ing solenoid valve or the compressor is opened, thus the compressed air can flow into the four air springs. If ...
13
Performance Of Solar Air Heaters With Corrugated Absorber Plate- A CFD Approach
... the mass flow rate inlet boundary condition is specified. Mass flow rate inlet boundary conditions are commonly used to define the flow velocity, along with all relevant scalar ...
11
FOULING PHENOMENON AND ITS EFFECT ON HEAT EXCHANGER: A REVIEW
... and mass flow rates of the hot and cold fluids using both a physical method based on number of transfer unit relations and a black box model that is estimated using a clean heat ...parallel ...
12
Performance evaluation on an air cooled heat exchanger for alumina nanofluid under laminar flow
... concentrations (0.5, 1.0, and 1.5 wt.%). The experiments in this study measured the thermal conductivity and viscosity of nanofluid with weight fractions and sample temperatures (20-60°C), and then used the nanofluid in ...
11
Assessment and development of the gas kinetic boundary condition for the Boltzmann equation
... i) mass flow rates in both Poiseuille and thermal transpiration flows are measured for the same gas and solid surface interaction, which poses an ideal and strict test of the boundary conditions, and ...
26
Selection of the Capillary Tubes for Retrofitting in Refrigeration Appliances
... for mass flow rates of helical and serpentine with straight tubes, ...for mass flow rates of serpentine and helical coiled tube ...
7
Heat transfer Analysis of Automobile Radiator with Helical Tubes using CFD
... Abstract: To guarantee smooth running of a vehicle under the factor load conditions, cooling systems have to perform effectively. The coolant traces the engine block absorbs the heat, when streamed through the radiator ...
5
Design Evalution and Optimization of Nozzle Used in Diesel Engine Fuel Injector
... of flow, speed, direction, mass, shape, and/or the pressure of the stream that exhaust from ...different mass flow rates to determine the pressure drop, heat transfer coefficient, and ...
5
Solving the Boltzmann equation deterministically by the fast spectral method : application to gas microflows
... the mass and heat flow rates is assessed, and the Onsager-Casimir relation at the microscopic level for large Knudsen numbers is ...of mass flow rates along a rectangular tube ...
29
Performance trade-off studies for a retrofit Hybrid Laminar Flow Control system
... laminar flow control (HLFC) system to a medium-sized aircraft, is ...suction mass flow rates, and therefore in pump power requirements and suction system ...suction rates by nearly 25%, ...
12
Application of Aspen HYSYS process simulator in green energy revolution: A case study of biodiesel production
... Table-2 gives the mass flow rates of the components involved in the reaction of the conventional process of biodiesel production for green energy revolution, which has been simulated wit[r] ...
13
Phase and Velocity Distribution in Two Phase Adiabatic Annular Dispersed Flow EUR 3759
... An idea of the accuracy of the local values of liquid., and gas specific mass flow rates with twophase flow can be given, as in the single phase flow case, by a comparison between the i[r] ...
98
Aerostatic Spherical Bearing for Mass Properties Machine (MPM)
... the mass flow rate, position of orifices for equal inward and outward mass flow rates, pressure at any position on the spherical bearing surface, the thrust load capacity and stiffness ...
5
Numerical Simulation of Flow through a Centrifugal Impeller
... the flow through an impeller (backward curved) of a centrifugal ...design mass flow ...of flow through the impeller at different flow coefficients. The flow pattern observed ...
7
Performance Evaluation of Single Bed Desiccant Desorption Process
... Figures 2-5 illustrate the variation of the outlet to inlet air humidity ratio with the regeneration time for a differ- ent air mass flow rates and inlet hot air regeneration tem- perature. It can be ...
7