• No results found

blend films

Tensile, Thermal, And Moisture Absorption Properties of Polyvinyl Alcohol (PVA) / Bengkuang (Pachyrhizuserosus) Starch Blend Films

Tensile, Thermal, And Moisture Absorption Properties of Polyvinyl Alcohol (PVA) / Bengkuang (Pachyrhizuserosus) Starch Blend Films

... characteristic of PVA, BS and its blend film. The TS and TE of all sample tested are presented on Table 2. The TS and TE value of PVA are 15.86 MPa and 225.64 %, respectively. This value is higher than BS and its ...

6

Preparation and Evaluation of Surface Morphology and Swelling Behavior of Ternary Blend Films

Preparation and Evaluation of Surface Morphology and Swelling Behavior of Ternary Blend Films

... chitosan films widely discussed [12-16] and microstructures, including roughness can be effectively examined by using atomic force microscopy ...of blend films plays an important role in control and ...

8

Influence of Phase Behavior and Miscibility on Mechanical, Thermal and Micro Structure of Soluble Starch Gelatin Thermoplastic Biodegradable Blend Films

Influence of Phase Behavior and Miscibility on Mechanical, Thermal and Micro Structure of Soluble Starch Gelatin Thermoplastic Biodegradable Blend Films

... of blend films (50% ...these blend films that revealed one endothermic ...ASS/G blend films or even additive in case of ApSS/G blend ...the blend films with ...

16

Influence of Gum Ghatti on Morphological and Mechanical Properties of Poly(vinylalcohol)/Poly(vinyl pyrrolidone) Blend Films

Influence of Gum Ghatti on Morphological and Mechanical Properties of Poly(vinylalcohol)/Poly(vinyl pyrrolidone) Blend Films

... pyrrolidone) blend films were prepared by solution blending and solvent evaporating ...prepared blend films were analyzed for phase morphology and mechanical ...incorporated blend ...

6

Characterization of Mechanical and Electrical Properties of Polymer Semiconductor Blend Films.

Characterization of Mechanical and Electrical Properties of Polymer Semiconductor Blend Films.

... the blend films is difficult to observe due to the relatively low concentration of PCDTPT and the overlapping diffraction peaks of P3HT and ...PCDTPT films become significantly weaker in the ...

52

Miscibility and Thermal Study of PVA/Chitosan/Papaya Latex Blend Films

Miscibility and Thermal Study of PVA/Chitosan/Papaya Latex Blend Films

... prepared blend films were determined by using scanning electron microscopy (SEM) (JOEL- JSM-6360, ...Germany). Blend films were sputter coated with gold layer to avoid charging under high ...

9

Microstructures and Electrical Properties of HPMC/PVP Polymer Blend Films Complex with Ferric Chloride (FeCl3)

Microstructures and Electrical Properties of HPMC/PVP Polymer Blend Films Complex with Ferric Chloride (FeCl3)

... (PVP) blend films were carried out using X-Ray diffraction ...HPMC/PVP blend film decreases up to a certain percentage of FeCl 3 and then ...doped films suggest complex formation due to doping ...

6

Role of Nano-Sized TiO2 on Mechanical and Thermal Behavior of Starch/Poly (vinyl alcohol) Blend Films

Role of Nano-Sized TiO2 on Mechanical and Thermal Behavior of Starch/Poly (vinyl alcohol) Blend Films

... polymer films. They modified the surface of the films by treatment with chitosan and observed improvements in some ...PVA films plasticized with glycerol and characterized for their physicomechanical ...

12

Effect of FormaldehydeContent
and Nanoparticles on Biodegradability of
PVA/Corn Starch Blend Films

Effect of FormaldehydeContent and Nanoparticles on Biodegradability of PVA/Corn Starch Blend Films

... PVA/CS films. FTIR of the films explores the CS was linked with PVA by chemical binding ...tested films decreased with the increasingof formaldehyde ...nanocomposites films indicated that ...

8

Morphology Development in Amorphous Polymer: Fullerene Photovoltaic Blend Films During Solution Casting

Morphology Development in Amorphous Polymer: Fullerene Photovoltaic Blend Films During Solution Casting

... however, a bar-coater housed within a sample environment chamber is placed in the path of an X-ray beam, with the beam directed at grazing incidence to the centre of the sample sub- strate. An ellipsometer is placed so ...

