coupled line directional couplers
Multi Section Coupled Line Directional Couplers Design
... ABSTRACT: Directional coupler is a passive device used for sampling incident and reflected microwave power conveniently and accurately for various applications in microwave ...systems. Directional coupler ...
7
Miniaturization of Trans-Directional Coupled Line Couplers Using Series Inductors
... When coupled-line directional couplers are used in Butler matrices, problems of circuit complexity and parasitic effects are caused by crossover circuits ...capacitor-loaded coupled ...
7
Development of Forward-wave Directional Couplers Loaded by Periodic Shunt Shorted Stubs
... transmission line, the phase difference between the even- and odd-modes is ...microstrip coupled line with photonic-bandgap (PBG) structures on the ground plane [10] and the composite ...
7
General strong coupled mode theory for multiwaveguide nonlinear directional couplers
... strong coupled mode theory, and nonlinear directional couplers are reviewed ...nonlinear coupled mode theory for multiwaveguide nonlinear ...nonlinear coupled mode equations of the ...
256
Compact Directional Coupled-Line Coupler with Independent Power Division Ratios at Dual Bands
... the coupled-line configuration is proposed based on the structure shown in ...of coupled lines, avoiding the large transmission-line loop or extra matching ...the couplers based on the ...
8
Directional Coupler Using Multi-Stage Coupled Structure Theory
... waveguide directional coupler, it was extensively used in microwave engineering to monitor, measure and separate incident power, ...industry, directional couplers have different forms and can be ...
11
Design and Simulation of Coupled-line Couplers
... Directional couplers are one of the microwave passive components that are used in array antennas, modulators, filters and power amplifiers for propose of dividing or combining the ...A ...
8
Design and Verification of Strip Line Directional Couplers for Various Applications in RF and Microwave Communication Systems
... The fabricated coupler has been tested with the Network Analyzer at IMPACT laboratory of Osmania University. The results obtained thus are plotted as shown Fig.1 and Fig.2. From the Fig.2 , the coupling of -19.84 dB is ...
5
Design of Multilayer and Multiline Microstrip Directional Coupler with Closed Form Relations
... microstrip directional couplers with closed form relations are ...second coupled line on the other side of the main line ...microstrip couplers. The design of multilayer ...
14
Broadband Substrate Integrated Coaxial Line to Cbcpw Transition for Rat-Race Couplers and Dual-Band Couplers Design
... transmission line, a coupled line has advantages, such as compact size, flexible design parameters, and so ...on coupled microstrip line, such as power dividers [21–24], filters [25, ...
13
A REVIEW ON DIRECTIONAL COUPLERS WITH INTRODUCTION OF TRANSMISSION LINES IN BETWEEN COUPLED LINE SECTIONS
... of coupled sections to compensate the difference in velocities in odd and even ...of coupled microstrip line coupler could achieve tight coupling (3dB) and more than 60 dB of directivity on practical ...
7
A Novel Compact Feeding Network for Array Antenna
... of couplers and power divider are presented in Table 1 according to ...branch-line couplers which occupy a large area especially at low frequencies as ...of couplers with inductance (L) and ...
7
A new shielding effectiveness measurement method based on a skin-effect transmission line coupler
... Depending on the purpose, some methods based on cables (ASTM D4935, 1999; Kinningham and Yenni, 1988), cou- pled TEM cells (Nishikata et al., 2006) or antennas (IEEE Std 299, 1997; MIL Std 285, 1956; EN 50147-1, 1997; ...
6
Subwavelength grating waveguide devices for telecommunications applications
... In this section, we discuss the design and characteristics of optical filters based on SWG waveguides. For fabrication processes available from typical silicon photonic multi-project wafer runs, our devices are based on ...
12
Directional Data Analysis for Line Segments
... In this section, we consider the problem on clustering line segments based on the angular data. Here we note that the angular data are obserbed just in (0, π), that is we cannot abtain the directions of the ...
6
Complex Impedance Transformers Based on Branch-Line Hybrid Couplers
... Branch line hybrid couplers are prominently used in the design of many microwave circuits (e.g., data modulators, phase shifters, balanced amplifiers and feeding networks). Most of the research on this ...
11
A Design of Compact Microwave Six-Port Device for Ultra-Wideband Applications
... 8.34-dB directional coupler designing at the operating frequency band from 2 to 8 GHz; secondly, series connection realizing between ...proposed couplers is shown in Fig. 2(a). In the model of the proposed ...
5
Miniaturized Hybrid Branch Line Couplers Based on a Square-Split Resonator Loading Technique
... Many artificial magnetic material inclusions are introduce in the literature. However, most of these inclusions have the same functionality as for split ring resonators. In [4] a square split ring resonator (S-SRR) was ...
10
Microstrip Bandpass Filter At 5.8 Ghz
... Parallel Coupled bandpass filter ...45 4.4 Filter response before optimize coupled line 46 ...Optimization coupled length filter response 47 4.6 Optimization coupled line width ...
24
Bi-Directional Hybrid Coupled Microstrip Antenna for WLAN Application
... aperture coupled feed then both are simulated using the CST Microwave studio [9] for the operating frequency at ...aperture coupled) having a common ground plane working at the same resonant frequency and ...
5