• No results found

850 C

Investigation of Micro structure and Creep Life Analysis of Centrifugally Cast Fe–Cr–Ni Alloy Reformer Tubes

Investigation of Micro structure and Creep Life Analysis of Centrifugally Cast Fe–Cr–Ni Alloy Reformer Tubes

... Mo, 23.6 Cr, 34.9 Ni, 0.8 Nb, 0.037 Ti and balance Fe (in weight %). Flat tensile creep specimens of 25 mm gauge length, 6.5 mm width and 3 mm thick as shown in Fig. 1, were machined from the longitudinal direction of ...

5

Synthesis of gallium nitride nanostructures by nitridation of electrochemically deposited gallium oxide on silicon substrate

Synthesis of gallium nitride nanostructures by nitridation of electrochemically deposited gallium oxide on silicon substrate

... and 850°C, the general shape of the nano- rods is still being preserved where no significant change in their morphologies is observed, as shown in Figure 4b,c, ...800°C, 850°C ...

8

Corrosion Behavior of a Thermally Oxidized Orto-Titanium Aluminide in Synthetic Seawater

Corrosion Behavior of a Thermally Oxidized Orto-Titanium Aluminide in Synthetic Seawater

... at 850 °C for one hour, the EIS plots are characterized by two time constants and circuit equivalent model simulates the oxide layer grown on the passive film ...

14

Self-assembly of ordered wurtzite/rock salt heterostructures—A new view on phase separation in MgxZn1−xO

Self-assembly of ordered wurtzite/rock salt heterostructures—A new view on phase separation in MgxZn1−xO

... processes proceed slower at lower annealing temperatures, the PL spectra recorded after annealing temperatures of 850°C, 900°C and 950°C represent intermediate stages of the phase separation ...

20

←
				
											Return to Article Details
									
				VISIBLE RANGE PHOTOCATALYSTS FOR SOLID PHASE PHOTOCATALYTIC DEGRADATION OF POLYETHYLENE AND POLYVINYL CHLORIDE

← Return to Article Details VISIBLE RANGE PHOTOCATALYSTS FOR SOLID PHASE PHOTOCATALYTIC DEGRADATION OF POLYETHYLENE AND POLYVINYL CHLORIDE

... °C and titania nanoparticles, are shown in Fig. 3 – 5 respectively. The band gap of the photocatalysts along with crystallite size from XRD studies is listed in Table 2. It is clearly seen from Figs. 3-5 that the ...

6

Study of System Pressure Dependence on n-TiO2/p-Si Hetrostructure for Photovoltaic Applications

Study of System Pressure Dependence on n-TiO2/p-Si Hetrostructure for Photovoltaic Applications

... heterojunction. Si wafers were ultrasonically cleaned using acetone and ethanol for 10 min. then were coated with a Ti buffer layer with a thickness of 50 nm by the e-beam evaporation technique evaporation rate under the ...

5

Carbon Nano Material Synthesis from Polyethylene by Chemical Vapour Deposition

Carbon Nano Material Synthesis from Polyethylene by Chemical Vapour Deposition

... and 850˚C - ...at 850˚C - 1050˚C decomposed at 624˚C - 668˚C; suggesting that CNT synthesized at this temperature range were more crystalline than what was obtained at the ...

10

Investigating the Preparation Conditions on Superconducting Properties of Bi2 x LixPb0 3Sr2Ca2Cu3O10+δ

Investigating the Preparation Conditions on Superconducting Properties of Bi2 x LixPb0 3Sr2Ca2Cu3O10+δ

... to 850˚C (third group) yielded larger grains (larger crystallinities) as shown in Figure 9 for the samples at different doping concentration of Li (x = 0, ...T C this effectively increases the ...

12

Hardness and Composition of Solution Treated Ag Pd Cu Au Alloy Microstructures

Hardness and Composition of Solution Treated Ag Pd Cu Au Alloy Microstructures

... Ag-Pd-Cu-Au alloy castings are applied as dental restora- tions after heat treatment, either for softening or hardening, according to clinical requirements. It is clear that the solution treatments of this alloy at ...

