• No results found

NaCl-KCl

Electrolytic Refining of High Carbon Ferrochromium to Produce Pure Ferrochromium in NaCl-KCl Melt

Electrolytic Refining of High Carbon Ferrochromium to Produce Pure Ferrochromium in NaCl-KCl Melt

... of electrorefining of high carbon ferromanganese (HCMnFe) to produce pure ferromanganese and hierarchical porous carbon in molten salts [19]. Recently, the electrochemical behavior of Cr 2+ in molten ...

12

Predominance Diagrams of Spent Nuclear Fuel Materials in LiCl-KCl and NaCl-KCl Molten Salt Eutectics

Predominance Diagrams of Spent Nuclear Fuel Materials in LiCl-KCl and NaCl-KCl Molten Salt Eutectics

... One instance where the possibility of selective electro-reduction is not desired is for U and Pu. This is for anti-proliferation reasons. The predominance diagrams for Pu are superimposed onto those for U, in ...

19

BaCe0.9Er0.1O3-α-NaCl-KCl Composite As Electrolyte for Intermediate Temperature Solid Oxide Fuel Cells

BaCe0.9Er0.1O3-α-NaCl-KCl Composite As Electrolyte for Intermediate Temperature Solid Oxide Fuel Cells

... The performance of single cell based on a BCEr10-NaCl-KCl electrolyte (thickness = 1.15 mm) was tested by using hydrogen as the fuel and oxygen as the oxidant at 700 °C. The I-V and power density curves are ...

9

Preparation of Cr-Ni Alloy by Electrochemical Codeposition in a NaCl-KCl-NaF-Cr2O3-NiO Molten Salt

Preparation of Cr-Ni Alloy by Electrochemical Codeposition in a NaCl-KCl-NaF-Cr2O3-NiO Molten Salt

... where △G θ is the standard Gibbs free energy change (kJ·mol −1 ), n is the electron transfer number and F is the Faraday's constant (96485 C·mol −1 ). As shown in Fig. 1, the theoretical decomposition voltages of ...

12

The Electroreduction of Gadolinium and Dysprosium Ions in Equimolar NaCl KCl Melt

The Electroreduction of Gadolinium and Dysprosium Ions in Equimolar NaCl KCl Melt

... obtained by the electrochemical complex Autolab PGST 30 (Ecochemic, Holland), which was paired with the computer. Equimolar mixture of NaCl-KCl was used by solvent. It was prepared from previously ...

8

The Electrochemical Behavior of Cr(II) Ions in NaCl-KCl Melt

The Electrochemical Behavior of Cr(II) Ions in NaCl-KCl Melt

... The electrochemical properties of Cr (Ⅱ) ions was investigated by means of cyclic voltammetry, square wave voltammetry, chronopotentiometry, and chronoamperometry which were equipped by a powersuite software in a ...

11

Preparation of a Cr coating on low-carbon steel by electrodeposition in a NaCl-KCl-NaF-Cr2O3 molten salt

Preparation of a Cr coating on low-carbon steel by electrodeposition in a NaCl-KCl-NaF-Cr2O3 molten salt

... The dried reagents were placed in a high-purity zirconia crucible and placed in a resistance furnace. The furnace temperature was controlled by an artificial intellective controller (Model: AI-808p) and measured by a ...

11

Effect of Electrolytic Conditions on Electrodeposition of Manganese in NaCl-KCl Melt

Effect of Electrolytic Conditions on Electrodeposition of Manganese in NaCl-KCl Melt

... present. Actually, the low concentration results in concentration polarization and high overpotential. Thus the crystal nucleating current density is bigger than growing current density, and the growth of the crystal is ...

10

Pulsed Current electrodepostion of manganese in NaCl-KCl- MnCl2 melt

Pulsed Current electrodepostion of manganese in NaCl-KCl- MnCl2 melt

... During the initial stage of electrolysis, the concentration of metal ions in the vicinity of an electrode is as large as the bulk concentration. According to equation (1), the nuclei number is small, leading to cathode ...

8

Synthesis of Sn0.9Al0.1P2O7−δ/KSn2(PO4)3 Composite Electrolyte Using NaCl/KCl Molten Salt

Synthesis of Sn0.9Al0.1P2O7−δ/KSn2(PO4)3 Composite Electrolyte Using NaCl/KCl Molten Salt

... The intermediate temperature electrical properties and fuel cell performance of the Sn0.9Al0.1P2O7−δ/KSn2PO43 were explored in depth.. EXPERIMENTAL The Sn0.9Al0.1P2O7−δ/KSn2PO43 was synt[r] ...

