• No results found

Terminal Voltage

Minimization of the Wilson’s Central Terminal voltage potential via a genetic algorithm

Minimization of the Wilson’s Central Terminal voltage potential via a genetic algorithm

... Central Terminal (WCT) is an artificially constructed reference for surface electrocardiography, which is assumed to be near zero and steady during the cardiac cycle; namely it is the simple average of the three ...

5

Accurate Modeling of Prismatic Type High Current Lithium Iron Phosophate (LiFePO4) Battery for Automotive Applications

Accurate Modeling of Prismatic Type High Current Lithium Iron Phosophate (LiFePO4) Battery for Automotive Applications

... nected cells are close to each other. As the actual power demand of EV varies with the operating mode, therefore a dynamic current of 55 A, which is close to the actual discharge current, is selected to calculate the ...

17

Analysis of a battery management system (BMS) control strategy for vibration aged nickel manganese cobalt oxide (NMC) Lithium Ion 18650 battery cells

Analysis of a battery management system (BMS) control strategy for vibration aged nickel manganese cobalt oxide (NMC) Lithium Ion 18650 battery cells

... same voltage, only one output voltage is required and in this case the first cell is chosen to calculate voltage), which takes the form of Equation ...same terminal voltage as its ...

21

1.
													Performance analysis of conventional controllers for automatic voltage regulator(avr)

1. Performance analysis of conventional controllers for automatic voltage regulator(avr)

... An AVR system is used in synchronous generator to hold the magnitude of the terminal voltage at a specified level. It composes of four main components which are named as amplifier, exciter, generator and ...

7

Impacts of high penetration of DFIG wind turbines on rotor angle stability of power systems

Impacts of high penetration of DFIG wind turbines on rotor angle stability of power systems

... the terminal voltage of the wind generation is ...severe voltage sag ...the voltage during grid ...DC voltage control once the terminal voltage drops below a predefined ...

9

The User defined Modeling Method of Power System Components Based on RTDS CBuilder

The User defined Modeling Method of Power System Components Based on RTDS CBuilder

... This paper puts forward a method to design the user-defined component based on the user-defined modeling environ- ment CBuilder of RTDS simulator. And also develops the user-defined component model with algorithm ...

7

Impacts of high penetration of DFIG wind turbines on rotor angle stability of power systems

Impacts of high penetration of DFIG wind turbines on rotor angle stability of power systems

... the terminal voltage of the wind generation is ...severe voltage sag ...the voltage during grid ...DC voltage control once the terminal voltage drops below a predefined ...

8

CONTROL SCHEME FOR VOLTAGE REGULATION IN MICRO GRIDS TO ENSURE MAXIMUM POWER POINT TRACKING (MPPT)

CONTROL SCHEME FOR VOLTAGE REGULATION IN MICRO GRIDS TO ENSURE MAXIMUM POWER POINT TRACKING (MPPT)

... of voltage regulation in micro grids involving doubly fed induction wind generators ...achieve terminal voltage regulation while ensuring maximum power point tracking ...on voltage sensitivity ...

15

Turn to turn fault modelling of three Phase PMSG having rotor Magnets of non-uniform strength

Turn to turn fault modelling of three Phase PMSG having rotor Magnets of non-uniform strength

... the terminal voltage during open circuit condition for the PMSG having defective magnets on the ...output voltage of phase ‘a’ has been shown for the clarity .The output voltage is a sinusoid ...

7

Improving Fault Ride-Through Capability of Fixed Speed Wind Turbine by using Simultaneously Series Braking Resistor and STATCOM

Improving Fault Ride-Through Capability of Fixed Speed Wind Turbine by using Simultaneously Series Braking Resistor and STATCOM

... the terminal voltage of IG ...the terminal IG voltage and the rotor speed starts to ...reduced voltage of IG. Thus, the induction generator voltage does not recover immediately ...

5

New Control Algorithm for Capacitor Supported Dynamic Voltage Restorer

New Control Algorithm for Capacitor Supported Dynamic Voltage Restorer

... dynamic voltage restorer (DVR) and unified power quality conditioner (UPQC) which is connected in both shunt and series with the ac ...load terminal volt- age from the “low quality” terminal ...

10

Relational Rewards: Creating a Fulfilling Workplace Environment

Relational Rewards: Creating a Fulfilling Workplace Environment

... The plot shows the speed of motor when converter is operated at different duty ratios. As the change in duty ratio varies the terminal voltage which is proportional to speed of motor the speed is reduced. ...

6

A Novel Control Strategy to Reduce Transformer Inrush Currents by Series Voltage Sag Compensator

A Novel Control Strategy to Reduce Transformer Inrush Currents by Series Voltage Sag Compensator

... the terminal voltage, the characteristics of the hysteresis curve (residual and saturation fluxes), the primary winding resistance, and the inherent primary winding air-core ...the voltage applied to ...

10

An advanced Lithium ion battery optimal charging strategy based on a coupled thermoelectric model

An advanced Lithium ion battery optimal charging strategy based on a coupled thermoelectric model

... The effects of the battery maximum charging voltage, ambient charging temperature and battery health status are analyzed. Zhang et al. [21] use the dynamic programming (DP) method to solve the trade-off problem ...

32

Performance of DC Voltage Control of Multi- Terminal VSC- HVDC Systems

Performance of DC Voltage Control of Multi- Terminal VSC- HVDC Systems

... Voltage source converters (VSC) on the other hand do not need reversal of polarity for changing the direction of power flow and also are capable of independent control of active and reactive power. This makes VSC ...

7

Design and development of axial field air cored brushless DC motors

Design and development of axial field air cored brushless DC motors

... shows the a r r a n g e m e n t s of such a machine: it has 2 coils, 4 poles and 4 c ommutator copper segments. But in order to reduce torque ripples, and to obtain better c o m m u t a t i o n c h a racteristics, motors ...

281

Evaluating Accuracy of Fault Location Algorithms Based on Terminal Current and Voltage Data

Evaluating Accuracy of Fault Location Algorithms Based on Terminal Current and Voltage Data

... Drawbacks mentioned above yield to the development of one-end and two-end fault location algorithms. One- end fault location algorithms are simple, economic and use only measurements from one terminal. On the ...

5

A Single Phase Grid Connected Five-Level Converter for Renewable Distribution System with Reactive Power control

A Single Phase Grid Connected Five-Level Converter for Renewable Distribution System with Reactive Power control

... The mid-point voltage balancing can be obtained by ensuring that the discharge times of the high-side and low-side capacitors are the same[7]. A suitable control scheme will be utilized to ensure that the voltages ...

6

Controlling of Distribution Voltage for DC Micro grids Using MRAS, Fuzzy Control and Gain Scheduling Technique

Controlling of Distribution Voltage for DC Micro grids Using MRAS, Fuzzy Control and Gain Scheduling Technique

... DC-distribution voltage has a tolerance of ±5% with reference to AC systems then upper and lower reference should be within limits of 3% because the gain-scheduling control includes a tolerance of ...good ...

9

Review paper on Study of Voltage Sag Compensation in Wind Farms to Weak Grid Connections using UPQC

Review paper on Study of Voltage Sag Compensation in Wind Farms to Weak Grid Connections using UPQC

... The principal aim is to improve the stability of wind farm by means of active compensator. The system under study is composed by a wind farm connected to a distribution network, as show in the fig 2.1 where the ...

8

Show all 10000 documents...

Related subjects