• No results found

thermal aging

Review of Accerlated Thermal Aging Models of Conditioning Assessment of Power Transformer Insulation

Review of Accerlated Thermal Aging Models of Conditioning Assessment of Power Transformer Insulation

... (a) Thermal aging chamber [5] (b) Test set up for thermal faults [32] Figure 1: Pictorial view of test models used to detect the influence of thermal stress on power transformer insulation ...

10

Investigation on Thermal Aging and Mechanical Properties of the Nano-SiO2/Epoxy Adhesive

Investigation on Thermal Aging and Mechanical Properties of the Nano-SiO2/Epoxy Adhesive

... Samples that before and after the thermal aging are shown in Fig.2. During the aging, the color of sample changes from light yellow into dark brown. The variation of color is obvious. Results of ...

5

Microstructure Characterization of Oxide Dispersion Strengthened Steels Containing Metallic Chromium Inclusions after High Temperature Thermal Aging

Microstructure Characterization of Oxide Dispersion Strengthened Steels Containing Metallic Chromium Inclusions after High Temperature Thermal Aging

... Figure 4 and Table 3 show the BSE images and EDX analysis results of CR-NT before and after the thermal aging. EDX analysis data of spot 2 indicated that a high Cr concentration area was formed near the ...

9

Effect of thermal aging on fracture toughness of austenitic stainless steel welds

Effect of thermal aging on fracture toughness of austenitic stainless steel welds

... In this study, fracture toughness test was conducted in order to evaluate the effect of thermal aging on the fracture behavior of shielded metal arc (SMA) weld and gas tungsten arc (GTA) weld of Type 316L ...

10

Study of Accelerated Thermal Aging Effects on Nomex Mylar Nomex and Dacron Mylar Nomex Insulating Paper

Study of Accelerated Thermal Aging Effects on Nomex Mylar Nomex and Dacron Mylar Nomex Insulating Paper

... of thermal stress on cellulose insulation systems of rotating machines, insulation is wrapped on copper conductor were placed in borosil ...for thermal aging of insulation to study its behaviour with ...

8

The Sn-3.5Ag-1.0Cu-0.1Zn/Cu Intermetallic Interface under Thermal Aging

The Sn-3.5Ag-1.0Cu-0.1Zn/Cu Intermetallic Interface under Thermal Aging

... action. However, during storage and field service, the growth of IMCs will influence the strength of solder joints and result in mechanical failure of the joints. Therefore, the formation and growth of IMCs during ...

7

Study Of Mechanical And Thermal Properties Of HDPE In Response To Accelerated Thermal Aging

Study Of Mechanical And Thermal Properties Of HDPE In Response To Accelerated Thermal Aging

... of thermal aging is widely use to speed up the aging ...dry thermal treatment at the early twentieth ...performing aging process, properties like mechanical can be enhance moderately ...

24

Solder joint strength on copper substrate under thermal aging condition

Solder joint strength on copper substrate under thermal aging condition

... On the other hand, the fracture surface of the Sn- 25Ag-10Sb solder joint contains less significant void formation when compared to the Pb-2.5Ag-2Sn specimen. The void formation of the Sn-25Ag-10Sb solder joint (shown in ...

5

Effect Of Different Concentration Of Carbon Nanotube (CNT) In SAC305 Solder Alloy On The Hardness, Wettabilitty And Resistivity Under Thermal Aging

Effect Of Different Concentration Of Carbon Nanotube (CNT) In SAC305 Solder Alloy On The Hardness, Wettabilitty And Resistivity Under Thermal Aging

... In this chapter the past review of the wetting characteristic of the Solder paste of the carbon nanotube (CNT) that are mixed together with 96.5Sn-3.0Ag-0.5Cu (SAC305) is studied where the type of CNT used is the ...

