... premolar metal brackets were selected according to their different mesh designs: (G1, Gemini Series,3M Unitek; G2,Micro Sprint, Forestadent; G3,Equilibrium 2,Dentaurum and G4,Mini-Master Series, American ...
... Traditional bond materials must be applied in completely dry and isolated fields to achieve adequate bond ...Hydrophilic bond systems have been an important development in orthodontic practice ...
... the bracket base has been shown to increase the bondstrength of new brackets to enamel by removing unfavorable oxides, contaminants on the base, and increasing surface roughness and ...
... fixed orthodontic appliance, but the use of this treatment could not improve bondstrength in case of moderate ...this study was higher than our study and these may be the factors ...
... of enamel surfaces exposed in vitro to four different bleaching agents that contained 10% carbamide peroxide or 30% hydrogen ...this study, ten freshly extracted, non carious human maxillary ...
... during different step of orthodontic bracketing is still debatable due to its effect on SBS of orthodontic brackets ...in bondstrength of orthodontic brackets in enamel ...
... The study and evaluation of the adhesive potential of a specific bonding system are complicated, as there are multiple variables that can influence the survival or longevity of the bracket-enamel ...
... A total number of 80 human permanent incisors, without caries, obvious defects, or attrition, extracted for peri- odontal causes over a period of 6 months, were selected for this study. The teeth were thoroughly ...
... in-vitrostudy has been done to evaluate and compare the tensile bondstrength of two different resin cements used to bond base metal alloy to human ...that enamel ...
... important orthodontic milestone that replaced the arduous task of banding and then the evolution of fixed appliance became ...to bondorthodontic brackets has reduced patient chairside time, reduced ...
... a bondstrength of 6-8 MPa would be clinically ...in orthodontic bonding studies to enamel and non-tooth ...in vitrobond strengths has been ...in vitro is clinically ...
... to bond the orthodontic ...bonding enamelsurface contamination can occur at two critical stages of the bonding procedure: after the tooth surface has been etched and after the primer ...
... this study was to evaluate the bondstrength of orthodontic brackets bonded to tooth enamel with different polymer composites after simulated clinical aging, and analyze ...
... porcelain surface are not amenable to resin penetration for orthodontic bonding, mechanical or chemical pre-treatments of the surface is essential for successful direct bonding to ...various ...
... this study was to evaluate the enamel roughness and shearbondstrength (SBS) of dental composite after removal of metal brackets bonded with dif‑ ferent materials ...
... enamelsurface as etchant. The enamelsurface is then rinsed and dried before applying the ...acceptable bondstrength ...cause enamel fracture ...the bond ...
... internal surface of the mold was coated with petroleum jelly and the teeth were fixed using 16x22 inch rectangular stainless steel ligature ...The shearbondstrength test was performed in ...
... Dentine bondstrength and microleakage of flowable composite, compomer and glass ...a bond between two resin layers,flowable composite is expected to bond well with the more viscous resin ...
... patients) bonded with the direct technique and group B (19 patients) bonded with the indirect ...of bracket failure were recorded for over 15 ...on bracket failures was ...total bond ...