5

Effect of Temperature on Physical and Electrochemical Properties of the Monolithic Carbon-Based Bamboo Leaf to Enhanced Surface Area and Specific Capacitance of the Supercapacitor

Effect of Temperature on Physical and Electrochemical Properties of the Monolithic Carbon-Based Bamboo Leaf to Enhanced Surface Area and Specific Capacitance of the Supercapacitor

... to 850 °C and decreased ...of 850 °C possessed the maximum specific ...of 850 °C is the optimum temperature to prepare supercapacitor cells from bamboo leaf-based ...

12

Understanding the behaviour of new low biopersistence high temperature insulation fibre materials

Understanding the behaviour of new low biopersistence high temperature insulation fibre materials

... at 850°C the thermal behaviour – in terms of final phase assemblage and elemental stability – of glass fibres was the same for the pre-crystallized and amorphous ...

222

Performance Assessment of an Allothermal Auger Gasification System for On Farm Grain Drying

Performance Assessment of an Allothermal Auger Gasification System for On Farm Grain Drying

... Biomass gasification is a well-developed technology with the potential to convert agricultural re- sidues to value-added products. The availability of on-farm gasifiers that can handle low-density agricultural wastes ...

14

Characterisation of strain-induced precipitation behaviour in microalloyed steels during thermomechanical controlled processing

Characterisation of strain-induced precipitation behaviour in microalloyed steels during thermomechanical controlled processing

... of 850¡C was selected in order to obtain the highest volume fraction of precipitates while enabling for the deformation of fully unrecrystallised ...

17

Microwave Synthesis of Different Morphologies of Lead Ferrite Nanostructures and Investigation of Magnetic Properties

Microwave Synthesis of Different Morphologies of Lead Ferrite Nanostructures and Investigation of Magnetic Properties

... The lead ferrite (PbFe 12 O 19 ) nanoparticles were prepared by a simple and short time microwave method. Lead nitrate, iron nitrate nine hydrate, surfactants, and ethylene glycol were used as precursor materials. The ...

5

Investigation on the Influence of Post Weld Heat Treatments on Weldments Between P91 and P11 

Investigation on the Influence of Post Weld Heat Treatments on Weldments Between P91 and P11 

... which my resulted in a formation of untempered martensite that contribute to the rise in hardness of weld metal. Figure 17 show microstructures of P11 base metals after applying PWHT at a temperature of ...

9

Structural and Dielectric Properties of (Bi2O3Fe2O3)0 4(Nb2O5)0 6 for Different Sintering Temperature

Structural and Dielectric Properties of (Bi2O3Fe2O3)0 4(Nb2O5)0 6 for Different Sintering Temperature

... Samples were sintered at four different temperatures 850˚C, 925˚C, 1000˚C and 1150˚C to study the effect of sintering temperature on the various properties of the samples.. X-ray diffrac[r] ...

10

Effect of Grain Size Distribution and Nb Addition on the Recrystallisation Avrami exponent of Fe  30Ni Model Alloy

Effect of Grain Size Distribution and Nb Addition on the Recrystallisation Avrami exponent of Fe 30Ni Model Alloy

... Cold deformed Fe-30Ni steel samples were reheated in the preheated furnace (850- 950 °C) during the annealing process. Thermocouple readings showed that it took 30 seconds for the sample to reach the set ...

304

Experimental and numerical studies of rotating drum grate furnace

Experimental and numerical studies of rotating drum grate furnace

... The required temperature of 850°C has to be kept on the same level during whole process of combustion. Furthermore, dedicated fuel feeder, which will provide material only in case of sufficient enough ...

6

Manganese spinels for rechargeable lithium batteries

Manganese spinels for rechargeable lithium batteries

... Although the solution based preparation and in particular the addition of carbon during synthesis improve the cycle life of the spinel cathode, capacity declines on cycling on the 3 V plateau much more rapidly than does ...

202

Exploring the enterprise class wireless operating systems: Blackberry operating systems

Exploring the enterprise class wireless operating systems: Blackberry operating systems

... his paper presents the features of blackberry operating systems. Blackberry devices developed by the Research in Motion Ltd. Research in Motion founded by two Canadian engineers mike lazaridis from the university of ...

5

Show all 10000 documents...

Related subjects