• No results found

Direct Injection (DI)

An Energy Analysis on Gasification of Sewage Sludge by a Direct Injection in Supercritical Water

An Energy Analysis on Gasification of Sewage Sludge by a Direct Injection in Supercritical Water

... DOI: 10.4236/ajac.2017.812055 755 American Journal of Analytical Chemistry The main objective of this research is to investigate and to optimize the per- formance of a SCWG system that employs a Direct ...

21

Cfd Modeling of the In Cylinder Flow In Direct-Injection Diesel Engines

Cfd Modeling of the In Cylinder Flow In Direct-Injection Diesel Engines

... for direct injection diesel cylinder and a ...cylinder direct injection (di) diesel out using the code computational fluid dynamics (cfd) fluent 13 ...

9

Numerical Analysis of Effect of Injection Pressures on Emissions of Direct Injection Diesel Engine Fuelled with Diesel and Heptane

Numerical Analysis of Effect of Injection Pressures on Emissions of Direct Injection Diesel Engine Fuelled with Diesel and Heptane

... fuel injection systems have designed to obtain higher injection ...fuel injection pressure is low, fuel particle diameters will enlarge and ignition delay period during the combustion will ...When ...

8

An experimental investigation of the performance and gaseous exhaust emissions of a direct injection diesel engine using used cooking oil methyl ester (UCOME) and its blend with diethyl ether and conventional DIESEL oil

An experimental investigation of the performance and gaseous exhaust emissions of a direct injection diesel engine using used cooking oil methyl ester (UCOME) and its blend with diethyl ether and conventional DIESEL oil

... The performance and emission characteristic tests have been carried out on a single cylinder direct injection diesel engine running under constant speed and variable loads. In the first part, the engine ...

5

In-cylinder radiation heat transfer in a small direct injection diesel engine

In-cylinder radiation heat transfer in a small direct injection diesel engine

... a direct- injection diesel engine, measuring the radiation emissions at three ...temperature, injection timing, orientation of injection plumes) and the field of view of probe was ...

180

Spray characteristics of a multi-hole injector for direct-injection gasoline engines

Spray characteristics of a multi-hole injector for direct-injection gasoline engines

... spray-guided direct injection gasoline engines, have been characterised in terms of droplet velocities/diameters at injection pressures of 120 and 200bar and chamber pressures varying from ...

16

Fundamental study on combustion characteristics of direct injection 
		gaseous fuel

Fundamental study on combustion characteristics of direct injection gaseous fuel

... a direct injection engine used today is heat loss to the walls of the combustion ...use direct injection for various alternative fuels like methane, propane, hydrogen and compressed natural ...

5

Modeling of Combustion and Carbon Oxides Formation in Direct Injection Diesel Engine

Modeling of Combustion and Carbon Oxides Formation in Direct Injection Diesel Engine

... (CO), some different quantities of EGR, analysed and quantified numerically. Other parameters tha affect the rate of oxides of carbon in the bowl shape, the Mexican hat and spherical geometry are analyzed in this work. ...

9

Evaluation of Lean Operation Limit on Performance Features of Stratified Charge Gasoline Direct Injection (GDI) Engine

Evaluation of Lean Operation Limit on Performance Features of Stratified Charge Gasoline Direct Injection (GDI) Engine

... ratio, injection timing and mixture ...and injection timing of a gasoline direct injection engine to evaluate its influence on lean operating limit and performance features of the engine on ...

7

A MODERN APPROACH FOR MODELING THE COMBUSTION PROCESS IN DIRECT INJECTION DIESEL ENGINES

A MODERN APPROACH FOR MODELING THE COMBUSTION PROCESS IN DIRECT INJECTION DIESEL ENGINES

... Abstract : The article presents a modern approach for studying the combustion process in the DI Diesel engines developed for passenger car. The mixing controlled combustion model has been chosen for estimation the rate ...

5

Spray Characteristics of Dimethyl Ether in a Direct Injection Application

Spray Characteristics of Dimethyl Ether in a Direct Injection Application

... high-pressure injection, two parameters are commonly measured, ...high injection pressures is primarily affected by the fuel properties, especially the kinematic viscosity and the surface tension ...

86

A study of transient over fuelling during heavy knock in an optical spark ignition engine

A study of transient over fuelling during heavy knock in an optical spark ignition engine

... of injection timings for the transient DI ...fuel injection pulse width and DI rail pressure remained fixed at 7ms and 65bar ...optimum direct injection timing was considered to be ...the ...

29

Experimental Investigation on the Effect of Air Swirl on Performance and Emissions Characteristics of a Diesel Engine Fueled with Karanja Biodiesel

Experimental Investigation on the Effect of Air Swirl on Performance and Emissions Characteristics of a Diesel Engine Fueled with Karanja Biodiesel

... in direct--injection diesel engines, it is necessary to achieve a good spatial distribution of the injected fuel throughout the entire space ...fuel injection and gas flows is the most crucial factor ...

6

Port Injection of Hydrogen Gas in Direct Injection Diesel Engine using DEE as Ignition Enhancer

Port Injection of Hydrogen Gas in Direct Injection Diesel Engine using DEE as Ignition Enhancer

... The hydrocarbon variation with load is shown in Figure 8. The HC is found to increase several fold in DEE operated engine compared to that of dual fuel operation of hydrogen. At 25 % load the maximum HC of 2.01 g/kWh is ...

6

The behaviour of a gaseous transient jet in a direct injection turbulence chamber.

The behaviour of a gaseous transient jet in a direct injection turbulence chamber.

... This idealized flow situation may not be directly found in real devices, but many flow situations may be close to it. For example, in compression ignition engines fuelled with gaseous fuel, the macro-scale motions decay ...

328

Direct Fuel Injection of LPG in Small Two-Stroke Engines

Direct Fuel Injection of LPG in Small Two-Stroke Engines

... and direct fuel injection ...that direct fuel injection is a well developed and readily deployable solution to existing two-stroke ...project, direct injection (DI) of Liquefied ...

7

In-cylinder radiation heat transfer in a small direct injection diesel engine

In-cylinder radiation heat transfer in a small direct injection diesel engine

... 6.7 Illustration of method used to deduce effective soot layer thick- ness for period 1, condition 3. Heat flux produced with 17 µm soot layer thickness matches the heat flux during cold motored at compression process ...

25

Spray structure from double fuel injection in multihole injectors for gasoline direct-injection engines

Spray structure from double fuel injection in multihole injectors for gasoline direct-injection engines

... two injection events (marked region), droplet sizes are similar or even larger than those measured during the main ...the injection holes after the needle has closed; these liquid ligaments are produced ...

17

A REVIEW ON LASER INDUCED IGNITION OF GASOLINE DIRECT INJECTION ENGINES

A REVIEW ON LASER INDUCED IGNITION OF GASOLINE DIRECT INJECTION ENGINES

...  The ussability of a laser-induced ignition system on direct injected gasolineengine has been working. Main advantages are the almost free choice of theignitionlocation within the combustion chamber, even inside ...

7

COMPUTATIONAL STUDIES OF SWIRL RATIO AND INJECTION TIMING ON ATOMIZATION IN A DIRECT INJECTION DIESEL ENGINE

COMPUTATIONAL STUDIES OF SWIRL RATIO AND INJECTION TIMING ON ATOMIZATION IN A DIRECT INJECTION DIESEL ENGINE

... in injection timing, the droplet undergoes break-up to a greater extent and hence overall mass of the droplet can be lowered as compared to the other injection timings ...an injection timing of 20 ...

9

Show all 10000 documents...

Related subjects