• No results found

layer thicknesses

STACKiNG SEQUENCE OPTiMiZATiON OF COMPOSiTE BEAMS WiTH DiFFERENT LAYER THiCKNESSES

STACKiNG SEQUENCE OPTiMiZATiON OF COMPOSiTE BEAMS WiTH DiFFERENT LAYER THiCKNESSES

... of layer thicknesses (LT), satisfying the total thickness of the beam together, are considered for three ...the layer thicknesses are ob- tained for a variation of ...

5

Influence of indium-tin-oxide and emitting-layer thicknesses on light outcoupling of perovskite light-emitting diodes

Influence of indium-tin-oxide and emitting-layer thicknesses on light outcoupling of perovskite light-emitting diodes

... In the past several years, numerous strategies have been introduced to realize the full potential of PeLEDs. As a result, external quantum efficiency (EQE) as high as 20% has been achieved in PeLEDs in contrast to the ...

5

Unrelaxed State in Epitaxial Heterostructures Based on Lead Selenide

Unrelaxed State in Epitaxial Heterostructures Based on Lead Selenide

... The work deals with the epitaxial PbSe layers grown on the KCl substrates by the method of “hot-wall” molecular epi- taxy over the range of layer thicknesses of 20 - 2000 nm. Special emphasis is put on the ...

9

Rolled up tubes and cantilevers by releasing SrRuO3 Pr0 7Ca0 3MnO3 nanomembranes

Rolled up tubes and cantilevers by releasing SrRuO3 Pr0 7Ca0 3MnO3 nanomembranes

... top layer (4 nm) remains essentially unharmed by the ...top layer and the applied etching time of 6 min and 10 s as well as the above determined etching rate along <100> for STO, the etching ...

8

Rapid Prototyping of Slot Die Devices for Roll to Roll Production of EL Fibers

Rapid Prototyping of Slot Die Devices for Roll to Roll Production of EL Fibers

... insulation layer via dip-coating and slot-die coating procedures, ...the layer thicknesses produced by each method. The emissive layer of dip-coated fibers was, on average, 50 µm thicker than ...

8

A New Device used in Selective Withdrawal from Reservoirs and its Effectiveness Verified in Computational Fluid Dynamics

A New Device used in Selective Withdrawal from Reservoirs and its Effectiveness Verified in Computational Fluid Dynamics

... withdrawal layer thicknesses are ba- sically in consistence; when baffle is installed, in the principal of taking selective withdrawal boundary layer velocity as 0, upper withdraw layer ...

10

A comparison between a shakedown design approach and the analytical design approach in the UK for flexible road pavements

A comparison between a shakedown design approach and the analytical design approach in the UK for flexible road pavements

... as the standard design method in the UK; the other is mechanistic-empirical approach (also called analytical design approach in the UK), in which elastic stresses or strains at critical points are related to pavement ...

8

Application of Grass Cover Failure Models Following in Situ Wave Overtopping Experiments in Belgium

Application of Grass Cover Failure Models Following in Situ Wave Overtopping Experiments in Belgium

... Each volume that overtops a dike will have a certain flow velocity and depth varying with time. High overtopping velocities and flow depths occur at the front of the overtopping tongue (Fig. 2). The peaks are often ...

10

Scaling group transformation for MHD boundary layer flow of a nanofluid past a vertical stretching surface in the presence of suction/injection

Scaling group transformation for MHD boundary layer flow of a nanofluid past a vertical stretching surface in the presence of suction/injection

... On the other ary layer thicknesses but decreases the thermal and nanoparticle hand if is showed that the seoaration factor for common nanofluids volume fraction boundary layers thickness[r] ...

7

Duration of Greenland Stadial 22 and ice-gas age from counting of annual layers in Greenland NGRIP ice core

Duration of Greenland Stadial 22 and ice-gas age from counting of annual layers in Greenland NGRIP ice core

... Continuous flow analysis (CFA) techniques have been de- veloped to improve the reliability and resolution of measure- ments of ice core impurities (e.g. R¨othlisberger et al., 2000; Kaufmann et al., 2008; Bigler et al., ...

