• No results found

Heat transfer network in the Co-flow HEX model

A three-dimensional numerical model of borehole heat exchanger heat transfer and fluid flow

A three-dimensional numerical model of borehole heat exchanger heat transfer and fluid flow

... borehole*can*be*considered*a*single*resistive*element.*This*can*be*argued*to*be*sufficient* for*applications*of*the*model*for*design*purposes*where*it*is*more*important*to*consider* ...

41

The Effect Of Frequency On Flow And Heat Transfer Of A Heat Exchanger In An Oscillatory Flow Condition

The Effect Of Frequency On Flow And Heat Transfer Of A Heat Exchanger In An Oscillatory Flow Condition

... of heat exchanger and heat exchanger networks. He found that the heat exchanger efficiency was a convenient approach for heat exchanger analysis, and can be used to solve ratio and sizing ...

24

Model validation for flow and heat 
		transfer characteristics of supercritical CO2 in mini channels

Model validation for flow and heat transfer characteristics of supercritical CO2 in mini channels

... with the experimental data obtained from (Liao and Zhao 2002). The experimental data consisted of three different cases with different inlet pressure (P), inlet temperature (Tin) and tube diameter (d). All the maximum ...

6

Investigation of boiling heat transfer and flow regimes in a heat exchanger

Investigation of boiling heat transfer and flow regimes in a heat exchanger

... four flow regimes is then subdivided into several flow ...Two-phase flow phenomena were investigated by [3] using boiling R113 and n-pentane in a 241-tube thin slice kettle ...

5

Heat transfer in borehole heat exchangers and the contribution of groundwater flow

Heat transfer in borehole heat exchangers and the contribution of groundwater flow

... the heat exchange between a borehole surface and the surrounding ground, with significant groundwater flow, is ...groundwater flow around a single borehole and neglecting gravitational ...numerical ...

123

Fluid Flow and Heat Transfer of Nanofluids over a Flat Plate with Conjugate Heat Transfer

Fluid Flow and Heat Transfer of Nanofluids over a Flat Plate with Conjugate Heat Transfer

... transfer became a main issue owing to low thermal conductivity of the most common fluids such as water , oil, and ethylene-glycol mixture. Since the thermal conductivity of solids is often higher than that of ...

10

EXPERIMENTS ON HEAT TRANSFER CHARACTERISTICS OF SHEAR-DRIVEN LIQUID FILM IN CO-CURRENT GAS FLOW

EXPERIMENTS ON HEAT TRANSFER CHARACTERISTICS OF SHEAR-DRIVEN LIQUID FILM IN CO-CURRENT GAS FLOW

... Young-Laplace model and kinetic theory-based expression for mass transport across the liquid-vapor ...the heat transfer was decreased with increasing channel size and/or wall superheat, and the ...

8

Hydraulic Network Modeling to Analyze Stream Flow Effectiveness on Heat Transfer Performance of Shell and Tube Heat Exchangers

Hydraulic Network Modeling to Analyze Stream Flow Effectiveness on Heat Transfer Performance of Shell and Tube Heat Exchangers

... Heat Transfer Coefficient Pressure Drop A B S T R A C T In this article, stream flow effectivness is based on hydraulic network studied in the shell-side of a shell and tube heat ...

8

Significance of Baffles in Fluid Flow and Heat Transfer

Significance of Baffles in Fluid Flow and Heat Transfer

... complex flow and temperature pattern in shell-and-tube heat exchanger using CFD code ...mass flow rates. it has been observed that there is significant heat transfer near the nozzle ...

20

A REVIEW OF HEAT TRANSFER AND LAMINAR FLOW IN A MICROCHANNEL

A REVIEW OF HEAT TRANSFER AND LAMINAR FLOW IN A MICROCHANNEL

... water flow and heat transfer characteristics in microchannel heat sink with triangular re-entrant ...laminar flow model with the conjugate heat transfer between the ...

