Throughput performance with changes in physical layer
Peak-Throughput of LTE-Release 10 for Up/Down Link Physical Layer
... network throughput performance is data throughput but unfortunately, the ways in which various organizations quote throughput statistics vary tremendously which often leads to misleading ...
Performance Analysis of IEEE 802.16e Wimax Physical Layer
... Fig.1 WIMAX Communication System Model A. SUI CHANNEL MODEL The term channel refers to the medium between the transmitting antenna and the receiving antenna .The characteristics of wireless signal changes as it ...
5
Improvement in Performance of Wireless Relay Nodes Using Physical Layer Network Coding
... All the multipath signals from the transmitter sums to the overall received signal at the receiver. Sometimes the multipath signals will be in phase or out of phase with the main signal. The in phase signal components ...
58
802.11n Client Throughput Performance
... Two changes were made to the settings of the clients: power save mode was disabled to prevent the radios from turning off during performance testing; and roaming aggressiveness was set to minimum wherever ...
16
Performance Analysis of MAC layer on Saturation Throughput
... My analysis work primarily aims at computing the saturation outturn of the mac layer and targets its improvement. The current study is conducted to look at each Physical and MAC layer protocols to ...
5
Performance Evaluation of the IEEE Infrared Physical Layer
... Control layer (MAC) that can be used with one of three Physical Layers (PHY): two of them using radio with spread spectrum modulation and one using infrared ...
6
Performance Evaluation of Optimized Physical Layer Network Coding
... Introduction 1.1 Overview With the recent development of wireless networks, system structures have become so complicated that it is impossible to simulate the entire network (all nodes and all links). This has ...
149
Wireless Physical-Layer Security Performance of Uwb systems
... systems, performance, receiver complexity, power consumption and cost are all considered in decid- ing whether to utilize coherent or noncoherent ...in performance but at the expense of significant receiver ...
57
Improving Throughput Performance of the IEEE MAC Layer Using Congestion Control Methods
... best throughput performance under all network ...the throughput improvement in some cases, especially with ftp or downloading a small file such as a web ...
15
Physical layer transmitter and routing optimization to maximize the traffic throughput of a nonlinear optical mesh network
... I. I NTRODUCTION Optical fibre mesh networks connecting re-configurable optical add drop multiplexers, ROADMs, form the backbone of modern communications and the internet. These networks utilize wavelength routing to ...
7
Wireless networks physical layer security : modeling and performance characterization
... INTRODUCTION As stated in the report of Ericsson entitled "10 hot consumer trends 2019" Ericsson (2018), technology does make our daily life cheaper, easier, and more convenient. Specifically, super- markets ...
247
A Case for Cross Layer Design: The Impact of Physical Layer Properties on Routing Protocol Performance in MANETs
... cross layer design routing protocols ...the performance of physical layer (for path loss and shadowing properties) is drastically different as compared to the ideal scenario using cross ...
8
The Performance of Network Coding at the Physical Layer with Imperfect Self Information Removal
... the physical layer ...network performance of ANC scheme depends on the self- information removal at the destination ...the performance of broadband ANC in terms of the bit error rate (BER) and ...
8
Performance of opportunistic scheduling for physical layer security with transmit antenna selection
... 5 Conclusions We proposed an opportunistic scheduling with TAS to enhance physical layer security. At the transmitter, a sin- gle antenna is selected to maximize the instantaneous SNR of the main channel, ...
9
Performance Evaluation Of Physical Layer Using Lora Technology For Indoor Environment
... the performance of the physical layer of LoRa Technology in an indoor ...data throughput, received signal strength indication and signal-to- noise ...LoRa physical parameters have a ...
6
Wireless Physical Layer Security.
... In the second work, we developed BitTrickle to enable wireless communication when a broadband and high power reactive jammer is present. BitTrickle delivers information by taking advantage of the reaction time of a ...
130
Analysis of LTE Physical Layer
... It carries out operations such as coding, decoding, modulation, demodulation, mapping etc. In this paper, the LTE transmissions in uplink and downlink are analyzed. The LTE uplink transmission is based on Single Carrier ...
6
Algorithms for 5G physical layer
... 2.2 Channel Coding for 5G 17 set by Shannon [153] in his landmark 1948 paper: to communicate reliably over a noisy transmission channel at a rate approaching channel capacity. Indeed, many applications have recently ...
225
Physical Layer Cooperation:Theory and Practice
... much performance improvement we can gain for QMF, if we optimize its design by taking into account the network configuration, as well as channel state information (CSI), over slow fading ...
122
Physical Layer Convergence Protocol
... for physical media: convergence protocol is physical layer convergence protocol stack for having participated in each station; and authorized ...is physical layer is physical ...
10