• No results found

Extrinsic Fabry-Perot Interferometer based Sensors

Graded-index fiber collimator enhanced extrinsic Fabry-Perot interferometer

Graded-index fiber collimator enhanced extrinsic Fabry-Perot interferometer

... 1.3. GIF EFPI SENSORS FOR LARGE STRAIN MEASUREMENT. SMF EFPI sensor has a fringe visibility decreasing rapidly as its cavity length increases due to the divergence (typically about 8°) of the exit beam from the ...

57

Optical gas sensors based on correlation spectroscopy using a Fabry Perot interferometer

Optical gas sensors based on correlation spectroscopy using a Fabry Perot interferometer

... is obtained simply by looking for the frequency at which the first sidelobe of has it maximum value as shown in section 3.4.3.1. The optimal value of the reflectivity can be obtained using the convolution method ...

227

A Fabry–Perot interferometer-based camera for two-dimensional mapping of SO 2distributions

A Fabry–Perot interferometer-based camera for two-dimensional mapping of SO 2distributions

... Three different imaging implementations were introduced. The first method is based on the whisk-broom imaging ap- proach using an OP FPI device. The second implementa- tion uses an optical system that ensures ...

11

Refractive index sensing setup based on a taper and an intrinsic micro Fabry-Perot interferometer

Refractive index sensing setup based on a taper and an intrinsic micro Fabry-Perot interferometer

... In this work a refractive index sensor setup based on a bicon- ically tapered fiber (BTF) concatenated to a fiber micro Fabry- Perot interferometer was demonstrated. Here, the reflected power ...

5

Intrinsic Fabry-Perot Sensors for Magnetic Field Detection

Intrinsic Fabry-Perot Sensors for Magnetic Field Detection

... intrinsic Fabry-Perot cavity comprised of two identical Bragg gratings, we could obtain a more accurate detector with the removal of photo-induced birefringence in the detection ...sensor based on an ...

5

Rayleigh Scattering Measurements Using a Tunable Liquid Crystal Fabry-Perot Interferometer

Rayleigh Scattering Measurements Using a Tunable Liquid Crystal Fabry-Perot Interferometer

... IV. Results Image data were acquired in the core of the jet flow at 1.5 jet diameters downstream of the nozzle exit. The jet was oriented relative to the optics in each scenario such that the Rayleigh diagnostic system ...

15

The synoptic variability of thermospheric and mesospheric winds observed using a Fabry-Perot interferometer

The synoptic variability of thermospheric and mesospheric winds observed using a Fabry-Perot interferometer

... Secondly, the Lloyd database was analysed using the nightly sum of K values (K aum) while the present database has been analysed in term s of the 3-hour K p values. The K p index refers to the planetary geomagnetic ...

283

Thermospheric wind variations observed by a Fabry–Perot interferometer at Tromsø, Norway, at substorm onsets

Thermospheric wind variations observed by a Fabry–Perot interferometer at Tromsø, Norway, at substorm onsets

... Based on the above results and assumption, we sug- gest that the Joule heating effect of auroral activities influenced the wind field only for the northward wind component of the R1 event because that is the only ...

13

An analytical method to find the optimal parameters for gas detectors based on correlation spectroscopy using a Fabry Perot interferometer

An analytical method to find the optimal parameters for gas detectors based on correlation spectroscopy using a Fabry Perot interferometer

... absorption based gas detector use a Fabry-Perot Interferometer (FPI) to modulate the incident ...method based on the Fourier Transform that describes the performance of these ...

9

Analytical method to find the optimal parameters for gas detectors based on correlation spectroscopy using a Fabry Perot interferometer

Analytical method to find the optimal parameters for gas detectors based on correlation spectroscopy using a Fabry Perot interferometer

... It is shown that relatively low reflectivity values are a good choice for these sensors relaxing the design of the system since FPI mirrors with high are generally very expensive. Furthermore it is shown that if ...

29

A High Speed Demodulation Technology of Fiber Optic Extrinsic Fabry Perot Interferometric Sensor Based on Coarse Spectrum

A High Speed Demodulation Technology of Fiber Optic Extrinsic Fabry Perot Interferometric Sensor Based on Coarse Spectrum

... Sensor. Sensors 2021, 21, ...Fiber‐optic, extrinsic FabryPerot interfero‐ metric dual‐cavity sensor interrogated by a dual‐segment, low‐coherence Fizeau interferometer for simultaneous ...