6

Numerical Investigation Of Flow And Heat Transfer In Microchannel

Numerical Investigation Of Flow And Heat Transfer In Microchannel

... 8 Dirker et al. (2014) has conducted an experiment to investigate the effects of inlet geometry is on the friction factors, Nusselt numbers, and critical Reynolds number associated with a single channel of 0.57, 0.85, ...

24

Investigation of the characteristics of nanofluids flow and heat transfer in a pipe using a single phase model

Investigation of the characteristics of nanofluids flow and heat transfer in a pipe using a single phase model

... When the Brownian motion of nanoparticles is ignored, the average shear stress ratio for the Al 2 O 3 – water nanofluid with𝜒 = 2%, 4% and 6%, is approximately 1.35, 1.99 and 3.02 respectively. However, for the TiO 2 ...

30

Determination of heat transfer into a wedge model in a hypersonic flow using temperature-sensitive paint

Determination of heat transfer into a wedge model in a hypersonic flow using temperature-sensitive paint

... The change in intensity distribution on the model surface over time, brought about by the increasing surface temper- ature, can be clearly seen in the four raw images shown in Fig. 8 for the times t =1.8 ms, 2.6 ...

13

Optimization of Air Flow and Heat Transfer in a Convective Heat Shrink Oven.

Optimization of Air Flow and Heat Transfer in a Convective Heat Shrink Oven.

... the flow under study. The flow in the inner shell, for which most of the simulation is done, is similar to a turbulent flow in a duct where most of the fluid meanders at high speed through the core ...

92

Borehole Heat Exchangers: heat transfer simulation in the presence of a groundwater flow

Borehole Heat Exchangers: heat transfer simulation in the presence of a groundwater flow

... Borehole Heat Exchanger is crucial for the operation and the energy performance of a Ground Source Heat ...only heat transfer ...groundwater flow influence has to be assessed, by ...

10

Investigation of fluid flow and heat transfer of compressible flow in a constricted microchannel

Investigation of fluid flow and heat transfer of compressible flow in a constricted microchannel

... Abstract. Heat transfer and hydrodynamics of air ow in a constricted microchannel are numerically investigated by considering the eect of geometry, stagnation pressure and temperature at the inlet, and ...

10

INTENSIFICATION OF HEAT TRANSFER CO- EFFICIENT IN ECONOMIZER AND VALIDATION OF EXPERIMENTAL RESULTS BY ANALYSIS OF FLOW THROUGH CFD

INTENSIFICATION OF HEAT TRANSFER CO- EFFICIENT IN ECONOMIZER AND VALIDATION OF EXPERIMENTAL RESULTS BY ANALYSIS OF FLOW THROUGH CFD

... [6] A.N. Aziz, P. Siregar, Y.Y. Nazaruddin, and Y. Bindar Improving the Performance of Temperature Model of Economizer Using Bond Graph and Genetic Algorithm, International Journal of Engineering & Technology ...

12

Magneto nanofluid flow with heat transfer past a stretching surface for the new heat flux model using numerical approach

Magneto nanofluid flow with heat transfer past a stretching surface for the new heat flux model using numerical approach

... mathematical model has been developed to simulate the steady, laminar, magnetohydrodynamic, incompressible electrically-conducting nanofluid flow, heat and mass transfer from a stretching ...

21

Modelling Turbulent Heat Transfer in a Natural Convection Flow

Modelling Turbulent Heat Transfer in a Natural Convection Flow

... This work is licensed under the Creative Commons Attribution International License (CC BY). http://creativecommons.org/licenses/by/4.0/ Abstract In this paper a numerical study of a turbulent, natural convection problem ...

10

Heat transfer performance investigation of nanofluids flow in pipe

Heat transfer performance investigation of nanofluids flow in pipe

... phase model has been selected and the Reynolds number has been fixed to Re = ...axisymmetric model (Chapter 4) remains to be the same in case of θ = ...laminar flow and the transition begins at the ...

232

Show all 10000 documents...

Related subjects