8

Dissolution Characteristics and Electrochemical Mechanism of NaCl-NaF-KCl-SiO2 Melt

Dissolution Characteristics and Electrochemical Mechanism of NaCl-NaF-KCl-SiO2 Melt

... Fig.1 showed the binary phase diagram and DTA for NaCl-KC-NaF. According to the principle of differential thermal analysis, the first peak on the left in Figure (b) indicates the complete solidification ...

11

The effect of sodium chloride substitution with potassium chloride on chemical, physical and microbiological characteristics  of Mediterranian cheeses

The effect of sodium chloride substitution with potassium chloride on chemical, physical and microbiological characteristics of Mediterranian cheeses

... with KCl on chemical, physical, microbiological and sensory properties of selected Mediterranean ...with KCl at four different levels (only NaCl, 3NaCl:1KCl, 1NaCl:1KCl, and ...with ...

190

The mechanism of action of the antidiuretic peptide Tenmo ADFa in
Malpighian tubules of Aedes aegypti

The mechanism of action of the antidiuretic peptide Tenmo ADFa in Malpighian tubules of Aedes aegypti

... transepithelial NaCl, KCl and water secretion by approximately the same extent (~50%), without effects on voltage and resistance measured across the tubule or in principal ...

12

Influence of the Second Coordination Sphere on the Electrochemical Behavior of Chromium Complexes in Chloride Melts: Experimental and Calculation Methods

Influence of the Second Coordination Sphere on the Electrochemical Behavior of Chromium Complexes in Chloride Melts: Experimental and Calculation Methods

... An assumption as to formation of polynuclear complexes does not agree with the result of [18], where formal standard potentials of Cr(III)/Cr(II) and Cr(II)/Cr were determined in alkali chloride melts, and no deviations ...

18

Sodium chloride reduction in bread: chemical and sensory characterization among teenagers

Sodium chloride reduction in bread: chemical and sensory characterization among teenagers

... Additionally, our palate is more exposed to low-level sodium diets, it develops a greater sensibility to the salty taste and vice versa. Therefore, since we know that the teenager public consumes a high sodium level, it ...

6

Rheological and textural properties of sodium reduced salt soluble myofibrillar protein gels containing sodium tri polyphosphate

Rheological and textural properties of sodium reduced salt soluble myofibrillar protein gels containing sodium tri polyphosphate

... 3% NaCl added group (T2) had higher (P<0.05) WHC than that with 1.5% NaCl and ...1.5% KCl (T3). KCl exhibited lower protein extractability than NaCl (Munasinghe and Sakai ...

24

Determination of critical micelle concentration of cetyltrimethylammonium bromide in presence and absence of KCl and NaCl in aqueous media at room temperature by viscosity measurement

Determination of critical micelle concentration of cetyltrimethylammonium bromide in presence and absence of KCl and NaCl in aqueous media at room temperature by viscosity measurement

... of KCl is more than in presence of NaCl(Table1), this is because while NaCl is absorbed on the surface of the micelle, KCl remains in the bulk of the solution ...order: ...

5

Vapor Pressure Measurements for Metal Chloride Systems by the Knudsen Effusion Method

Vapor Pressure Measurements for Metal Chloride Systems by the Knudsen Effusion Method

... the KClNaCl system exhibit same behavior with ideal solution and ideal gas, ...of KCl decreased becauae its vapor pressure was slightly higher than that of ...

6

Chloride conductance across toad skin: effects of ionic acclimations and cyclic AMP and relationship to mitochondria rich cell density

Chloride conductance across toad skin: effects of ionic acclimations and cyclic AMP and relationship to mitochondria rich cell density

... Toads (Bufo viridis) were of local origin. They were maintained in the laboratory (19–22 °C) with free access to tapwater (40–50 mosmol kg −1 ; approximately 15 mmol l −1 Cl − ) and fed mealworms once a week. For ...

7

A water soluble core material for manufacturing hollow composite sections

A water soluble core material for manufacturing hollow composite sections

... For the current work, extra fine NaCl powder with an average particle size of 0.59 mm was used to manufacture the cores, referred to here as NT Cores. Trehalose sugar was used as the binder material, which had a ...

11

Show all 1327 documents...

Related subjects