[PDF] Top 20 Determination of the thermal properties of thin polymer films

... in this freezer environment, a change of film thickness or. conductivity is not significant[r] ... See full document

... the determination of the mechanical properties of thin films and coatings at a rapid ...in thin films [2-7], have presented inconsistent ...confined thin polymer ... See full document

... the polymer and substrate, as suggested by ...the polymer- substrate interactions, which are generally known to influence the physical properties of polymer thin films, do not ... See full document

... preparation Thin film bio-polymer composites are prepared by mixing the monomer with cross-linker and treated graphite filler of 2,4,6,8,10% weight to weight ratio of bio-monomer using a mechanical ... See full document

... using polymer precursor of zinc nitrate, ferric nitrate and polyvinyl alcohol ...nanocomposite films were prepared by solvent casting ...nanocomposite films have thermal stability up to 360 0 ... See full document

... and thermal interaction between the cantilever and the ...nanostructured thin film, thus enabling contactless thermal imaging with nanoscale ... See full document

... occurring beyond a penetration depth of - 45nm. This indicates that the influence of tip effects diminishes after this point. Rows 5-10 show the influence of substrate w ith an increase in m odulus, with indents 5,6 & 7 ... See full document

... optical properties of Se films for 500 nm thickness at different annealing temperatures have been study by UV-Visible transmittance ...as-deposited films have been illustrated in Fig ... See full document

... ZnO films have been deposited on glass slide substrates at room temperature by thermal evaporation ...tural properties of as-deposited films have been compared with those of the annealed ... See full document

... some properties suggestive of a rejuvenated state such as quicker dynamics, but differs significantly in terms of spatial and temporal heterogeneity of relaxation times 12,13 ...mechanical properties from ... See full document

... CdO films have been deposited on glass substrate by thermal evaporation in vacuum better than 5x10 -5 mbar without heating the ...for thermal evaporation were prepared by taking appropriate amount of ... See full document

... Optical transmittance exhibits values exceeding 70% in the visible and infrared (IR) regions on the two substrates. CdS deposited on PET records 2.48 eV and CdS deposited on PI obtains 2.47 eV of optical band gap (E g ) ... See full document

... diffraction; thermal expansion; diffraction grating; ...and polymer-based devices have been increasingly studied due to their potential application in optoelectronics, such as field emission transistors ... See full document

... each polymer layer ...bilayer polymer film work reported by Damin et ...each polymer in the film, which has been previously proposed by us to measure mixed polymer films, 34 and ... See full document

... CSA films were thus obtained by casting films on glass plates using spin coater and subsequently dried for 24 hrs on a hot plate at 50 o ...PANI-CSA films cast from solution, the PANI chains are ... See full document

... insulation properties was good and thermal constancy dependent on sense of ...optical properties decisive about its wide applications and attractive ...transparent polymer with owned ... See full document

... pentacene thin films using a scan size of 1  1µm 2 ...pentacene films were well deposited for all deposition times but not homogenous due to the bulk phase of the pentacene ...pentacene films ... See full document

... The films were subsequently annealed in a commer- cial rapid thermal annealing set up under forming gas envi- ronment (5%H þ 95%N 2 ) at 600  C for annealing times of 30, 60, and 90 ... See full document

... solid thin films does trigger c-AB → t-AB isomer con firmation, and after discounting the thermal isomerization e ffect, the isomerization due to pure ultrasound could be observed to be about 46% in 2 h, with ... See full document

... a thin film in order to increase the mechanical and chemical compatibility between coating and ...the thin film. In the published work the mechanical properties were evaluated by ... See full document