• No results found

on-line fault detection method

On-line fault detection method for induction machines based on signal convolution

On-line fault detection method for induction machines based on signal convolution

... highlight fault characteristics in the spectrum, and to discriminate in case of mixed faults ...rotor fault characteristic frequencies close to the stator supply frequency, which makes fault ...

14

Aircraft Cable Fault Detection and Location Based on SSTDR

Aircraft Cable Fault Detection and Location Based on SSTDR

... the fault delay time, from which the fault distance can be ...TDR method is that the SSTDR method emits a pseudo-random sequence modulated by BPSK, and the TDR method emits a single ...

7

Self-Regulating Line Fault Detection & Its Location In Transmission Lines

Self-Regulating Line Fault Detection & Its Location In Transmission Lines

... adapted method was proposed in order to determine the robustness of wireless optical communication system taking into account the presence of any obstacles in the specified work volume ...

7

On-line fault detection in fermentation development facilities

On-line fault detection in fermentation development facilities

... This method was developed and used by Stephanopoulos and San (1984) and San and Stephanopoulos (1984), and subsequent examples of its use have been reported by Shioya et a l (1986), Nâhlik and Burianec (1988), and ...

256

WAVELET TRANSFORM BASED FAULT DETECTION AND CLASSIFICATION IN TRANSMISSION LINE

WAVELET TRANSFORM BASED FAULT DETECTION AND CLASSIFICATION IN TRANSMISSION LINE

... based Fault detection and classification technique has been ...This method identifies all ten types of faults ...transmission line. Fault data is generated using EMTDC/PSCAD [9] ...

8

IOT Based Fault Detection and Automation In Electricity Board

IOT Based Fault Detection and Automation In Electricity Board

... robust fault detection and discrimination technique for transmission lines which computes accurate fault using robust method by values obtained from samples ...the line to estimate ...

8

Automated fault detection using deep belief networks for the quality inspection of electromotors

Automated fault detection using deep belief networks for the quality inspection of electromotors

... production line, we propose a novel automated fault detection method named “ Tilear ”, based on Deep Belief Networks (DBNs) training only with good electromotor ...

10

Three Phase Line Fault Detection using Artificial Neural Network

Three Phase Line Fault Detection using Artificial Neural Network

... alternative method for the detection of faults on power transmission ...single line-ground, line-line, double line- ground and three phase faults have been taken into ...

7

Fault Detection of Electric Power Transmission Line by Using Neural Network

Fault Detection of Electric Power Transmission Line by Using Neural Network

... steepest-decent method. The steepest-decent method is an extension to the Laplace‟s method of integral approximation where the contour integral in a complex plane is deformed to approach a stationary ...

9

Detection and Classification of Double Line to Ground Faults in a 138 kV Six Phase Transmission Line Using Hilbert Huang Transform

Detection and Classification of Double Line to Ground Faults in a 138 kV Six Phase Transmission Line Using Hilbert Huang Transform

... transmission line against a variety of double line to ground faults using Hilbert Huang ...proposed method well detects and classifies the double line to ground faults and the reliability of ...

16

A Novel Fault Detection and Fault Location Method for VSC-HVDC Links Based on Gap Frequency Spectrum Analysis

A Novel Fault Detection and Fault Location Method for VSC-HVDC Links Based on Gap Frequency Spectrum Analysis

... gap-based fault location method for VSC-HVDC transmission line using the fault current ...This method is able to locate the fault by analyzing the single-end fault ...

7

Line outage detection using phasor angle measurement

Line outage detection using phasor angle measurement

... a fault on the line causing the power outage, a quick means of detecting the exact location is needed to facilitate a quick response to restore the power back to the ...of line outage ...

70

LIGHTNING DETECTION IMPROVEMENT FALLS BROUGHT TO ESKOM S TRANSMISSION LINE DESIGN AND FAULT ANALYSIS

LIGHTNING DETECTION IMPROVEMENT FALLS BROUGHT TO ESKOM S TRANSMISSION LINE DESIGN AND FAULT ANALYSIS

... Lightning contributes around 24% to Eskom Transmission’s total transmission line faults. Measures have been taken over the past decades to combat this effect of lightning on the performance of high voltage ...

6

Global Fault-Tolerant Control of Underactuated Aerial Vehicles with Redundant Actuators

Global Fault-Tolerant Control of Underactuated Aerial Vehicles with Redundant Actuators

... active fault-tolerant control is based on estimator or parameter ...the fault detection and isolation scheme can be ...passive fault-tolerant control mechanisms are actually adaptive control ...

14

Feature Extraction and Diagnosis System Using Virtual Instrument Based on CI

Feature Extraction and Diagnosis System Using Virtual Instrument Based on CI

... a fault diagnosis system based on virtual instrument, which was successfully ap- plied to SDF-9 generator ...a fault diagnostic system, which solved the problems of state prediction and trou- ble-mode ...

9

Method & Implementation of Fault Detection & Prevention Attack in WSN

Method & Implementation of Fault Detection & Prevention Attack in WSN

... This work provides the concept of blackhole attack in WSN that can affect the performance of system by generating faulty nodes. These nodes affect the energy level of nodes as well as the network lifetime. Due to this, ...

7

Modeling and Simulation of Overcurrent and Earth Fault Relay for Extra High Voltage Transmission Line

Modeling and Simulation of Overcurrent and Earth Fault Relay for Extra High Voltage Transmission Line

... major fault in transmission line is single line to ground (L-G) fault, but, various types of faults also occur in transmission line, such as unsymmetrical faults which includes single ...

7

Fault Location and Incipient Fault Detection in Distribution Cables

Fault Location and Incipient Fault Detection in Distribution Cables

... final fault distance is given as the average of eight calculations in one cycle, which will reduce, to certain extent, errors caused by the factors such as, phasor measurement erros and dynamic change of the ...

266

Abstract: The lane line detection is through the on-board camera to deal with the captured image, to extract the

Abstract: The lane line detection is through the on-board camera to deal with the captured image, to extract the

... lane line detection is through the on-board camera to deal with the captured image, to extract the lane line information from the ...lane line detection is often applied to the advanced ...

5

Transmission Line Fault Detection using BFONN

Transmission Line Fault Detection using BFONN

... new method to classify the types of faults and to determine the exact location of faults in transmission lines from the sender’s end has been ...This method uses famous optimisation techniques neural ...

8

Show all 10000 documents...

Related subjects