9

Optical and Electrical Enhancement of Organic Solar Cells.

Optical and Electrical Enhancement of Organic Solar Cells.

... spacer layer (optical spacing is also one function of an exciton blocking ...spacer layer and folded architecture are used together they can give enormous benefit to cells with thin ...spacer layer. ...

72

Effects of myopia on different areas and layers of the macula: a fourier-domain optical coherence tomography study of a chinese cohort

Effects of myopia on different areas and layers of the macula: a fourier-domain optical coherence tomography study of a chinese cohort

... inner layer in- creased with the degree of myopia, the inner and outer layer thicknesses of the para- and perifovea significantly decreased in myopic ...macular layer was thinner; however, the ...

7

A High Efficiency Ultra Thin (1.8 um) CdS/CdTe p-i-n Solar Cell with CdTe and Si as BSF layer

A High Efficiency Ultra Thin (1.8 um) CdS/CdTe p-i-n Solar Cell with CdTe and Si as BSF layer

... (TCO) layer (ZnO), a window layer (n-type CdS), an intrinsic layer (CdTe), an absorber layer (p-type CdTe) and a highly doped CdTe and Si as back surface field (BSF) ...of layer ...

5

Comparison of explosion characteristics of Colombian and Kellingley coal

Comparison of explosion characteristics of Colombian and Kellingley coal

... Rates of pressure loss and layer thicknesses for Kellingley and Colombian coal are shown in.. Fig.9.The rate of pressure loss increases initially as flame temperature increased.[r] ...

25

Study of Water Bolus Effect on SAR Penetration Depth and Effective Field Size for Local Hyperthermia

Study of Water Bolus Effect on SAR Penetration Depth and Effective Field Size for Local Hyperthermia

... Figure 7 illustrates the normalized SAR contours showing the EFS in depth of 1 cm inside the muscle layer when different values of water bolus thickness are used. These contours are plotted in a 4.5 cm × 6.6 cm ...

11

Rheological Measurements in Liquid Solid Flows

Rheological Measurements in Liquid Solid Flows

... To measure the influence of solids on the shear stress, a rheometer with a rotating outer cylinder was used. Particles are confined in an annular region between the inner, station- ary cylinder and the outer, rotating ...

225

Pulsed Source MOCVD of High k Dielectric Thin Films with in situ Monitoring by Spectroscopic Ellipsometry

Pulsed Source MOCVD of High k Dielectric Thin Films with in situ Monitoring by Spectroscopic Ellipsometry

... Among various methods which have been investigated to deposit these high-k thin films on Si(100) surface, metal- organic chemical vapor deposition (MOCVD) is a leading deposition technique because of good surface coverage ...

5

Design a 16-cell densely packed receiver for high concentrating photovoltaic applications

Design a 16-cell densely packed receiver for high concentrating photovoltaic applications

... The IMS has a 1.6 mm thick aluminum baseplate and a 35 μm-thick copper layer, bonded together with a 4.5 μm thick marble resin. All the surface mounted components will be soldered using a Sn96,5/Ag3,5 solder ...

14

Initial stage growth of Gex
              Si1−x layers and Ge quantum dot formation on Gex
              Si1−x surface by MBE

Initial stage growth of Gex Si1−x layers and Ge quantum dot formation on Gex Si1−x surface by MBE

... critical thicknesses of the transitions, but also affected the properties of the germanium nanocluster array for the top Ge layer. Based on the RHEED data, the shape of the hut-like islands, which were not ...

5

Determination of Effective Particle Density for Sterically Stabilized Carbon Black Particles: Effect of Diblock Copolymer Stabilizer Composition

Determination of Effective Particle Density for Sterically Stabilized Carbon Black Particles: Effect of Diblock Copolymer Stabilizer Composition

... Detailed SAXS analysis indicated a relatively low volume fraction of the n-dodecane solvent within the micelle cores (x sol ≈ 0.10). Similar values have been reported by Pedersen et al. for a related diblock copolymer ...

10

Show all 10000 documents...

Related subjects