room-temperature deposited films
Article Electrical Properties of Low-Temperature Processed Sn-doped In 2O3 thin films: The Role of Microstructure and Oxygen Content and the Potential of Defect Modulation Doping
... of room temperature deposited films w ith d ifferent fi lm th ickness in di fferent en vironments allow to discriminate between the effects of crystallization, grain growth, donor activation ...
14
SYNTHESIS AND STRUCTURAL CHARACTERIZATION OF ELECTRODEPOSITED CONIP ALLOY THIN FILM
... electroplating bath prepared by all the reagent grade chemicals was dissolved in triple distilled water. The pH value of the bath was adjusted to 6 by adding few drops of ammonia solution. The CoNiP thin films ...
7
Microstructure evolution of Al–Mg–B thin films by thermal annealing
... thin films, with good capability of accurately preserving the target stoichiometry in the film due to congruent ablation induced by high-intensity laser irradiation of the ...as-deposited films are ...
12
Characteristics and Mechanism of Cu Films Fabricated at Room Temperature by Aerosol Deposition
... Cu films showed broader peaks and high full width at half maximum (FWHM) in comparison with that of the Cu ...ceramic films is mainly influenced by the reduction in crystallite size [17, 19, ...Cu ...
8
Annealing Effect on the Physical Properties of dc Reactive Magnetron Sputtered Nickel Oxide Thin Films
... thin films were successfully deposited by dc reactive magnetron sputtering at room temperature and annealed at various ...The films showed (200) as preferred orientation at all ...
6
Temperature Dependent Properties of Spray Deposited Nanostructured ZnO Thin Films
... of room temperature PL emission spectrum for ZnO sample measured in the wavelength range of 350–650 nm at an excitation wavelength of 330 ...thin films has been attributed to structural defects such ...
11
Pd Nanoparticles and Thin Films for Room Temperature Hydrogen Sensor
... Palladium nanostructures were deposited on conductive Si (100) substrates (resistivity = 0.005 X-cm) through po- tentiostatic electrodeposition [21, 22]. An amount of the electrolyte, consists of Pd sulfate and ...
6
Fabrication and characterization of Phosphate-based planar waveguides activated by Er3+ ions
... at room temperature. The films were deposited on clean silica substrates with roughness of about 2 ...nm. Films were formed by dip-coating, with a dipping rate of 40 ...
200
Formation of TiO2 Nanopores by Anodization of Ti Films
... Ti films deposited by RF magnetron sputtering at room temperature and ...Both films have fine granular structure, but more rough and some Ti grain coarse at 500˚C it was ...at ...
9
Study of ferromagnetic paramagnetic phase transition in two dimensional Fe/Mo(110) epitaxial films
... Fe films on Mo(110) substrate grown at 300 K and at 512 K are shown in ...At room temperature ...the films deposited at room temperature was ...the temperature at ...
11
Magnetron Sputtering of Gadolinium-doped Ceria Electrolyte for Intermediate Temperature Solid Oxide Fuel Cells
... of films deposited at room temperature substrates may be caused by radiation enhanced ...The films grown under higher peak power density become denser, because ion bombardment the ...
10
Study of a sandwich structure of transparent conducting oxide films prepared by electron beam evaporation at room temperature
... Figure 3a shows the relationship between transmittance and wavelength for the sandwich structure prepared by depositing an Ag layer with and without IAD for the glass and plastic substrates. The ZnO layers were of ...
5
Relevance of Microstructure on Optical Properties of Thermally Evaporated Indium Oxide Thin Films
... thin films of thickness about 100 nm have been deposited using ther- mal vacuum evaporation technique at room temperature on glass and quartz substrates and sub- sequently annealed at ...
15
Cohesive strength of nanocrystalline ZnO:Ga thin films deposited at room temperature
... nominal strains. The PEN substrate is isotropic, and the elastic modulus was 4.23 GPa, as measured through the tensile test on uncoated substrate. The cracking densi- ties as a function of the substrate nominal strain ...
5
Enhanced electrical and optical properties of room temperature deposited Aluminium doped Zinc Oxide (AZO) thin films by excimer laser annealing
... low temperature growths, industrial applicability, as well as relatively good uniformity and reproducibility ...combined room temperature pulsed laser deposition and ELA (KrF 248 nm) resulting in ...
8
Semiconductor-to-metal Transition Control in Novel VO2/Silicon and VO2/Sapphire Epitaxial Thin Film Heterostructures for Device Applications.
... these films was performed at Inter University Accelerator Centre New Delhi, India in Materials Science beam ...irradiated films were recorded with a Horiba Jobin Yvon LabRam ARAMIS using a 633 nm laser ...
191
Superhard self lubricating AlMgB14 films for microelectromechanical devices
... when deposited at room temperature and 573 K, ...as- deposited films are amorphous, regardless of substrate temperature; however, analysis of Fourier transform infrared spectra ...
6
Infrared Spectroscopy of Titania Sol Gel Coatings on 316L Stainless Steel
... derived films were recorded using a Perkin Elmer FTIR ...thin films and allows investigation of the sample in depth layers by varying the incidence angle of the infra- red ...
8
Temperature Effects on Gas Sensing Properties of Electrodeposited Chlorine Doped and Undoped n Type Cuprous Oxide Thin Films
... undoped films showed a good response to the gas by increasing/decreasing the electrical resis- tance by ...thin films showed a negative response (ΔR < 0) at all ...
9
Substrate Temperature Effect on Optical property of ZnO Thin Films
... thin films have been deposited on glass substrate by Ultrasonic spray at different substrate temperatures between 300 and 400 ...the films having high transparency in the visible region, the band gap ...
8