Pulsed Laser Deposition Thin Films
Pulsed Laser Deposition of Thin Film Heterostructures
... produced thin films for characterization of ...produced thin film heterostructures were measured with a Princeton Measurements Corporation Micromag alternating gradient/vibrating sample magnetometer ...
78
The Influence of the Number of Laser Pulses on the Thickness and Roughness of TiO2 Thin Films Fabricated Using Pulsed Laser Deposition
... Dioxide thin films were fabricated by pulsed laser deposition technique (PLD) using a Q- switched Nd: YAG ...of laser pulses (5, 10 and 15 pulses) with the same pulse energy (150 ...
6
Erbium-doped glass nanoparticle embedded polymer thin films using femtosecond pulsed laser deposition
... Figure 4 shows the XRD patterns obtained from the target glass and fabricated siloxane- coated silica samples modified with Er-TZN glass NPs. The target glass shows two characteristic broad amorphous bands at 2θ = 28.59° ...
11
Electrochemical Properties of LiNi0.50Co0.25Mn0.25O2 Thin Film Cathodes Prepared by Pulsed Laser Deposition
... in thin films may be one of reasons resulting in low ...of thin film electrodes, XPS analysis was ...2 thin films was etched by ion beam sputtering to remove any ...
8
Femtosecond pulsed laser deposited Er3+-doped zinc-sodium tellurite glass on Si: Thin-film structural and photoluminescence properties
... deposited films was studied by using high resolution scanning electron microscopy (SEM, Hitachi ...29,30 Deposition thicknesses d were evaluated on cross-sections after snapping the substrate from the ...
11
Growth and characterization of Cu(In,Ga)Se2 thin films by nanosecond and femtosecond pulsed laser deposition
... CIGS thin films are crucial to the performance of their device ...CIGS thin films at 15 K and room temperature (see the inset) without normalization, in which PL peaks at ...
7
Effect of Crystallinity and Morphology on the Electrical Properties of Y2O3 Thin Films Prepared by Pulsed Laser Deposition for MOSFET
... substrate temperature from ambient to 650°C in low oxygen pressure (0.0034mbar) was realized by change in crystallinity and morphology. The XRD result shows the preferred orientation along the (400) plane. The effect of ...
10
Investigation of the Dependence of Thickness and Roughness of TiO2 Thin Films Fabricated Using Pulsed Laser Deposition on the Laser Energy
... of laser pulses (10 pulses) and the same laser repetition rate to fabricate three groups of thin film (I, II and ...these thin films. The results showed that the thickness of the ...
5
Controlling Oxygen Content by Varying Oxygen Partial Pressure in Chromium Oxynitride Thin Films Prepared by Pulsed Laser Deposition
... Hard coatings have been applied on cutting tools, auto parts and mold tools to improve their characteristics which include high hardness, wear resistivity, chemical stability, oxidation resistivity and so on. ...
5
Thermoelectric Properties of Amorphous Zinc Oxide Thin Films Fabricated by Pulsed Laser Deposition
... and (024) on pattern in Fig. 1(a) for as-deposited film. On the other hand, the pattern in (b) for after the 10th cycle shows ZnO(110) peak at the same angle as the broad diffraction peak on the pattern in Fig. 1(a). This ...
6
Pulsed laser deposition of thick multilayer garnet crystal films for waveguide laser devices
... of pulsed laser deposition (PLD) to fabricate thick multilayered garnet crystal planar waveguides with rare-earth ion doped cores for use as planar waveguide laser ...diode laser ...
213
Switching Applications Based on Reversible Insulator-Metal Transition of Vanadium Dioxide Thin Films Synthesized by Pulsed Laser Deposition.
... X-ray diffraction (XRD) is a traditional approach to study the crystal and orientation of thin films. It is also used to determine the phase composition of mixtures of crystalline phase materials. When an ...
168
Composition and crystalline properties of TiNi thin films prepared by pulsed laser deposition under vacuum and in ambient Ar gas
... TiNi thin films, the TiNi films were fabricated by PLD method under vacuum (5 × 10 -6 Torr) and in 200- mTorr Ar ...deposited films were charac- terized by EDXS, a surface profiler, and XRD at ...
6
Characterization and Conduction Mechanism of La5/8Sr3/8MnO3 Thin Films Prepared by Pulsed Laser Deposition on Different Substrates
... covering Si substrate and the chemical reactivity of Si with oxide film made a polycrystalline (non- epitaxial) growth. One can see from Table 1, that lattice parameters and unit cell volume for thin film sample ...
17
High Curie Temperature for La5/8Sr3/8MnO3 Thin Films Prepared by Pulsed Laser Deposition on Glass Substrates
... The films showed the same structure as bulk, which is single phase rhombohedral with space group of R 3 ...of thin film were ...for thin film sample are compressed when compared with LSMO ...
10
Characterization of Ferroelectric NaxK1 xNbO3 System Films Prepared by Pulsed Laser Deposition
... Pulsed laser deposition has been widely applied for preparation of many kinds of thin films due to several advantages, i.e., stoichiometric transfer of compositions from source to film, growth ...
6
Effect of Pulse Energy on the Optical Properties of ZnS Thin Films Prepared Using Pulse Laser Technique
... the films in the wavelength range 300-1850 nm by using spectrophotometric measurement ...ZnS thin film were fabricated using Q-switched Nd:YAG pulsed laser deposition with the ...
7
Superconducting MgB2 thin films by pulsed laser deposition
... ⬃ 22 K. In the ex situ process, the highest T c is obtained by magnesiating pure boron films, rather than films made from MgB 2 target. This suggests that a careful study of reaction and diffusion kinetics ...
6
Development of a Low Cost Pulsed Laser Deposition System for Thin Films Growth
... An economics complete system for deposits by PLD was built. The system allows to make thin film deposits at different substrate temperatures into a controlled atmos- phere. Also it is possible to control the time ...
8
The deposition and characterisation of metallic thin films and magnetic multilayers prepared by pulsed laser ablation deposition
... Initial work focuses on the effects of the laser wavelength and the laser pulse temporal profile on the deposition rates of nickel and silver and the droplet numbers deposited on to film[r] ...
213