24

Microstructure and Mechanical Properties of JLF-1 and CLAM Steels Exposed to Thermal Aging with Stress

Microstructure and Mechanical Properties of JLF-1 and CLAM Steels Exposed to Thermal Aging with Stress

... CLAM shows a higher hardness and tensile strength than JLF-1. This is because of finer prior austenitic grain size for CLAM (5-10 mm) than for JLF-1 (8-15 mm), and smaller lath width for CLAM (440 nm) than for JLF-1 (500 ...

5

High temperature electrical and thermal aging performance and application considerations for SiC power DMOSFETs

High temperature electrical and thermal aging performance and application considerations for SiC power DMOSFETs

... exponentially. Thermal aging tests demonstrated a sudden change from linear to non- linear output characteristics after 24 to 100 hours air storage at 300 °C and after 570 to 1000 hours in N2 ...

14

The measurement of very low conductivity and dielectric loss in XLPE cables: A possible method to detect degradation due to thermal aging

The measurement of very low conductivity and dielectric loss in XLPE cables: A possible method to detect degradation due to thermal aging

... S.J.Dodd was born in Harlow, Essex in 1960. He received the B.Sc. (Hons) Physics degree in 1987 and the Ph.D. degree in physics in 1992, both from London Guildhall University, UK and remained at the University until 2002 ...

11

Aging Effect on Characteristics of Oil Impregnated Insulation Paper for Power Transformers

Aging Effect on Characteristics of Oil Impregnated Insulation Paper for Power Transformers

... Figures 15 and 16 show the effect of thermal aging on tensile strength of oil impregnated papers. It is clear that the increase in temperature caused a decrease in the ten- sile strength for all samples. ...

7

Tensile and Toughness Properties Of Materials tor the In-Service Inspection and Flaw Evaluation RSE-M Code

Tensile and Toughness Properties Of Materials tor the In-Service Inspection and Flaw Evaluation RSE-M Code

... of aging and to improve the statistical analysis of the databases from experimental fracture mechanics programs on austenitic stainless steel piping and carbon-manganese ferritic steel piping and associated ...of ...

11

Lifetime   Evaluation and Management for Class 1 Piping of Korean Lead Plant

Lifetime Evaluation and Management for Class 1 Piping of Korean Lead Plant

... If detailed LBB backfit project for the lead plant is performed, the results connected to the thermal aging issue can be incorporated for the continued operation of Class[r] ...

8

Study of stability of brown-gray inks on paper support

Study of stability of brown-gray inks on paper support

... The objective of this research was to study the stability of three types of historical brownish gray inks, i.e. bistre, sepia, and iron gall ink on the paper substrate during ac- celerated thermal aging in ...

7

Reaction Diffusion and Formation of Cu11In9 and In27Ni10 Phases in the Couple of Indium Substrates

Reaction Diffusion and Formation of Cu11In9 and In27Ni10 Phases in the Couple of Indium Substrates

... Intermetallic compound layer growth between pure indium solder and Au deposited (Ni and Cu) substrates was examined as a consequence of solid state thermal aging. The aging temperatureswere 343, 373, ...

6

Testing the Mutation Accumulation Theory of Aging Using Bioinformatic Tools

Testing the Mutation Accumulation Theory of Aging Using Bioinformatic Tools

... in Aging Research For beta-Amyloid Precursor Protein, the same number of mutations was produced randomly and similar bioinformatic runs were done to all mutated ...the aging phenotype; lowering the ...

12

Investigating the Influence of Precipitation Hardening and Characterization of Aluminium Alloy Composite Material

Investigating the Influence of Precipitation Hardening and Characterization of Aluminium Alloy Composite Material

... Composite materials are new generation materials to meet the demands of rapid growth of technological changes of the industry. Composites are engineering materials made from two or more constituents’ materials. One ...

5

Effect of Heat Aging on Thermal and Mechanical Properties of Ti Ni Nb Shape Memory Alloy

Effect of Heat Aging on Thermal and Mechanical Properties of Ti Ni Nb Shape Memory Alloy

... the thermal and mechanical properties of the joint ring material exposed to high-temperature water for a long term, and clarified the effect of the aging time on the function property of the joint ring ...

6

Show all 10000 documents...

Related subjects