Solid Volume Fraction
Buoyancy Driven Heat Transfer of Water-Based CuO Nanofluids in a Tilted Enclosure with a Heat Conducting Solid Cylinder on its Center
... of solid volume ...increasing solid volume fraction is also a fact, although it does not compensate for the increase in the thermal energy from the hot wall to the nanofluid due to ...
5
Nonlinear Rosseland thermal radiation and energy dissipation effects on entropy generation in CNTs suspended nanofluids flow over a thin needle
... ues of the skin friction coefficient increase for both types of nanofluids. The decreasing behavior of the skin friction coefficient is observed with increasing values of the veloc- ity ratio parameter ε. The local Nusselt ...
14
CFD investigation of coal gasification: Effect of particle size
... The simulated case is a bubbling fluidised bed coal gasifier designed and built for studying the gasification of Columbian coal [3]. The schematic view of the gasifier is shown in Fig-1 the reactor has an internal ...
5
Controlling Barrier Property of Polypropylene Meltblown Nonwoven.
... Pore size is one of the most critical parameter of a nonwoven medium to determine its barrier property. The literature revealed that pore size is a function of fiber diameter and solid volume ...
119
Analysis of Magneto-hydrodynamics Jeffery-Hamel Flow with Nanoparticles by Hermite-Padé Approximation
... The combined effects of nanoparticles and magnetic field on the nonlinear Jeffery-Hamel flow are analyzed in the present study. The basic governing equations are solved into series solution using a semi-numerical ...
9
Numerical Study of Natural Convection in a Partitioned Square Cavity Filled with Nanofluid - Volume 2 Number 4 (Aug. 2011) - IJCEA
... Although a lot of studies have been carried out to investigate the role of nanofluids in cavities, most of them have considered cavities without partition. To our knowledge very little work has been done on partitioned ...
7
Slip Flow of Nanofluids between Parallel Plates Heated with a Constant Heat Flux
... Variation of the average Nusselt number with the slip factor is seen in Figs. 4 to 6 for various values of the Brinkman number, solid volume fraction, and the ratio of liquid layering thickness to ...
10
CFD simulation of bubbling fluidized bed: Effect of distributor plate orifice pattern configuration on hydrodynamics of gas solid mixing
... of solid volume fraction. It shows a low solid volume fraction in the annular region while the regions near to the walls are experiencing high concentration of ...
6
Assessment of Particle-size and Temperature Effect of Nanofluid on Heat Transfer Adopting Lattice Boltzmann Model
... Increasing the nanoparticles have a substantially impact on the velocity and temperature of nanofluid. By adding nanoparticles, the vertical velocity decreases in the areas near the left wall of the enclosure while it ...
11
Nanoparticle shape effects on squeezed MHD flow of water based Cu, Al2O3 and SWCNTs over a porous sensor surface
... the solid volume fraction and nanoparticle shape have powerful outputs in squeezing flow phenomena, the sphere shape nanoparticle in Cu – water and cylindrical shape in SWCNTs-water in the presence ...
13
Numerical study of natural convection in a square cavity with partitions utilizing Cu-Water nanofluid
... increasing volume fraction of nanoparticles, in particular at the higher Rayleigh ...number, volume fraction and partitions location on the average Nusselt number are ...
14
Solidification Path and Solute Redistribution of an Iron Based Multi Component Alloy with Solute Diffusion in the Solid*
... The micro-segregation of an iron-based multi-component alloy, where the liquid is assumed to be completely mixed and finite diffusion works in the solid, is calculated by a simple method. With this method, not ...
7
Synthetic myocardial extracellular volume fraction
... extracellular volume fraction (ECV) assessed by cardiovascular magnetic resonance imaging (CMR) estimates the extent of the myocardial extracellular space relative to its cellular ...
5
Flat Belt Separation System under Slat in Fattening Pig Housing: Effect of Belt Slope Angle
... The effect of slope angle on average production of liquid fraction (AVLF) and total solids content (TS) of liquid fraction are presented in Table 6. As shown, no differences between slope angles were found, ...
11
Interactions between casein layers adsorbed on hydrophobic surfaces from self consistent field theory: kappa-casein versus para-kappa-casein.
... carbohydrate part of the protein plays in providing the functional behaviour of -casein. That the outer part of the “hairy” -casein layer consists of these carbohydrate moieties is best demonstrated by the graph of ...
40
Finite Element Simulation of Liquid Phase Sintering with Tungsten Heavy Alloys
... Densification and distortion of W-Ni-Fe tungsten heavy alloys during liquid phase sintering are modeled using constitutive laws of grain growth, densification, and deformation. The models are ‘‘calibrated’’ via carefully ...
8
Dense, collisional, shearing flows of compliant spheres
... Above a volume fraction of 0.49, at which a first- order phase transition between disordered and ordered states in an equilibrated system of colliding hard spheres is first possible [7,8], molecular ...
7
Effect of total solid concentration on anaerobic digestion of the organic fraction of municipal solid waste
... Anaerobic digestion technology has tremendous application in the future for sustainability of both environment and agriculture because it represents a feasible and effective waste-stabilization method to convert the ...
5
Shock dissipation in magnetically dominated impulsive flows
... Our simulations have shown that, at least in the case where shells and gaps have comparable widths, the tail–head collision strongly modifies the flow dynamics, making the results for an isolated shell irrelevant. The ...
21
FIBER REINFORCED CONCRETE A BETTER MATERIAL FOR CONSTRUCTION
... FRC composite properties, such as crack resistance, reinforcement and increase in toughness are dependent on the mechanical properties of the fibre, bonding properties of the fibre and matrix, as well as the quantity and ...
8