Fe-Al
Synthesis and Faraday Effect of Fe Al Oxide Composite Ferrofluid
... rotation has a non-linear dependence on magnetic field in normal temperature region [13]. In this experiments, the charts in Figure 1 interpret that Faraday rotation has a approximate linear dependence on magnetic field ...
6
Adsorption Desorption of BTX (Benzene, Toluene and O xylene) on Fe, Fe Al Pillared Clay
... The studies are conducted in laboratory to determine the adsorption-desorp- tion behavior of BTX (benzene, toluene and o-xylene) in gas phase on Fe, Fe-Al pillared clays adsorbents. In experimental ...
27
Fabrication of Fe Al nanoparticles by selective oxidation of Fe Al thin films
... 200-nm Fe-Al films changed from the continuous to the discontinuous type; thus, particulate Fe-Al films formed after 100 ...100-nm Fe-Al films showed super-paramagnetic behavior ...
6
Tetragonal magnetostriction and magnetoelastic coupling in Fe Al, Fe Ga, Fe Ge, Fe Si, Fe Ga Al, and Fe Ga Ge alloys
... the Fe-Al-Ga alloy, it is possible to show how the double peak magnetostriction feature of the binary Fe-Ga alloy flows into the single peak binary Fe-Al ...the Fe-Ga, ...
15
Theoretical Predict of Half Metals in Co Cr Fe Al Alloys
... per unit cell (n). When the value of n is an integer, we can judge an alloy is a half-metal. We use the symbol ‘n’ as the decimal fraction of the number of down-spin electrons. The lattice constant (a) dependence of W ...
5
Corrosion Performance of Fe-Al Intermetallic Coatings in 1.0 M NaOH Solution
... both Fe and Al have protective properties and that the electrochemical behavior of pure Fe and Fe28Al have the same performance ...of Fe and Al (Fe(OH) 2 , Al(OH) 3 ) ...
14
Corrosion study of Fe-Al Intermetallic Alloys in Simulated Acid Rain
... This paper presents an investigation on the corrosion resistance of iron aluminides FeAl-based alloys, in an environment that simulates acid rain water in temperature room. Potentiodynamic Polarization, Linear ...
14
The Synthesis and Characterization of Arc Melted Fe1 xAlx Alloys
... During the last decade, enormous progress has been made in manufacturing and processing of materials with intermetallic matrices [1]. Mechanical alloying (MA) [2], which was initially conceived for the production of dis- ...
5
Temperature dependence of the magnetostriction and magnetoelastic coupling in Fe100−xAlx (x = 14.1,16.6,21.5,26.3) and Fe50Co50
... lated for the Fe–Al alloys. Between 77 K and room tempera- ture, only small temperature dependences were found in the c ⬘ elastic constants, the elastic constants decreasing ⬃6% for the 14.1% alloy and ⬃12% ...
6
Decolourization of Textile Dyebath Chloride Rich Wastewater by Electrolytic Processes
... (Fe, Al, Steel, Graphite, Platinum etc) and there combinations [12-15] are generally used to treat various wastewaters in recent studies- Galvanic rinsing wastewater [16], Beer brewery wastewater [17], ...
13
Nano mechanical properties of Fe Mn Al C lightweight steels
... were studied. The Ni-containing samples were found to have a higher hardness due to the B2 phase composition being NiAl rather than FeAl, with Ni-Al bonds reported to be stronger than the Fe-Al ...
13
1 Co-, Cu- and Fe-Doped Ni/Al 2O3 Catalysts for the
... Ni/Al 96.70 0.13 0.03 0.00 0.30 2.84 90 16 26.14 0.3407 5.6 Ni-Co/Al 95.84 0.14 0.00 0.00 1.04 2.98 96 19 26.19 0.3400 5.5 Ni-Cu/Al 97.80 0.22 0.07 0.00 0.39 1.52 130 39 26.29 0.3387 6.5 ...
15
Molecular changes of ferric oxide bound soil humus during the decomposition of maize straw
... was considered as one of the typical hydrophilic natural organic matters except polysaccharides and other mono- meric biopolymer such as amino sugars [43]. The recal- citrance of proteins in humic substances was achieved ...
7
Effect of carbon addition on the single crystalline magnetostriction of Fe X (X = Al and Ga) alloys
... of Fe–Al alloys 14 shows similar compositional dependence to Fe–Ga alloys; it increases with Al content in the A2 phase region, reaching a maximum at around 20 ...% Al 共 near the phase ...
9
Hardenability and Corroson Resistance of as Cast Fe-9Al-0,6C Alloy
... considerations, Fe-Al-C alloy could be a good candidate for replacing some of the conventional stainless ...Wherein, Al is used to replace the expensive alloy element in conventional Fe-Cr-C ...
8
Morphology of Compounds Formed by Isothermal Reactive Diffusion between Solid Fe and Liquid Al
... along the test line with the length L parallel to the initial Fe/ Al interface, and N is the number of the tongues intersected by the test line. The results of T ¼ 973, 1023 and 1073 K are shown as open ...
9
Corrosion Study of Al-Fe (20 wt%) Alloy in Seawater Alkaline Solutions
... For pH 10 and 12 there is a semi-passive behaviour attributed to the formation of corrosion products trapped between Fe-Al phases; retarding the ion transfer mechanism at the alloy interface as a resistive ...
11
Modeling and Optimization of Electrocoagulation Process for the Removal of Yellow145 dye Based on Central Composite Design
... of Al and Fe were ...of Fe electrodes, while others pointed out to the advantages of using Al ...that Fe is relatively cheaper [31]. Fe forms more denser flocks of coagulated ...
12
Application of the Wilson Equation for Zn Al Fe Alloy in Vacuum Distillation
... The Zn-Al-Fe alloy sample used for the experiments was obtained from a factory in China. The material and sample information are summarized in Table 3. The experiment was performed in the vacuum furnace in ...
7
Effect of Mn or Fe Addition on Age Hardening Behaviour of Al Mg2Si Alloys
... calculated activation energy of 52.364.5 kJ/mol for this process of AlMgSi alloy. Therefore, our value for the activation energy of the clustering process is within the most acceptable values found in the literature. ...
8