13

High time resolution measurements of the thermosphere from Fabry-Perot Interferometer measurements of atomic oxygen

High time resolution measurements of the thermosphere from Fabry-Perot Interferometer measurements of atomic oxygen

... 1 Introduction Studying the small-scale structure of the thermosphere is im- portant both to better understand the processes, such as the energetics and dynamics of the atmosphere, and to improve models of the atmosphere ...

10

ANGEO - Fabry-Perot interferometer measurements of neutral winds and F2 layer variations at the magnetic equator

ANGEO - Fabry-Perot interferometer measurements of neutral winds and F2 layer variations at the magnetic equator

... Two di€erent schemes have been proposed to explain the main driving forces of mesoscale equatorial F2 layer variations during the night. 1. The most consistent experimental models compare the Jicamarca incoherent scatter ...

7

Midlatitude thermospheric wind and temperature: networked Fabry-Perot interferometer observations and radiative transfer modeling

Midlatitude thermospheric wind and temperature: networked Fabry-Perot interferometer observations and radiative transfer modeling

... The laser calibration signal is orders of magnitude brighter than the airglow signal, so we may therefore treat p instr as having negligible uncertainty in the airglow inversion even though it is an estimated quantity. ...

174

A comparison of thermospheric winds and temperatures from Fabry Perot Interferometer and EISCAT Radar measurements with models

A comparison of thermospheric winds and temperatures from Fabry Perot Interferometer and EISCAT Radar measurements with models

... geophysical conditions, extending from 100 km altitude upwards. CTIP-200 (Fuller-Rowell and Rees, 1980; Millward et al., 1996) is a global, 3-dimensional, time-dependant numerical model which simulates the dynamical ...

6

Low-Cost Fiber-Tip Fabry-Perot Interferometer and its Application for Transverse Load Sensing

Low-Cost Fiber-Tip Fabry-Perot Interferometer and its Application for Transverse Load Sensing

... In this paper, we propose a novel FPI manufacturing method. The manufacturing process can be divided into two steps: firstly, a chemical etching method was used to make a groove in the tip of a multimode fiber (MMF). ...

6

Design, Simulation, Fabrication, and Characterization of MEMS-based, Tunable FABRY-PEROT Interferometer Filter in the Long Wavelength Infrared Region

Design, Simulation, Fabrication, and Characterization of MEMS-based, Tunable FABRY-PEROT Interferometer Filter in the Long Wavelength Infrared Region

... tunable Fabry-Perot interferometer filter (FPI), that is proposed to be a monochromator with a broadband IR detector array in an improvised explosive device detection system, is designed, simulated, ...

162

A Theoretical Study and Numerical Simulation of a Quasi-Distributed Sensor Based on the Low-Finesse Fabry-Perot Interferometer: Frequency-Division Multiplexing

A Theoretical Study and Numerical Simulation of a Quasi-Distributed Sensor Based on the Low-Finesse Fabry-Perot Interferometer: Frequency-Division Multiplexing

... The quasi-distributed optical fibre sensor based on the low-finesse Fabry-Perot interferometer, 288. was studied theoretically and simulated numerically[r] ...

13

Low coherence fibre optic Fabry-Perot sensors suitable for multiplexed strain measurement

Low coherence fibre optic Fabry-Perot sensors suitable for multiplexed strain measurement

... A single receiver interferometer at the output selectively reconstracts the interference associated with individual sensors when its optical path difference is timed to match that of ea[r] ...

247

ANGEO - Ion-neutral coupling in the high-latitude F-layer from incoherent scatter and Fabry-Perot interferometer measurements

ANGEO - Ion-neutral coupling in the high-latitude F-layer from incoherent scatter and Fabry-Perot interferometer measurements

... Abstract. Since the auroral ionosphere provides an important energy sink for the magnetosphere, iono- sphere-thermosphere coupling must be investigated when considering the energy budget of the ionosphere- magnetosphere ...

9

Show all 10000 documents...

Related subjects