• No results found

Liquidus Temperature

Liquidus Temperature Design of Lead Free Solder

Liquidus Temperature Design of Lead Free Solder

... the liquidus temperature was ...‘‘liquidus temperature’’ is strictly intended to mean the ‘‘apparent liquidus ...apparent liquidus temperature, obtained using the two ...

8

Liquidus Temperature of Aluminum Electrolytes Detected by Statistics

Liquidus Temperature of Aluminum Electrolytes Detected by Statistics

... reliably liquidus temperature of aluminium ...between temperature curve and data-density of temperature ...identify liquidus temperature even under the bad circumstance that ...

7

Detection for Liquidus Temperature by Embedded System with Data density Algorithm

Detection for Liquidus Temperature by Embedded System with Data density Algorithm

... high temperature around 900℃ of molten aluminum electrolyte, the crucible (such as stainless steel cup) of sensor nearly ruin as soon as the crucible insert into the cell to measurement temperature signal, ...

6

Liquidus Surface of ``Lime Ferrite'' Slags at Intermediate Oxygen Potentials

Liquidus Surface of ``Lime Ferrite'' Slags at Intermediate Oxygen Potentials

... the liquidus temperature until about 3% and then increases it ...the liquidus temperature if this is necessary but not in the second ...

5

Effect of Magnesium and Aluminum Oxides on Fluidity of Final Blast Furnace Slag and Its Application

Effect of Magnesium and Aluminum Oxides on Fluidity of Final Blast Furnace Slag and Its Application

... of liquidus temperature as a function of slag ...different liquidus temperatures in this diagram, two distinct regions can be ...the liquidus temperature decreases with decreasing MgO ...

7

The influence of alloy composition on the as cast grain structure in near net shape low density steels

The influence of alloy composition on the as cast grain structure in near net shape low density steels

... than measured, hence this alloy does not fit the trend seen for the other alloys in Figure 5. Figure 6 shows the predicted fraction liquid for each alloy against the amount of undercool- ing from its liquidus ...

7

Liquidus Surface of FeO Fe2O3 SiO2 CaO Slags at Constant CO2/CO Ratios

Liquidus Surface of FeO Fe2O3 SiO2 CaO Slags at Constant CO2/CO Ratios

... liquidus temperature were also quantified and the contra- dictions often found between the microscopic results of laboratory quenching measurements and slowly cooled solidified smelting slags from industrial ...

6

Thermodynamic Calculation of Phase Diagram in the Bi In Sb Ternary System

Thermodynamic Calculation of Phase Diagram in the Bi In Sb Ternary System

... calculated liquidus projec- tion of the Bi–In–Sb system accompanying by iso-liquidus at the 100 ◦ C temperature interval, ...melting temperature on the In-rich side, whereas the ...

8

Liquidus Surfaces and Isothermal Section at 973 K of the BaO ZnO B2O3 Pseudo Ternary System

Liquidus Surfaces and Isothermal Section at 973 K of the BaO ZnO B2O3 Pseudo Ternary System

... higher temperature corresponds to the liquidus temperature and the one at the lower temperature stands for a reaction for the formation of a secondary ...

8

Melt Inclusions in Olivine Phenocrysts: Using Diffusive Re equilibration to Determine the Cooling History of a Crystal, with Implications for the Origin of Olivine phyric Volcanic Rocks

Melt Inclusions in Olivine Phenocrysts: Using Diffusive Re equilibration to Determine the Cooling History of a Crystal, with Implications for the Origin of Olivine phyric Volcanic Rocks

... The composition of the pillow-rim glass of the sample can be used to estimate the eruption temperature (1231°C, Table 3, No. 2) which represents the low- temperature end of the cooling interval. The lower ...

21

Microstructural Investigation of Aluminium-Silicon Carbide Particulate Metal Matrix Composite Fabricated by Stir Casting

Microstructural Investigation of Aluminium-Silicon Carbide Particulate Metal Matrix Composite Fabricated by Stir Casting

... uniform temperature of 750°C was ...the liquidus temperature) to a semi-solid state and SiC preheated mixture was added to the melt in fragments and manual stirring of the slurry was ...a ...

5

Functionally Graded Material Fabricated by a Centrifugal Method from ZK60A Magnesium Alloy

Functionally Graded Material Fabricated by a Centrifugal Method from ZK60A Magnesium Alloy

... no liquidus surface evaluation performed previously for lower temperature region, a ternary invariant reaction composed of liquid phase, Mg, -Zr and Mg–Zn intermetallic phase can be expected near the Mg–Zn ...

6

Solidification Path and Solute Redistribution of an Iron Based Multi Component
Alloy with Solute Diffusion in the Solid*

Solidification Path and Solute Redistribution of an Iron Based Multi Component Alloy with Solute Diffusion in the Solid*

... diffusion parameter α diffusion coefficient in the solid half of the primary dendrite arm spacing temperature liquidus temperature solidus temperature fraction of the solid fraction of t[r] ...

7

High Temperature Phase Relations in FeOX(X=1 and 1 33)  CaO  SiO2 Systems under Various Oxygen Partial Pressure

High Temperature Phase Relations in FeOX(X=1 and 1 33) CaO SiO2 Systems under Various Oxygen Partial Pressure

... are that the changes in the bulk composition during equilibration do not affect the final results, and that each experiment provides useful information on both the liquidus composition and the compositions of the ...

8

Thermodynamic Study of Phase Equilibria in the Ni  Fe  B System

Thermodynamic Study of Phase Equilibria in the Ni Fe B System

... peritectic temperature, FeB coexists with the liquid phase. In the present description, both the congruent melting and the peritectic reaction temperatures are in good agreement with the assessed values within the ...

6

Liquidus Surfaces and Isothermal Section at 1073 K in the CaO Fe2O3 (0  50 mol%)B2O3 Pseudo Ternary System

Liquidus Surfaces and Isothermal Section at 1073 K in the CaO Fe2O3 (0 50 mol%)B2O3 Pseudo Ternary System

... the liquidus lines and the eutectic points in the pseudo-binary sections for which only a small number of experimental points were obtained were determined by extrapolating the liquidus lines connecting ...

6

Cobalt-Platinum Alloys96-104

Cobalt-Platinum Alloys96-104

... Nemilow's liquidus curve, extending to alloys containing 51 atomic per cent of platinum links up almost completely with recent melting point data on platinum- rich a[r] ...

9

Mechanical Behavior of Inconel 625 at Elevated Temperatures

Mechanical Behavior of Inconel 625 at Elevated Temperatures

... creep tests were performed in the temperature range of 600-700 °C, in the stress range of 500-600 MPa in a constant load mode. The surface fracture was observed by optical and scanning electron microscopy. ...

15

Liquid Solid Equilibrium and Intermediate Phase Formation during Solidification in Mg 1 3 at%Zn 1 7 at%Y Alloy

Liquid Solid Equilibrium and Intermediate Phase Formation during Solidification in Mg 1 3 at%Zn 1 7 at%Y Alloy

... In the present study, the 97.0Mg-1.3Zn-1.7Y (at%) alloy is prepared in order to assure the validity that the Mg-Y-Zn ternary system can be represented as a pseudo-binary system between the and X phases, and to clarify ...

7

Novel formation of ferrite in ingot of

Novel formation of ferrite in ingot of

... 3.2 Ferrite density and distribution in steel were correlated with mushy zone temperature 150.. Shrinkage styles of steel ingot forming were simulated with different mushy zone temperat[r] ...

17

Show all 10000 documents...

Related subjects