• No results found

Power densities

Preparation of Delithiated LixCoO2 as Cathode Material for High Power Densities Primary Lithium Batteries

Preparation of Delithiated LixCoO2 as Cathode Material for High Power Densities Primary Lithium Batteries

... C, respectively. It can be seen that all the capacities of Li/DLCO cells drop with the temperature decreasing. The discharge capacities of 132.65, 111.13, 108.99, 94.83 and 90.06 mAh g −1 can be achieved at 25, 15, 10, 5 ...

11

Shifts in Photon Spectral Power Densities within Schumann (7 7 to 7 8 Hz) Values in Microtubules during Complex Magnetic Field Exposures May Reflect an Information Interface with Universal Energies

Shifts in Photon Spectral Power Densities within Schumann (7 7 to 7 8 Hz) Values in Microtubules during Complex Magnetic Field Exposures May Reflect an Information Interface with Universal Energies

... Considering the preponderance of the aromatic amino acids with aggregates of π orbital electrons able to de- localize across discrete spatial regions, photon emissions would be expected even without conspicuous ...

12

Health Effects of High And Low Power Densities of Mobile Phone Tower Radiation On Nearby Inhabitants – Case Study

Health Effects of High And Low Power Densities of Mobile Phone Tower Radiation On Nearby Inhabitants – Case Study

... localities. Power densities were measured in different places in both the ...that power density is much higher in the area where there is mobile tower than the area where there is no mobile ...

6

Analysis of high torque and power densities outer rotor PMFSM with DC excitation coil for in wheel direct drive

Analysis of high torque and power densities outer rotor PMFSM with DC excitation coil for in wheel direct drive

... of power versus speed characteristics between the final design machine and conventional IPMSM are also analyzed in the same ...the power curve characteristic of IPMSM increases up to the maximum point but ...

8

Polypyrrole-coated Graphite Fluorides with High Energy and High Power Densities for Li/CFx battery

Polypyrrole-coated Graphite Fluorides with High Energy and High Power Densities for Li/CFx battery

... emergency power source, memory back-up, military and implantable medical devices ...require power sources with high energy densities, good reliability, safety and long ...

10

Magnetic Field Configurations Corresponding to Electric Field Patterns That Evoke Long Term Potentiation Shift Power Spectra of Light Emissions from Microtubules from Non Neural Cells

Magnetic Field Configurations Corresponding to Electric Field Patterns That Evoke Long Term Potentiation Shift Power Spectra of Light Emissions from Microtubules from Non Neural Cells

... magnetic field configuration corresponding to the electric field pattern that induced long-term potentiation in neural tissue when applied as electric current displayed peaks of spectral power densities ...

8

Online Adaptive Battery Parameters Identification, and State of Charge (SOC) and State of Health (SOH) Co-Estimation.

Online Adaptive Battery Parameters Identification, and State of Charge (SOC) and State of Health (SOH) Co-Estimation.

... and power densities and to reduce ...and power densities, making them very attractive for plug-in hybrid electric vehicles (PHEVs) and in general electric-vehicle (EV) use to improve the ...

202

Formation of tungsten oxide nanostructures by laser pyrolysis: stars, fibres and spheres

Formation of tungsten oxide nanostructures by laser pyrolysis: stars, fibres and spheres

... and 0.3. The higher power densities were found to be essential for the further growth of structures and for smal- ler particle sizes. The authors now have an idea of the pos- sible shapes of nanostructures ...

8

Cell Phone Radiation and Genomic Damage: In Vitro Exposure and Assessment

Cell Phone Radiation and Genomic Damage: In Vitro Exposure and Assessment

... dBm power level there was increase in chromosomal damage with longer exposure times as compared to control and sham-exposed ...both power densities 20 dBm and 30 dBm were compared for different time ...

5

Wind Energy Potential Assessment in Selected Regions in Northern Cyprus
Based on Weibull Distribution Function

Wind Energy Potential Assessment in Selected Regions in Northern Cyprus Based on Weibull Distribution Function

... In the present study, wind speed data have been collected from the Meteorological Department, where wind speeds were measured using a cup anemometer at a height of 10m. Wind speed data was collected for the seven-year ...