10

AC ELECTRICAL CONDUCTIVITY
ANALYSIS OF (PVC-PS) BLEND FILMS

AC ELECTRICAL CONDUCTIVITY ANALYSIS OF (PVC-PS) BLEND FILMS

... Mixing two or more polymers together is an easy way to achieve specified properties without the need to synthesize specialized polymer systems. The design, selection, and performance of polymer blends crucially depend on ...

10

Spectroscopic Studies on Films of Lead NitrateDoped Polyvinyl Alcohol – Polyvinyl Pyrrolidone Blend

Spectroscopic Studies on Films of Lead NitrateDoped Polyvinyl Alcohol – Polyvinyl Pyrrolidone Blend

... The emission (fluorescence or photo-luminescence) spectra of Pb(NO 3 ) 2 filled PVA-PVP blend films are shown in figure 2. The excitation wavelength was fixed at 350 nm for all the samples. Two emission ...

13

Nerve tissue engineering using blends of poly(3-hydroxyalkanoates) for peripheral nerve regeneration

Nerve tissue engineering using blends of poly(3-hydroxyalkanoates) for peripheral nerve regeneration

... PHA films was analyzed by measuring the water contact ...P(3HO)/P(3HB) films decreased as the content of P(3HO) decreased ((P(3HO), ...the films P(3HO)/P(3HB) were significant (p-value < ...

31

PHYSICO-CHEMICAL AND THERMAL PROPERTY STUDIES OF GG/PVA BLEND THIN FILMS

PHYSICO-CHEMICAL AND THERMAL PROPERTY STUDIES OF GG/PVA BLEND THIN FILMS

... FTIR spectra of GG, PVA and their blend films (50/50, 60/40 and 80/20) were recorded. Figure 1 shows the FTIR spectra of pure and blend films in the wave length range of 4000-500cm -1 . The ...

7

Preparation of Stereocomplex Polylactide Bioplastics from Star-shaped/Linear Polylactide Blending

Preparation of Stereocomplex Polylactide Bioplastics from Star-shaped/Linear Polylactide Blending

... Polylactide Films The stereocomplex polylactide films of 1PLLA120K/1PDLA, 4PLLA120K/1PDLA and 16PLLA480K/1PDLA blends were prepared via solution blending followed by solvent ...The blend solution was ...

8

Synthesis, structure, and opto electronic properties of organic based nanoscale heterojunctions

Synthesis, structure, and opto electronic properties of organic based nanoscale heterojunctions

... both blend films shifted. In the case of P3HT:[60]ThCBM blend, the shift of sur- face potential is ...this blend is mini- mized, and therefore it is beneficial for PV ...

12

Structural, Thermal and Optical properties of PMMA, PEO and PMMA/PEO/LiClO4 Polymer Electrolyte Blends

Structural, Thermal and Optical properties of PMMA, PEO and PMMA/PEO/LiClO4 Polymer Electrolyte Blends

... thin films were recorded using an X-ray ...4 blend films were taken by using the ZEISS ...electrolyte blend thin films were carried out using DSCQ20 ...

5

Influence of Silver Nanoparticles on Optical Properties for (PS-PMMA) Blend

Influence of Silver Nanoparticles on Optical Properties for (PS-PMMA) Blend

... (PS) blend films doped with silver nanoparticles were ...The blend films were prepared using solution casting technique different weight ratio (0, ...prepared films were investigated. ...

6

Tailoring Macromolecular Structure of Cationic Polymers towards Efficient Contact Active Antimicrobial Surfaces

Tailoring Macromolecular Structure of Cationic Polymers towards Efficient Contact Active Antimicrobial Surfaces

... antimicrobial films by blending copolymers with quaternary ammonium salts and polyacrylonitrile as matrix ...microorganism. Blend films composed of copolymers with high positive charge density and ...

16

The Chemical Modification of Chitosan Films for Improved Hemostatic and Bioadhesive Properties.

The Chemical Modification of Chitosan Films for Improved Hemostatic and Bioadhesive Properties.

... all blend films have relatively few free aldehyde groups, their spectra did not exhibit the presence of 2,4-DNPH and the change of the shape in spectra, as seen in Figure ...CS, blend, and SF ...

247

Show all 5350 documents...

Related subjects