liquid-solid interface
Investigating the Co Adsorption Behavior of Nucleic Acid Base (Thymine and Cytosine) and Melamine at Liquid/Solid Interface
... melamine possesses homogeneous holes with uniform diameter, this porous network might act as host template to capture some appropriate guest molecule or ions. However, the final products of host-guest reaction are mainly ...
8
Molecular Self-Assembly of Substituted Terephthalic Acids at the Liquid/Solid Interface: Investigating the Effect of Solvent
... the liquid-solid interface and molecules in ...HOPG/PO interface, the adsorbed and solvated systems were very close in energy, suggesting an equilibrium between molecular adsorption and ...
14
Thermodynamics of halogen bonded monolayer self-assembly at the liquid-solid interface
... Scanning Tunneling Microscopy (STM) experiments were conducted with a home-built low- drift instrument operated with a commercial ASC500 control electronics (attocube Systems AG, Munich). Highly Oriented Pyrolytic ...
12
Self assembled monolayers of oligophenylenecarboxylic acids on silver formed at the liquid solid interface
... (a) Large scale image with differently orientated domains of the α-phase indicated by dotted lines. (b) Image showing co- existence of α and β phases. Phase boundaries are marked by dashed lines. Arrows highlight rows of ...
18
Self assembly of 1,3,5 benzenetribenzoic acid on Ag and Cu at the liquid/solid interface
... Firstly, the preference of a monopodal over a bipodal configuration for H3BTC 62 on UPD-Ag suggests that intermolecular interactions prevail over molecule-substrate interactions. Secondly, there is a noticeable ...
11
Self-assembly of 1,3,5-benzenetribenzoic acid on Ag and Cu at the liquid/solid interface
... Firstly, the preference of a monopodal over a bipodal configuration for H3BTC 62 on UPD-Ag suggests that intermolecular interactions prevail over molecule-substrate interactions. Secondly, there is a noticeable ...
11
Sequential nested assembly at the liquid/solid interface
... The star molecules were adsorbed either from 1,2,4- trichlorobenzene (TCB) or DMF by immersion of the network modified substrate at 60°C. During the adsorption time of about two minutes the solution was cooling down. ...
10
Molecular self assembly of substituted terephthalic acids at the liquid/solid interface : investigating the effect of solvent
... the liquid/solid interfaces (graphite/heptanoic acid and graphite/1-phenyloctane) was studied using a combination of STM measurements and molecular mechanics and molecular dynamics ...
14
Analytic Diffraction Corrections to Ultrasonic Scattering Measurements
... Considering an immersion configuration in which the transducer radiates into a fluid and the beam then passes through a liquid-solid interface and propagates on to the flaw, a function C[r] ...
20
Numerical Analysis of Latent Heat Storage with an Internal Fin using Flexpde
... (e) Using extended surfaces such as fins and honeycombs. Lamberg et al. [6] introduced a simplified analytical model based on a quasi-linear, transient, thin fin equation which predicts the temperature distribution in ...
7
Thermally Stable Conditions during Capillary Shaping of Bent Components
... The solid-liquid interface was located 3 mm above the melt surface, which agreed with the formation of the melt column above the melt surface sustained by the surface tension or the oxide ...The ...
6
Preparation and characterization of carbon nanofluid by a plasma arc nanoparticles synthesis system
... fluid internal shear stresses that results to the observed nanofluid viscosity. Adding more nanoparticles would produce a similar effect. Figure 9 shows the change in viscosity ratio for carbon/water nanofluids compared ...
11
Simulation of the Dendritic Growth Velocity for Binary Alloy Al-Cu in the Undercooled System
... of solid fraction with solidification time, in this simulation, the sol- id fraction is given by the ratio of the solid control volume to the total volume control of the com- putational ...thin solid ...
9
Effects of Cu Addition on Microstructure Characteristics and Tensile Behaviors of Metal Inert Gas Arc Welded Mg Steel Dissimilar Joints
... and without Cu interlayer are evaluated. Figure 7 shows that the welding speed has a significant effect on the tensile strength of Mg-steel joints. With the welding speed increasing from 550 to 700 mm/min, the average ...
7
The Effects of an Applied Voltage on the Corrosion Characteristics of Dense MgO
... basic liquid oxides are ionic in nature [9] and to all intents and purposes can be considered as a molten ...Acidic liquid oxides are more covalent [9] and may not be easily represented as molten ...to ...
6
Biosorptive Removal of Zinc from Aqueous Solution by Algerian Calotropis procera Roots
... In these equations, Ce is the concentration of ZnII in solution mg/L at equilibrium, qe is the amount of the adsorbed metal ions mg/g at the solid/liquid interface, qmax is the monolayer[r] ...
9
← Return to Article Details MAGNETIC SOLID PHASE EXTRACTION APPLICATIONS COMBINED WITH ANALYTICAL METHODS FOR DETERMINATION OF DRUGS IN DIFFERENT MATRICES REVIEW
... Today, food production processes are becoming global and it is becoming difficult to control food safety and quality. For this reason, national and international regulatory committees identify and supervise relevant ...
11
Effect of Liquid-Solid Contact on Thermal Cracking of Heavy Hydrocarbons in a Mechanically Fluidized Reactor
... the liquid-solid contact in the conventional fluidized bed (House 2008, Knapper, Gray et ...the liquid-solid contact. There is a need to study the liquid-solid contact as a whole ...
70
Novel Analysis Method for the Solid liquid Interface Using Surface Enhanced Raman Spectroscopy
... 1. Figure 2 (Solid line (a)) shows the Raman spectrum of N2H4, which has six pronounced, polarized lines at 469, 818/924, 1132, 1303/1366, 1633 (overlapping Raman band), and 3293 (3213, 3356) cm-1. We assign these ...
8
Filament and Droplets Formed Behind a Solid Sphere Rising Across a Liquid Liquid Interface
... a solid sphere and deformation of the interface were observed with a high-speed video camera at 500 frames per second and the images were stored on a personal ...
7