[PDF] Top 20 OPTICAL PROPERTIES OF THIN Cu FILMS AS A FUNCTION OF SUBSTRATE TEMPERATURE

... the substrate holder system was ...six films can be produced at 6 different substrate temperatures, under the same evaporation condition, in one evaporation ... See full document

... ZnO thin films as a function of substrate ...optimum substrate temperature for the deposition of crystallized ZnO thin films is ...this temperature, atoms ... See full document

... lower substrate temperatures are almost similar and are closer to both Johnson and Christy’s and bulk sample’s [18,20] results (except for ( 120nm, 600 K) ...different substrate temperatures and thicknesses ... See full document

... a function of substrate temperature and are given in Table ...increasing substrate temperature but the grain size extrapolating from the AFM measurmaents ... See full document

... CZTS thin films have been grown on clean preheated glass at different substrate temperatures of (200, 250, 300, 350, 400 and 450) o ...and optical properties of these films have ... See full document

... in substrate temperature which means that the real dielectric constant increase with increasing of substrate ...of thin film lead to rearrange the localized state causing an dеcrеasе in ... See full document

... the optical properties of MPcs thin layers were intensively investigated since they are classified as small organic molecules and many factors such as the interaction with the substrate type, ... See full document

... (CdSe) thin films of thickness 1320 Å were thermally evaporated technique deposited on glass substrate at room ...as-deposited films were annealed in air atmosphere at 100 o C, for three ... See full document

... of substrate temperature on optical and electrical properties was studied ...successfully. Optical studies shows that films are highly absorptive in nature having high absorption ... See full document

... the optical properties of MoGe layers as a function of film ...Si substrate, without native oxide, and a MoGe film of varying ...the optical properties of the MoGe layer are ... See full document

... a function of wavelength. It is observed that for undoped films , there is one well defined maximum, and it decreases with the increase of annealing ...doped films the refractive index firstly ... See full document

... results revealed that the electrical conductivity is increased with increasing the annealing temperatures and /or annealing time, while optical energy gap is decreased. On the other hand it was found that the ... See full document

... interesting optical properties in the carbon-based films by ability to tuning wide optical band gap of ...physical properties depending on the deposition ...different optical ... See full document

... room temperature. Figure 5 shows the variation of optical transmittance with wave- ...The optical study shows that the films are absorp- ...of films. The optical band gaps of the ... See full document

... and optical properties of ZnO thin film deposited on glass substrate at a substrate temperature equal to 450 o C by spray pyrolysis technique have been ...the films have ... See full document

... plane. Films with indium excess have poor crystallinity while Copper-rich films exhibit good ...the films are homogenous, smooth and adherent to the ...Copper-rich films had well developed ... See full document

... silicon substrate is illustrated in Figure (2); the figur reveals a polycrystalline structure of the ...all films are preferentially orientated along (111) crystallographic directions and the preferential ... See full document

... ZnO thin films have been deposited on glass substrate by Ultrasonic spray at different substrate temperatures between 300 and 400 ...The optical, electrical and structural ... See full document

... and properties of the spray deposited film highly depends on the various process parameters such as spray rate, substrate temperature, nozzle to substrate distance, quantity of spray solution, ... See full document

... wet films were dried at 150°C in air for 20 ...at temperature range of 300-450°C in ambient air for 1 ...the substrate into the film, the annealing process was not performed at temperature ... See full document