13

An overview of lithium-ion battery cathode materials

An overview of lithium-ion battery cathode materials

... For over a century, petroleum-derived fuels have been the first choice as an energy source for transportation, and accounted for more than 71.4% of U.S. petroleum use in 2009 [1]. Although the petroleum-based fuel energy ...

6

Design and optimisation of outer rotor hybrid excitation flux switching motor

Design and optimisation of outer rotor hybrid excitation flux switching motor

... constant power applications. In conventional PM machines, high torque and power densities are not the issue for a single operating point ...additional power converter for DC coils as in the ...

60

Numerical Analysis Of A Radio Frequency-Assisted Convective Drying

Numerical Analysis Of A Radio Frequency-Assisted Convective Drying

... of power densities and heat trasfer ...of power densities and heat transfer coefficient increases temperature and decreases moisture in the product because the boundary conditions for heat and ...

8

Deposition of DLC Films onto Oxynitriding Treated V4E High Vanadium Tool Steel through DC Pulsed PECVD Process

Deposition of DLC Films onto Oxynitriding Treated V4E High Vanadium Tool Steel through DC Pulsed PECVD Process

... er densities of the DC-pulsed PECVD after the ...different power densities of the DLC/oxynitriding-treated V4E specimens is shown in Table ...

7

Performance improvement of a direct carbon solid oxide fuel cell through integrating an Otto heat engine

Performance improvement of a direct carbon solid oxide fuel cell through integrating an Otto heat engine

... 3.2 Power density improvement of the proposed system The equivalent power densities of the DC-SOFC, Otto heat engine and proposed system 14... * are compared at different operating tempe[r] ...

46

Integrated motor drives: state of the art and future trends

Integrated motor drives: state of the art and future trends

... The maximum operational temperature of a semiconductor material is determined by the bandgap. The temperature limit is reached when the number of intrinsic carriers approaches the number of purposely added (extrinsic) ...

15

Electrodeposition of Nanocrystalline Zinc on Steel Substrate from Acid Sulphate Bath and its Corrosion Study

Electrodeposition of Nanocrystalline Zinc on Steel Substrate from Acid Sulphate Bath and its Corrosion Study

... Nanocrystalline zinc was electrodeposited on steel substrates from acid sulphate bath. The condensation product formed between Glycyl-glycine (GGL) and Veratraldehyde (VTL) was used as brightener. The effect of bath ...

17

Performance Assessment and Parametric Design of a Combined System Consisting of High-Temperature Proton Exchange Membrane Fuel Cell and Absorption Refrigerator

Performance Assessment and Parametric Design of a Combined System Consisting of High-Temperature Proton Exchange Membrane Fuel Cell and Absorption Refrigerator

... output power and efficiency for HT-PEMFC, APR and the combined system are derived and the optimum operating regions of system performance parameters are ...

17

 ISOLATION AND PHYSICOCHEMICAL CHARACTERIZATION OF CROSSBREED AND OPEN POLLINATED MAIZE STARCHES FROM ETHIOPIA

 ISOLATION AND PHYSICOCHEMICAL CHARACTERIZATION OF CROSSBREED AND OPEN POLLINATED MAIZE STARCHES FROM ETHIOPIA

... The various powder properties of the crossbreed and open pollinated maize starches obtained during the study are depicted in Table 1. Both the bulk and tapped densities of BH-546 Zea mays starch are higher than ...

6

Estimation of Peaked Densities Over the Interval [0,1] Using Two Sided Power Distribution: Application to Lottery Experiments

Estimation of Peaked Densities Over the Interval [0,1] Using Two Sided Power Distribution: Application to Lottery Experiments

... peaked densities over the interval [0,1] using two# sided power distribution (Kotz, van Dorp, ...two#sided power distribution (TP) and its generalized form ...equivalent densities in two data ...

21

Show all 10000 documents...

Related subjects